Curtis DVD5036 User Manual

PRECAUTIONS
Frequency Response: Main Speakers 200Hz-20kHz +/- 3dB Surround Speakers 200Hz-20kHz +/- 3dB Center Speaker 200Hz-20kHz +/- 3dB Subwoofer 20Hz-200Hz +/- 3dB
S/N Ratio > 76dB Input Sensitivity 350mv, 47k Channel Resolution > 30dB (Normal)
Remote Control
Transmitter Infrared Ray Signal Range Approximately 15' Power Source 2 AAA Batteries
General
Power Supply AC 120V~60Hz Consumed Power 105W Size (WxHxD) 420 mm x 50 mm x 348 mm
Because its products are subject to continuous improvement, We reserves the right to modify product design and/or specifications without notice and without incurring any obligations.
""
A lightning bolt with an arrowhead symbol within
an equilateral triangle is intended to alert the
user to the presence of uninsulated "dangerous
voltage" within the product's enclosure that may
be of sufficient magnitude to constitute a risk of electric shock to persons.
The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and main-
tenance (servicing) instructions in the literature
accompanying the appliance.
WARNING: TO AVOID THE DANGER OF FIRE
OR ELECTRIC SHOCK, DO NOT EXPOSE THIS
APPLIANCE TO RAIN OR MOISTURE. NEVER OPEN THE CABINET, AS DANGEROUS HIGH VOLTAGES ARE CONTAINED INSIDE. ONLY
A QUALIFIED SERVICE TECHNICIAN SHOULD
ATTEMPT TO OPEN THE CABINET.
CAUTION: TO PREVENT ELECTRIC SHOCK, MATCH WIDE BLADE OF PLUG TO WIDE
SLOT, AND FULLY INSERT INTO ELECTRICAL
SOCKET.
PROTECT YOURSELF!
Record the model and serial numbers for this
unit while it is easy to see them. These numbers
are located on the back of the unit's cabinet. Retain this information for future reference.
Model Number DVD5036 Serial No. _________________________
Retain this information for future reference.
WARNING
RISK OF ELECTRICSHOCK
DO NOT OPEN
CAUTION
RISK OF ELECTRIC SHOCK DO NOT OPEN
CAUTION: TO REDUCE THE RISK OF
ELECTRIC SHOCK, DO NOT REMOVE COVER
(OR BACK). THERE IS NO USER SERVICE ABLE PART INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.
28
CAUTION: This DVD receiver unit employs a laser system. To prevent direct exposure to the laser beam, do not open the enclosure. Visible laser radiation is present when enclo­sure is open. DO NOT STARE INTO BEAM. Additionally, the use of controls or adjustments or performance of procedures other than those specified herein may result in hazardous radia­tion exposure.
To ensure proper use of this product, please read this owner's manual carefully and retain for future reference. Should the unit require maintenance, contact an authorized service centre.
1
IMPORTANT--
SAFETY INFORMATION
JPEG FILES
TROUBLE SHOOTING
2
CAUTION: Is it important that you read and follow all
CAUTION: Is it important that you read and follow all
of the instructions in this booklet and any marked on
of the instructions in this booklet and any marked on
the unit itself. Retain this booklet for future reference.
the unit itself. Retain this booklet for future reference.
Accessories--- Never place this product on an un-
Accessories--- Never place this product on an un-
stable platform, stand, cart, wall mount, shelf, or
stable platform, stand, cart, wall mount, shelf, or
table. The product may fall, causing serious personal
table. The product may fall, causing serious personal
injury to persons and pets, as well as seriously
injury to persons and pets, as well as seriously
damaging the product. Use only with a stable platform,
damaging the product. Use only with a stable platform,
stand, cart, wall mount, shelf, or table that has been
stand, cart, wall mount, shelf, or table that has been
recommended by CURTIS or sold with the product .
recommended by CURTIS or sold with the product .
Any mounting of the product should follow the
Any mounting of the product should follow the
manufacturer's instructions, and use a mounting
manufacturer's instructions, and use a mounting
accessory recommended by the manufacturer.
accessory recommended by the manufacturer.
This unit while positioned on some type of cart must
This unit while positioned on some type of
be moved with care. Quick stops, excessive
be moved with care. Quick stops, excessive force,
and uneven surfaces may cause the product and
and uneven surfaces may cause the product and
cart combination to overturn.
cart combination to overturn.
Attachments---Use only approved attachment as
Attachments---Use only approved attachment as
they may cause hazards.
they may cause hazards.
