Curtis IP562UK User Manual

iMode

MODEL NO. IP562UK

MICRO SYSTEM DOCKING STATION FOR iPOD

INSTRUCTION MANUAL

MODE

CLK SET

PLEASE READ BEFORE OPERATING THIS EQUIPMENT

FM ST

POWER

IMPORTANT SAFETY INSTRUCTIONS

1

IMPORTANT SAFETY INSTRUCTIONS

Mains supply

This equipment is designed to operate from a 230 Volt, 50Hz AC mains supply. Other power sources may
damage it. Check that the rating label of the equipment states 230V AC before you plug it in for the first
time.

Mains plug

We have fitted this equipment with a standard mains plug.

If the supply cord is damaged it must be replaced by the manufacturer, its service agent or similarly
qualified person in order to avoid a hazard.

If you cut off the mains plug, for example to fit a different type, please destroy the old plug as it would
be dangerous if inserted into a live power outlet. Carefully follow the wiring instructions supplied with
the new plug.

If a fuse is fitted to the plug, remove the fuse before throwing the plug away.
Never use a fused mains plug without the fuse cover.

Mains plug wiring for the UK

In a moulded plug the wires in the mains lead of this apparatus must be connected as follows.
The wire-coloured brown must be connected to the terminal that is marked with the letter L.
The wire-coloured blue must be connected to the terminal that is marked with the letter N.
Do not connect anything to the earth terminal which is marked E, or .

BROWN

Live

BLUE

Neutral

E

Cord Clamp

FUSE

3 Amps

L

N

You must make sure the mains lead is a firmly secured under the cord clamp.

Mains fuse

UK standard (BS1363) plugs must have a 3 amp (BS1362 type) fu

se fitted. Replace the plug or have the

power lead assembly replaced if the fuse cover is lost.

Symbols

This equipment is double insulated and
an earth connection is not required.

Dangerous voltage constituting a risk
of electric shock is present inside this

equipment.
This mark is applied to show the
equipment conforms to European
safety and electro-magnetic
compatibility standards.

There are important operating and
maintenance instructions in the
literature accompanying this
equipment.

2

Battery Installation
To use this unit with battery power, remove the battery compartment on the
rear of the unit by sliding it towards the rear of the unit and lifting the battery
door off. Insert six (6) "C" size batteries (batteries not included) following the
diagram in the compartment.

POWER SOURCE