Cunill TRANQUILO, TRANQUILO-2, BRASIL, TAURO, SPACE User guide
...
User’s Manual
ATTENTION - Read before start-up
This appliance can be used by children aged 8 years and older and
people with reduced physical, sensory or mental capabilities or lack
of experience and knowledge if they have been given appropriate
supervision or training in the use of the appliance in a safe way and
understand the dangers involved. Children should not play with the
appliance. Children without supervision should not do the cleaning
and maintenance to be carried out by the user.
Recommended operating and rest times:
-Manual models: 3 minutes working, 15 minutes stop.
-Electronic models : 6 seconds working, 44 seconds stop.
-Cleaning instructions for parts in contact with food:
All cleaning must be done with the grinder unplug using On/OFF
switch (11).
For the hopper’s cleaning, you should remove the Hopper of coffee
beans (2), wash it using a highly diluted solution of dishwasher liquid
in water (by hand). Make sure the hopper is completely dry before
re-attaching it.
Fort he blades’ cleaning, remove the coffee beans Hopper (2), remove
the platen by pressing the adjustment pawl (6). Cleaning using a dry
brush. Replace all the parts.
Fort he dispenser’s cleaning, empty the dispenser (8), remove the
dispenser lid (7). Cleaning the dispenser with a dry brush. Replace
the parts.
For the outer body of the coffee grinder cleaning, use a soft cloth
dampened in water.
-How to properly use protections against moving parts:
There is a safety guard located in the lower portion of the coffee bean
Hopper (2) to prevent contact with the grinding blades. This device
lets the coffee beans drop but avoids the insertion of the ngers.
-How to properly tting the protections against moving parts and
hazards that may exist if these parts are disassembled:
Before turning the coffee grinder, make sure the Hopper (2) is well-
attached and xed.
-Special precautions during installation:
Place the grinder on a at and stable surface, in an appropriate
distance from a ground mains outlet (approx. 110cm.), distanced
from running water and heat sources. Minimum clearances: Width:
20cm. on both sides. Depth: 20cm in front of and behind the grinder.
Height: 30cm. on the top of the grinder.
The electrical installation must be done by qualied personnel and
following safety indications:
Make sure the electrical data on the coffee grinder’s specication
plate (see section 37 of this manual), connect the grinder to a
grounded mains outlet meeting the country’s regulation, protect
the power source with a suitable magneto-thermal switch, having a
suitable differential relay, make sure the mains wiring is suited to the
device’s power consumption, do not use cable extensions, adaptors
or multiple-switch boards. If the power cord is damaged, it must be
replaced.
Do not operate the coffee grinder while barefoot or with wet or damp
hands or feet, avoid wetting the outer surface of the coffee grinder,
avoid the penetration of solid objects in the interior of the grinder.
Never turn on the grinder with any moving parts not correctly in place.
Put the Hopper cover (1) in place (on the top of the Hopper (2)) after
lling it. Never run the coffee grinder without the Hopper (2) properly
xed. Never run the grinder without the dispenser lid (7) correctly in
place. Take into account the maximum operation time detailed on the
specication plate.
While lling the Hopper (2) make sure no objects accidentally fall
into it. Always follow the instructions in this manual. Make sure the
machine is not operated by anyone who has not read this manual.
ATTENTION - Read before start-up
-The appliance should not be cleaned under running water.
-If the power cord is damaged, the manufacturer must replace it, by
its aftersales service or by similar qualied personnel.
-Any precautions that must be taken during the maintenance to be
performed by the user:
Do not operate the coffee grinder while barefoot or with wet or damp
hands or feet, avoid wetting the outer surface of the coffee grinder,
avoid the penetration of solid objects in the interior of the grinder.
Never turn on the grinder with any moving parts not correctly in place.
Put the Hopper cover (1) in place (on the top of the Hopper (2)) after
lling it. Never run the coffee grinder without the Hopper (2) properly
xed. Never run the grinder without the dispenser lid (7) correctly in
place. Take into account the maximum operation time detailed on the
specication plate. While lling the Hopper (2) make sure no objects
accidently fall into it. Always follow the instructions in this manual.
