Cuddeback Capture, Capture IR Operating Instructions Manual

Introduction

Thank you for purchasing a Cuddeback Capture digital scouting camera.
Capture is so easy to use that you may feel you do not need to read this manual.
However, we recommend you spend 5 minutes familiarizing yourself with some
of the not-so-obvious features of the Capture. At the very least, we recommend
you read how to check your Capture.

What you need

Before you can use your Capture, you will need the following items:

1. One or more Secure Digital (SD) cards. We recommend sizes up to 2 GB,
with 1 GB being the preferred size. The higher the number on the card, the
more images that can be saved on the card. DO NOT USE SDHC CARDS.

2. Four D Cell batteries (we recommend Rayovac, Duracell or Energizer
brand batteries).

3. An optional padlock if you want to prevent tampering. The shaft of the padlock
must be ¼ inch or smaller to fit through the Capture’s padlock opening.

STEP 1 – Familiarize yourself with Capture

Take a moment to familiarize yourself with Capture’s features.

Hinge rod

Flash lens

Camera
window

Red LED

Heat-in-motion sensor

LCD screen

Operation keys

“Stay-open” cover

2

1

1. Push hinge rod

left to hold open

2. Push hinge rod
right to close

SD card port

Green LED

Rotary switch

STEP 2 – Turning Capture on

1. Mount the supplied tree bracket to the
back of the camera with the supplied screw.

2. Turn the rotary switch to the OFF position.

3. Install 4 new alkaline D cell batteries. Make sure to observe correct polarity.

4. A series of numbers will be displayed. These are the Capture’s hardware and
software version numbers.

5. Wait until the LCD display goes blank and the green and red LEDs turn off.

6. Install the SD card into the SD card port. We recommend a 1 GB size card.