Cuisinart 12-Cup Programmable, 12-Cup Programmable Coffeemaker & Hot Water System Quick Reference Manual

Decalcification:

Cleaning Your Hot Water System:

Cleaning Your Coffeemaker:

Filter basket, carafe and lid.

Turn unit off and remove plug from outlet.

Wash filter basket, carafe and lid in warm, soapy water and rinse
thoroughly, or clean in upper rack of dishwasher. Dry after use.

Wipe area under the filter basket with a damp cloth. NOTE: DO NOT PUT

ANY WATER IN THE UNIT ONCE FILTER BASKET IS REMOVED.

To clean base, wipe with damp cloth.

Do not use any scouring agents or harsh cleaners on any parts of the
coffeemaker. Never immerse base of unit in water.

A flashing Clean light indicates unit needs to be decalcified. Fill the water reservoir to
capacity with 1/3 cup of white vinegar and 2/3 cup of water. Press the Clean button; when
light comes on, turn Coffeemaker on. Five beeps sound when Clean cycle is complete; unit
will shut off. Turn unit back on and if Clean light flashes, repeat process; if not, run a brew
cycle with water only. Unit is then ready to use

We recommend you decalcify your hot water system twice a year.

Dispense any water in your reservoir until the Add Water light flashes. Add 32 ounces of
white vinegar. Dispense 16 ounces of vinegar and discard; this will fill the inner tank. Let unit
sit for 20 minutes, then turn to Off and allow hot vinegar to cool. Drain internal reservoir over
sink by removing water release tab on bottom of unit. When vinegar has completely drained,
replace tab. Refill reservoir with water and drain water as directed above. Unit is now ready
to use.

PG-27136

Please see reverse side for setup and use instructions.

UNLOCK LOCK

UNLOCK LOCK

UNLOCK LOCK

UNLOCK LOCK

UNLOCK LOCK

UNLOCK LOCK

To Program the Auto On:
Turn the Function knob to PROG; the
Auto-On LED will flash. Set the time you

want coffee to begin brewing (follow Set
the Time instructions). Once complete, turn the
Function knob to AUTO ON and press the On/Off
button. The blue indicator light will come on to remind
you that the programming function is in use.

2.

4.

To start the brew cycle at the same time the
next day, make sure the Function knob is
on AUTO ON and press the On/Off button.
The blue Auto-On light will illuminate.

3.

At the programmed time, the blue On/Off
indicator light will come on, indicating that
the brew cycle is starting.

5.

To Program the Auto Off: Turn the
Function knob to AUTO OFF. Follow Set the
Time instructions to program Coffeemaker
to shut off 0 to 4 hours after brew cycle
is finished.

To Set the Time: Turn the Function
knob to CLOCK. Press and hold Hour or
Minute button until the clock begins flashing.

Hold down the Hour or Minute button to scroll
through the numbers. When desired time approaches,
release the button and press repeatedly to advance one
digit at a time. To finish, wait for the numbers to stop
flashing.

1.

PROGRAMMING

QUICK REFERENCE GUIDE

12-Cup Programmable Coffeemaker

& Hot Water System

Please see reverse side for setup and use instructions.