Make sure the machine is not operated by anyone who has not read
this manual.
Regular maintenance checks: if you observe any abnormal operation,
turn off and unplug the coffee grinder immediately from the mains
outlet and contact Cunill’s Technical Service. Any possible repairs
must be made by Cunill’s Technical Service or by authorized dealer
personnel. Do not try to modify the coffee grinder in any way. Use
only Original Spare Parts, provided by the manufacturer in all repair
work. All maintenance work should be done with the coffee grinder off
and unplugged from the mains.
-Any safety instruction that is considered appropriate, apart from the
previous ones required by the standard:
Cleaning precautions. Safety guidelines: before cleaning any part of
the coffee grinder make sure you turn it off using the ON/OFF switch
(11) and unplug it from the mains outlet. Never clean the grinder
submerging in water. Do not use abrasive cleaners or chemical
solvents.
Before using the coffee grinder, it is necessary to follow the
instructions to ll with coffee beans, which is a maintenance
operation to be carried out by the user:
Make sure the coffee bean Hopper (2) is correctly placed and
attached. Close the trap (5) preventing the beans from entering to
the blades. Lift the hopper lid by removing the xing screws (1), ll
the hopper (2) and close the lid. Except during the operation of lling
with coffee beans and cleaning the hopper, it is essential that the lid
is always in position to maintain the quality of the coffee and prevent
the entry of any foreign body. Slide the trap (5) to its outer position
letting the beans drop into the grinder.
03 CUNILL Coffee Grinders00 Table of contents
Manufacturer’s Identication
Identication of the Model
Welcome to the World of Cunill
Technical Specications
Identication ( Classic) of the Components
Machine Air Noise
Unpacking
Placement of Coffe Grinder
Electrical wiring
Before using the Coffee Grinder
Grinding Coffee Beans
Obtaining a Measure of Ground Coffee
Operating of the models MICHIGAN/HAWAI
Adjusting Coffee Grinding Level
Adjusting Ground Coffee Amount
Maximum Operating Time
Cleaning Precautions
Maintenance Precautions
Troubleshooting
Long-Term Storage
Usage Precautions
User-Adopted Safety Measures
Residual Risks
Specications Plate
EC Conformity Declaration
1-2
Use, Maintaenance and Safety
3
4-5
6-7
This User’s Manual has been written to comply with EC regulations,( EN 2929-2, 5; and
8
Appendix of the Machinery Directive - ECC
Oficial Journal).
9
10
MOLCUNILL, manufacturer of CUNILL
coffee grinders, reserves the right to modify
11
the specifications detailed in this manual
12
without prior notice, with the only intent to
upgrade and enhace its products
13
14
15
16
02 Manufacturer’s Identification
17
Manufacturer: MOLCUNILL, S.L
18
Brand Name: CUNILL
19
Country of Origin: ESPAÑA
Postal Address:
20-24
Carretera de Santa Coloma, s/n
25-28
Apartado de Correos nº 18.
17410 SILS - MALLORQUINES (GIRONA)
29-30
ESPAÑA
31
Tel. (National): 972.168282
32
Fax (Nacional): 972.853104
Tel. (Inter’l): +34.972.168282
33-35
Fax (Inter’l): +34.972.853104
36
www.cunill.com - email: cunill@cunill.com
37
38
User’s Manual.
Instructions.
When a number appears in the text in
brackets (e.g. (9)), it refers to a part of
the grin der which is detailed in section 08
(Identification of external components.
MANUFACTURERS OF COFFEE GRINDERS
SINCE 1957
03 Identification of the Models
04 Welcome to the World of
CUNILL
The usage and maintenance instructions
detailed in this manual are applicable to all
CUNILL brand-name coffee grinders which
make up our present product range, with the
following commercial names:
“CLASSIC”
(nº3)TRANQUILO,(nº3)TRANQUILO-2
(nº3)BRASIL,(nº3)TAURO,(nº5)SPACE,
(nº5)MARFIL(nº12)MICHIGAN.
