Page 1
2
5
Grid
Brushed Stainless Steel
Octagonal Hanging Cookware Rack
Pot Hook
6
Nut
7
Ceiling Hook
Model CRC-29B
Base
6
Hanger
Arm
Beautifully display Cuisinart® Cookware and keep
it within easy reach. This Cuisinart
®
Brushed
4
3
Stainless Cookware Rack eliminates the need to
bend down to stack and store cookware in
cupboards. The solid brushed stainless rack is
easy to install and is designed to last a lifetime.
WARNING:
PLEASE READ ALL INSTRUCTIONS
BEFORE ASSEMBLING AND INSTALLING
YOUR NEW COOKWARE RACK
Enclosed you will find everything needed for the proper assembly and use of your cookware rack. Two people make
assembly and installation easier. The parts and hardware included are:
(1) Octagonal Base (3) Hanger Arms (5) Grid (7) Ceiling Screw Hooks
(2) Pot Hooks (4) Allen Head Bolts (6) Nuts with lock washers (8) Allen Head Wrench
1
Allen Head Bolt
Rack Size: 31½" Length x 15½" Width x 19" Height
ASSEMBLY and INSTALLATION INSTRUCTIONS
Please proceed carefully, using the following instructions to assure this rack is assembled properly for safe installation and
use, and without damage to the finish. Haste in assembly could result in needless scratching or marring of the stainless
steel finish.
1. Unwrap rack base and grid from plastic covering. Notice that each hanger arm has one hole on one
end and two different sized holes at the other end. The end with one hole is the end that attaches to the
octagonal base. Notice also that two of the hanger arms have a threaded hole at the end with two holes.
2. Join the two hanger arms with the unthreaded holes to the two hanger arms with the threaded holes
by placing an allen head bolt through the unthreaded hole to the threaded hole in each set. Leave the
screw loose (diagram A).
3. Place the octagonal base on a flat surface. Next attach the arm sets to the base by placing them directly
over the mounting holes on the base. (Make sure that the allen head bolts at the top of the arm sets are both
showing from the same side of the rack.) Attach the four remaining allen head bolts going from the outside of the hanger arms to the inside of the base. Make sure that the arm sets are at right angles to the base,
and then tighten all the screws using the allen head wrench provided. Thread the two nuts onto the ends of the joined
hanger arms and tighten.
4. Place the grid on the octagonal base resting on the allen head bolts. Assembly is now complete and your cookware rack
is ready to hang.
5. Your rack must be anchored into the solid wood of ceiling joists or beams – to install otherwise is improper.
Plasterboard or wall fasteners will not work and should not be used. Carefully measure the area where the rack is to
be hung. The ceiling screw hooks should be 16" apart.
6. Install your ceiling screw hooks. Your local hardware store can advise you if special hardware is needed for your
particular kitchen.
7. Hang your pot hooks from the interior grid only. Do not hang them from the perimeter or the cut portion of the grid.
Distribute cookware evenly.
8. Use a low-abrasive product to clean your cookware rack. A periodic cleaning will restore the stainless steel to its
original brilliance.
Diagram A
WARNING It is important that your cookware rack be assembled and installed according to the above directions. If the
unit is assembled and or installed incorrectly, it could become unstable, collapse and possibly cause injury. Cuisinart is not
responsible for any damages due to improper assembly or installation.
OVER PLEASE
Page 2
Lifetime Warranty
Your Cuisinart
®
Cookware Rack is warranted to be free of defects in material and workmanship under normal
home use from the date of original purchase throughout the original purchaser’s lifetime. If your cookware rack
should prove to be defective within your lifetime, we will repair it (or, if we think it necessary, replace it)
without charge to you, except for shipping and handling. To obtain warranty service, please call our Consumer
Service Center toll-free at 1-800-726-0190, or write to Consumer Service Center, Cuisinart, 150 Milford Road,
East Windsor, NJ 08520. To facilitate the speed and accuracy of your return, please also enclose $7.00 for
shipping and handling of the product. Be sure to include a return address, description of the product problem,
phone number, and any other information pertinent to the product's return. Please pay by check or money
order. This warranty excludes damage caused by accident, misuse or abuse and improper installation. This warranty also expressly excludes all incidental or consequential damages. Some states do not allow the exclusion
or limitation of incidental or consequential damages, so the foregoing limitation or exclusion may not apply to
you. This warranty gives you specific legal rights, and you may also have other rights which vary from state to
state.
CALIFORNIA RESIDENTS ONLY
California residents need only supply proof of purchase and should call 1-800-726-0190 for shipping
instructions. California law provides that for In-Warranty Service, California residents have the option of
returning a nonconforming product (a) to the store where it was purchased or (b) to another retail store that
sells Cuisinart
®
products of the same type. The retail store shall then, according to its choice, either repair the
product, refer the consumer to an independent repair facility, replace the product, or refund the purchase price
less the amount directly attributable to the consumer’s prior usage of the product. If the above two options do
not result in the appropriate relief to the consumer, the consumer may then take the product to an independent
repair facility if service or repair can be economically accomplished. Cuisinart, and not the consumer, will be
responsible for the reasonable cost of such service, repair, replacement or refund for nonconforming products
under warranty. California residents may also, according to their preference, return nonconforming products
directly to Cuisinart for repair, or if necessary, replacement, by calling our Customer Service Center toll-free
at 1-800-726-0190. Cuisinart will be responsible for the cost of the repair, replacement, and shipping and
handling for such nonconforming products under warranty.
©2009 Conair Corporation
Cuisinart is a registered trademark of the Conair Corporation
150 Milford Road, East Windsor, NJ 08520
Made and printed in China 09CW14604
Loading...