Curtis RLDED3950A-C User Manual
RLDED3950A-C
39
TV PLACEMENT SETUP
Initial Setup
3.1. Initial Installation
3.2. Audio/Video Source Selection
3.3. DTV Mode Operations
2
2
7
17
17
17
SETTINGS
4.1.Customizing the PICTUERE Settings
4.2.Customizing the Audio Settings
4.3.Customizing theTIME Settings
4.4.Customizing the SETUP Settings
4.5.Customizing the Patental Settings
4.6.Customizing the TV Settings
PC Mode
18
18
19
20
21
24
27
30
31
33
1.2． TV PLACEMENT SETUP
.
TV Stand Installation/Removal
Place the unit face down on a soft surface.
1.
Gently position the glass base to the leg at the bottom of the TV.
2.
Insert the column corresponding position with the threaded screw size M5 * 45 fixed.
3.
Fasten the 5 provided screws (screw size B4x18) to secure the stand to the TV according
4.
to the diagram.
Wall Mounting
1. Ensure that the selected wall is made of appropriate material and can support the
weight of the TV. Make sure there are no pipes or cables inside the wall on your
chosen position.
2. Obtain a suitable wall mounting bracket and mounting eyebolts (thread size M4x10)
and screws from your local hardware store.
3. Place the unit face down on a soft surface.
4. Remove the attached leg at the bottom of the TV by removing the 5 screws on the
leg cover.
5. Refit the cover securely by replacing the 5 screws into their original positions.
screw size M5 * 45
5
4
6
screw size B4x18
6. Fasten 4 eyebolts panel according to the
diagram.
7. Fasten the wall mounting bracket using screws onto the wall.
8. Connect the eyebolts and the wall bracket securely with strong rope
9. Carefully check that all fastenings are secure before releasing the TV.
200mm
100mm100mm
200mm
Thread hole size M4 x 10 depth (TV Mounting Screw Size) on the TV.
AUDIO
VIDEO
L
R
12
11
Pr
Pb
Y
10
1.POWER: Turns the LED TV on and into standby mode.
2.SOURCE: chooses from different input signal sources
3.MENU: press once to display the OSD(on screen display), press again
to turn the OSD off.
4/5.VOL-/+: Adjusts the volume upand down.Selects the main-menu item
and change values for items when in the OSD mode.
6/7.CH-/+: Scans up and down through channels. Selects sub-menu item
when in the OSD mode.
8.IR RECEIVER: Receives infrared signals from the remote control
9.INDICATOR LED: Status indicator (Power on: Green/Standby: Red)
HDMI1 HDMI2 VGA PC AUDIOCOAXIAL USB
(For Service)
1 2 3 4 5 6 7
1. Headphones
2. Coaxial: Digital audio output
3. USB Host port
4/5/9. HDMI
6. VGA: PC video input
7. PC AUDIO: Connect it to the
audio output terminal of PC
HDMI3
RF
8. RF: Antenna connection
10. YPbPr: Connect to the YPbPr
video output terminal of DVD
11. Video: Video input
12. AUDIO IN R/L: Stereo audio
input
9
8
Loading...