Cub cadet 59A40013727 User Manual
Installation Instructions
Clevis Pin (w/Tractor)
Klik Pin
3-Pt. Hitch
Lower Link
3-Pt. Hitch Top Link
711-1105 (Qty. 2)
Klik Pin (w/Tractor)
Rear Weight Box - For Model EX 3200
Model Number: 59A40013727
The 59A40013727 Weight Box attachment is designed for use on
certain Cub Cadet Yanmar tractor models. The weight box can
carry a maximum additional weight of 800 lbs.
IMPORTANT: Do not overload the tractor. Use only the additional
weight needed to counterbalance the weight of the specific front
mounted equipment.
NOTE: All three point hitch mounted equipment must be removed
from the tractor to install the weight box.
Installing the Weight Box
• Two 711-1105 klik pins have been provided to fasten the weight
box to the two lower links of the tractor’s 3-point hitch. Remove
the klik pins from the weight box.
NOTE: The clevis pin and klik pin used to secure the weight box
to the top link of the 3-point hitch should be with the tractor. If they
are not, it will be necessary to acquire the needed hardware from
your Cub Cadet Yanmar dealer before installing the weight box.
• Back the tractor up to the weight box assembly so that one of
the 3-point hitch lower links is on each side of the box.
• Slide each lower link onto the pin on the respective side of the
weight box assembly. Insert a klik pin (711-1105) into the hole
of each pin, and pivot the klik pin ring over the end of the pin to
lock in position. Refer to Figure 1.
• Lower the 3-point hitch top link from its retainer and position
between the two mounting brackets on the top of the weight
box. Refer to Figure 1.
PRINTED IN U.S.A.
Cub Cadet Yanmar LLC P.o. Box 368023 Cleveland, Ohio 44136-0019
Figure 1
• Remove the klik pin and clevis pin from the top link.
• Following the instructions in the tractor operator’s manual,
adjust the top link as necessary to align with the mounting
brackets of the weight box. Insert the clevis pin though the
weight box mounting brackets and the top link, and secure
with the klik pin.
Using the Weight Box
• Use only solid weight (e.g. concrete, sand bags, stones, metal
plates) in the weight box.
• Refer to the front attachment ’s owner’s manual, or the tractor
operator’s manual, for the amount of weight that needs to be
added to the rear of the tractor.
• Where possible, the weight box should be carried in the
lowered position (approximately 12” from the ground) to
provide optimal counterbalance for the front mounted equipment, and stability for the tractor. If it is necessary to carry the
box higher, more weight may have to be added to the box to
effectively counterbalance the front equipment.
WARNING: Use extreme caution when operating
the tractor with the weight box in the raised position. Raising the weight box may raise the center
of gravity of the tractor, which could increase the
risk of rollover.
769-03209
(5/07)
Loading...