Cleaning--- Always unplug this unit from the wall
Cleaning--- Always unplug this unit from the wall
electrical outlet before cleaning. Do not use liquid or
electrical outlet before cleaning. Do not use liquid or
aerosol cleaners; use a damp cloth for cleaning.
aerosol cleaners; use a damp cloth for cleaning.
Lightning--- For added product protection during
Lightning--- For added product protection during
a lightning storm or when it is left unattended and
a lightning storm or when it is left unattended and
unused for long periods of time, unplug it from the
unused for long periods of time, unplug it from the
wall outlet and/or disconnect the antenna or cable
wall outlet and/or disconnect the antenna or cable
system. This will prevent damage to the product due
system. This will prevent damage to the product due
to lightning and power-line surges.
to lightning and power-line surges.
Object and Liquid Entry--- Never push objects of
Object and Liquid Entry--- Never push objects of
any kind into this product through openings as they
any kind into this product through openings as they
may touch dangerous voltage points or short-out
may touch dangerous voltage points or short-out
parts that could result in a fire or electric shock.
parts that could result in a fire or electric shock.
Never spill liquid of any kind on or into the product.
Never spill liquid of any kind on or into the product.
Outdoor Antenna Grounding--- If an outside
Outdoor Antenna Grounding--- If an outside
antenna or cable system is connected to the product,
antenna or cable system is connected to the product,
be sure the antenna or cable system is grounded so
be sure the antenna or cable system is grounded so
as to provide protection again stvoltage surges and
as to provide protection again stvoltage surges and
built-up static charges.
built-up static charges. Overloading---Do not overload wall outlets, exten-
Overloading---Do not overload wall outlets, exten-
sion cords, or integral convenience receptacles, as
sion cords, or integral convenience receptacles, as
this may result in a fire or electric shock.
this may result in a fire or electric shock.
Power - Cord Protection - Power - supply cords
Power - Cord Protection - Power - supply cords
should be routed so that they are not likely to be
should be routed so that they are not likely to be
walked on or pinched by items placed upon or against
walked on or pinched by items placed upon or against
them, paying particular attention to cords at plugs,
them, paying particular attention to cords at plugs,
convenience receptacles, and the point where they
convenience receptacles, and the point where they
exit from the product.
exit from the product.
cart must
force,
Power Lines---An outside antenna system should
Power Lines---An outside antenna system should
not be located in the vicinity of overhead power lines
not be located in the vicinity of overhead power lines
or other electric light or power circuits, or where it
or other electric light or power circuits, or where it
can fall into such power lines or circuits. When
can fall into such power lines or circuits. When
installing an outside antenna system, extreme care
installing an outside antenna system, extreme care
should be taken to keep from touching such power
should be taken to keep from touching such power
lines or circuits as contact with them might be fatal.
lines or circuits as contact with them might be fatal.
Power Sources---This product should be operated
Power Sources---This product should be operated
only from the type of power source indicated on the
only from the type of power source indicated on the
marking label. If you are not sure of the type of power
marking label. If you are not sure of the type of power
supply to your home, consult your product dealer or
supply to your home, consult your product dealer or
local power company. For products intended to
local power company. For products intended to
operate from battery power or other sources, refer to
operate from battery power or other sources, refer to
the operating instructions. This DVD home theater
the operating instructions. This DVD home theater
operates on AC 120V/60Hz. Do not turn off unit
operates on AC 120V/60Hz. Do not turn off unit
immediately after turning on; wait at least 10 seconds.
immediately after turning on; wait at least 10 seconds.
Replacement Parts--- If replacement parts are
Replacement Parts--- If replacement parts are
required, be sure the service technician has used
required, be sure the service technician has used
approved replacement parts or have the same
approved replacement parts or have the same
characteristics as the original part. Unauthorized
characteristics as the original part. Unauthorized
substitutions may result in fire, electric shock, or
substitutions may result in fire, electric shock, or
other hazards.
other hazards.
Safety Check---Upon completion of any service
Safety Check---Upon completion of any service
or repairs to this product, ask the service technician
or repairs to this product, ask the service technician
to perform safety checks to determine that the
to perform safety checks to determine that the
product is in proper operating condition.
product is in proper operating condition.
Servicing--- Do not attempt to service this product
Servicing--- Do not attempt to service this product
yourself as opening or removing covers may expose
yourself as opening or removing covers may expose
you to dangerous voltage or other hazards. Refer all
you to dangerous voltage or other hazards. Refer all
servicing to qualified service personnel.
servicing to qualified service personnel.
