Curtis IP1500UK User Manual

iPOD RADIO CD MICRO SYSTEM

MODEL NO. iP1500UK

OWNER'S MANUAL

PLEASE READ BEFORE OPERATING THIS EQUIPMENT

1

WARNING AND PRECAUTIONS

TO PREVENT FIRE OR SHOCK HAZARDS, DO NOT EXPOSE THIS
UNIT TO RAIN OR MOISTURE.

This symbol, located on back or bottom of the unit, is intended to alert the
user to the presence of uninsulated “dangerous voltage” within the product’s
enclosure that may be of sufficient magnitude to constitute a risk of electric
shock to persons.

This symbol, located on back or bottom of the unit, is intended to alert the

DANGER:

Invisible and hazardous laser radiation when open and interlock failed or
defeated. Avoid direct exposure to beam.

user to the presence of important operating and maintenance (servicing)
instructions in the literature accompanying the appliance.

Any use of the controls or an adjustment to the procedures other than those
specified herein may result in hazardous radiation.

CAUTION: TO PREVENT ELECTRIC SHOCK, MATCH WIDE

BLADE OF PLUG TO WIDE SLOT, FULLY INSERT.

To reduce the risk of electric shock, do not remove cover (or back). There are
no user-serviceable parts inside. Please refer any servicing to qualified service
personnel.

WARNING: Changes or modifications to this unit not expressly approved by

the party responsible for compliance could void the user’s authority to operate
the equipment.

2

Power Sources

This portable audio system is designed to operate on
either 230V AC, 50Hz house current.

AC Operation

Unwind the AC cord and extend it to its full length. Insert the small end of the AC cord into the AC
socket on the rear of the unit. Insert the other end of the AC cord into any convenient 230V AC,
50Hz household outlet.

PREPARATION FOR USE

Connecting the Speakers

Place the speakers on either side of the main unit.

Connect the speaker on the left side of the main unit to the "L" speaker jack on the
back panel.

Connect the speaker on the right side of the main unit to the "R" speaker jack on
the back panel.

Right Side Speaker

Left Side Speaker

Speaker wire with white strip will connect to "Red" speaker jack and speaker wire without
the white strip will insert to "Black" speaker jack
Make sure the speaker wires are fully inserted and locked into the speaker jacks on the
back panel of the main unit.

LOCATION OF CONTROLS

1.

2.

3.

4.

5.

6.

7.

8.

POWER BUTTON

MEM/CLK ADJ BUTTON

REPEAT/M-DN BUTTON

TIMER BUTTON

SLEEP BUTTON

FUNCTION BUTTON

IPOD BUTTON

SKIP/TUNE DN BUTTON

9.

10.

11.

12.

13.

14.

15.

16.

PRESET EQ BUTTON

SKIP/TUNE UP BUTTON

VOLUME DN BUTTON

VOLUME UP BUTTON

STOP/BAND BUTTON

OPEN/CLOSE BUTTON

HEADPHONE JACK

PLAY/PAUSE MEM-UP BUTTON

3

1 2 3 4 5 6 7

8 9 10 11 12 13 14 15 16

LOCATION OF REMOTE CONTROLS

1.

2.

3.

4.

5.

6.

7.

8.

9.

POWER BUTTON

FUNCTION BUTTON

DISPLAY BUTTONS

FM ST BUTTON

SKIP/TUNE DN BUTTON

SLEEP BUTTON

SKIP/TUNE UP BUTTON

TIMER BUTTON

MEM/CLK SET BUTTON

10.

11.

12.

13.

14.

15.

16.

17.

18.

STOP/BAND BUTTON

REPEAT/MEM DN BUTTON

PLAY/PAUSE/MEM UP BUTTON

VOLUME DN BUTTON

MUTE BUTTON

EQ BUTTON

VOLUME UP BUTTON

IPOD BUTTON

OPEN/CLOSE BUTTON

4

1

2

3

4

5

11

12

POWER

EJECT

FM ST

EQ

MUTE

CLK SET

MEM DN

TUNE/SKIP

BAND MEM-UP

VOL

VOL

iPOD

REPEAT

6

7 8 9 10

13

14

15

16

17

18

POWER SOURCES

BATTERIES
NOTE:
The button cell battery contains mercury, don't put in the trash. Recycle or
dispose as hazardous waste.

NOTE:
You may need to remove a protectiv e covering from the remote's battery
compartment before using the remote control.

5

(FOR REMOTE CONTROL)