“SILENCER”
(nº9)KENIA,(nº11)JAMAICA,(nº12)MOVIE
(nº12)LUXO,(nº12)LUXOMATIC,(nº12)
HAWAI
“ELECTRONICS”
(nº3)TRON-TRANQUILO,(nº9) TRONKENIA(nº11)TRON-JAMAICA,(nº12)
LUXOMATIC.
In their respective versions “w/handle” and
“automatic”.
Our ESPECIAL BAR product, which is also
part of our production, is simply a motorless
ground coffee dispenser.
Therefore, its usage and maintenance specifications are the same as for our other
manufactured products, expect for those
reffering to the motor.
We want to thank you for your trust in
CUNILL coffee grinders, manufactured by
MOLCUNILL.
The coffee grinder which you have just bought is manufactured following strict quality
control standards, and has been designed
applying ergonomical principles, so that you
will have no problems whatsoever using it
and so that it will provide comfortable and
safe operation.
In this manual you will find all the information
necessary for installing, using, maintaining
and cleaning your coffee grinder. Follow all
of these instructions carefully to ensure a
long, trouble free life for your coffee grinder.
If any problem arises or you have doubts as
to the contents of this manual, please
do not hesitate to consult our Technical
Service, which from this moment on is at
your entire service.
Xavier Cunill
Product Manager
Our products MICHIGAN, HAWAI depends
on specific operating features that are different from the others. These are also described in this manual.
Our series of products called TOP-LINE,
EXCLUSIVE, modify ONLY THE OUTER
FINISH of the grinders. Usage, service and
maintenance instructions ARE THE SAME
FOR ALL MODELS.
05 For you Safety and Good
Operation
06 General Description
CUNILL coffee grinders are designed to
provide safe, durable and reliable operation
if used correctly. Therefore, it is VERY
IMPORTANT to read this instruction manual
carefully before using the coffee grinder for
the first time. Follow each and every item
in the order in which they appear, and pay
even more attention to warnings regarding
installation, use, maintenance and cleaning
especially those sections marked with the
symbol:
as they refer to
opertions which may be
HAZARDOUS TO THE
USER if not perfomed
correctly.
If you fail to follow the instructions, incorrect
use may cause bodily harm or material
damage.
The manufacturer may not be held liable for
any transformation, regulation, alteration
and/or modification to caffee grinders not
made by qualified personnel. These may
lead to material damages or bodily harm.
All of the machines presented in this
manual are coffee grinders powered by
electric motor and destined for commercial
use.
07 Technical Specifications
(nº3) TRANQUILO-TRANQUILO-2 - TRON
Models
H: 380mm L: 280mm W: 140mm Wei: 8Kg
Number of Motors: 1
Voltage: 230v -110v -Frequency: 50Hz-60Hz
Phases: 1(single) - Amperage:1,15A - 2,53A
Power: 0,10/270
Condenser: 10nf-450v - 40nf-400v
Speed: 1300-1650-Protection Degree: IP21.
Motor Equiped with Thermal Protector
Tempered Steel Grinding Wheels, 60mm.
Duration of Grinding Wheels:500kg Cof.B.
Hopper Capacity: 1/2Kg.
Dispenser Capacity: Direct fall to holder.
Disp. Adjustment: M/Placa electrónica.(Tra).
Disp. Adjustment: 5Gr - 12Gr.(Tranquilo-2)
-Manual.models:3minutes working, 15 minutes stop.
-Electronic.models:6 seconds working, 44 seconds stop.
Although the manual which you are
reading right now is written in your contry’s
language, we also have this manual in all
official EC languages. If you wish to obtain
one of these, or a translation into any other
languages, please contact our Commercial
Department, which will gladly provide it to
you. (You will find our address and telephone
number in this manual).
Store this manual in a safe place for future
reference.
Loading...