TV System---This unit is compatible with television
TV System---This unit is compatible with television
sets featuring either the NTSC or PAL color system.
sets featuring either the NTSC or PAL color system.
Ventilation---Slots and openings in the cabinet
Ventilation---Slots and openings in the cabinet
are provided for ventilation and to ensure reliable
are provided for ventilation and to ensure reliable
operation and protection from overheating. These
operation and protection from overheating. These
openings should never be blocked by placing the
openings should never be blocked by placing the
product on a bed, sofa, rug, or other similar surface.
product on a bed, sofa, rug, or other similar surface.
This product should not be placed in a built-in install-
This product should not be placed in a built-in install-
ation such as a bookcase or rack unless proper
ation such as a bookcase or rack unless proper
ventilation is provided. Never place this product near
ventilation is provided. Never place this product near
a heat source, such as heat registers, stoves,
a heat source, such as heat registers, stoves,
radiators, or any other product that produces heat.
radiators, or any other product that produces heat.
Water and Moisture---Do not use this product near
Water and Moisture---Do not use this product near
sources of water and moisture, such as bath tub, wash
sources of water and moisture, such as bath tub, wash
bowl, kitchen sink, or wash machine; in a wet, damp
bowl, kitchen sink, or wash machine; in a wet, damp
basement; or near a swimming pool or similar
basement; or near a swimming pool or similar
locations. If moisture condensation occurs, remove
locations. If moisture condensation occurs, remove
any disc, connect the unit's power cord to a wall outlet,
any disc, connect the unit's power cord to a wall outlet,
turn the unit on, and leave it on for two to three hours.
turn the unit on, and leave it on for two to three hours.
By then, the unit will have warmed up and evaporated
By then, the unit will have warmed up and evaporated
any moisture.
any moisture.
JPEG adoptting the most efficient compression is widely used as picture storage type flattened and stored format. Even if pictures are compressed 15-20 times. They still have good effect. Supported by most
This handy trouble-shooting guide is
provided to save you time in case you experience
any inconvenience with this DVD player. If the problem is not listed or if the provided solution does not correct the problem, please return to point of sales within 12 months of purchase.
picture processing software, fit for picture storage, it has small data and easy use .This machine can read. JPEG-fomat-made picture CD disc.
Press revelant number key to select picture display.
1.Put in disc correctly, the machine begins to search disc information.
2. Press number key to select picture.
3. It s efficient only in present picture when press number key.
Problem Possible Solution No power
1. Check to ensure that the power plug is securely in the wall outlet.
No sound
1. Check the connection between the DVD player and the TV set, amplifier, or any other unit it is connected to.
2.Check to ensure the TV and amplifier are in the correct mode.
Select to play by menu
1. Put in disc, machine searches disc information andmain menu displays on screen. press number key from 1 to select picture. press play key to make sure.
2. Press direction key to select picture then press play key.
3. In condition of stop. press direction key to select other pictures.
4. In condition of stop. select the first line file item on the right. Then press play key, to return to upper menu.
No picture
1. Check the connection between the DVD player and the TV set or any other unit it is connected to.
2.Check to make sure TV is turned on.
Disc does not play
1.Check to make sure the disc is loaded correctly label side facing up on disc tray.
2.Check that disc is clean from dirt, dust, fingerprints, and smudges.
3.Check to ensure disc is with in the guides on the tray.
4.Check if parental lock function is on.
5.Make sure disc is for use in region
27
Remote does not work.
1. Check batteries; possibly replace.
2. Check to ensure there isn't any obstacles between the remote sensor on the unit's front panel and the remote control.
3.Be sure the remote is aimed at the remote sensor.
Divided picture
1.Check that disc is clean and has no scratches.
2.The unit is controlled by a micro computer, which may need to be reset. Turn off the unit's power, wait several seconds, then turn back on.
No color picture
1.Check to see if the S connector is damag­ ed (bent pin).
MP3 discs don't play
1. Use another software edition to re burn disc, as the edition used may not be com­ patible with the player.
2. Use new editions of software such as Audio station 4, asy CD Creator , To ast
"E "
Titanium, etc.
3. Make sure MP3 file is not encoded with a variable bit rate, such as provided by Real Networks.
.. Prefrence page ..
TV type Audio Subtitle Disc menu Parental Default
NTSC ENG ENG ENG 8 ADULT RESET
Preferred menu language
Loading...
+ 10 hidden pages