The CTX SERVICE MANUAL is published by Chuntex Electronic Co., Ltd
All rights reserved. No part of this manual may be used, copied, reproduced, or transmitted in any form or by
any means for any purpose without the express written permission of the publisher.
The publisher has been trying its best to make this publication perfect, and in this manner takes no
responsibility for the use of any of the materials or methods described in this manual, or for the products
thereof. Neither will the publisher be responsible for any damages caused by misuse or misquotation.
Dec- 2002 - Version 0
C
C
T
T
X
X
Information in this manual is subject to change by the publisher without any notice in advance.
CTX is a registered trademark of Chuntex Electronic Co., Ltd.
-2-
C
T
X
C
T
X
C
T
X
Dec- 2002 - Version 0
1. SCOPE
This specification defines the design and performance requirements for the 17”
SXGA TFT LCD display monitor.“S720 “
There are 2 series of “ S720 ” in each own’s project code.
The common features of the 2 series of “S720 ” are listed in the following table :
Feature Description
1 Universal input AC/DC power supply inside the monitor
2 Analog RGB interface (VGA ) 30~80KHz, 59~75Hz, 135MHz
3 17” SXGA 1280*1024, TFT LCD panel
4
Function keys * 5 : Power On/Off, ESC, △ (up), ▽ (down), (enter)
5
Direct Acess function keys : △ for
6 Green/Amber LED indicator for power on/power saving
7 Plug & play support with DDC2B protocol installed.
8 Power saving mode compliant with Energy Star
9 OSD (on screen display) MENU operation
9.1 Brightness adjustment
9.2 Contrast adjustment
9.3 Auto tune function (VGA)
9.4 Color selection
9.5 Image adjustment
9.6 Position adjustment
9.7 Language selection
9.8 Reset function
contrast function, ▽ for brightness function
Service Manual
S720
-3-
Service Manual
S720
2. INPUT REQUIREMENTS
2.1 Input Power
2.1.1. Power Source
2.1.2. Power Consumption
2.1.3. AC Line Drop Out
2.1.4. AC Wave Distortion
2.1.5. In-rush Current
2.1.6. Power Cord
2.2 Display Input
2.2.1. RGB Video
2.2.2 Sync Signal
2.2.3 Analog Input Connection
C
T
X
100 ~ 240 Vac, + -10%, 50/60 Hz
Normal operating mode : ≦ 35W
Power saving mode : ≦ 2W
Power switch off : ≦ 1.5W
Picture must not disappear while AC 100 V input drop out
(10ms, 100%)
10% max. permitted
50 A max at 240 Vac cold start
Detachable, 3P with ground type.
Analogue, 0.0 to 0.7 V peak to peak
Separate RGB
Input impedance 75 Ohm
Positive polarity
1.Separate horizontal & vertical sync (3.3V & 5V)
Low level 0.8 V maximum
High level 2.0 V minimum
Positive or negative polarity
a. Captive cable(length1.5M) in LCD monitor end, Mini
D-sub 15 pin male in another end.
b.Cable oin assignment
Dec- 2002 - Version 0
C
C
T
T
X
X
-4-
C
T
X
C
T
X
T
X
C
Dec- 2002 - Version 0
Service Manual
S720
Pin 1 Red
Pin 2 Green
Pin 3 Blue
Pin 4 No Connection
Pin 5 Ground
Pin 6 R Return
Pin 7 G Return
Pin 8 B Return
3. ELECTRICAL CHARACTERISTICS
3.1 LCD Panel
3.1.1. Type
3.1.2. Pixel structure
3.1.3. Gray scale
3.1.4. Surface treatment 3H hard coating ,anti-static
3.1.5. Backlight
3.1.6 Pixel Faults
Pixel Faults type
17” diagonal, SXGA resolution, color TFT-LCD
R/G/B sub-pixels in vertical stripes
1280 x 1024 array matrix
A-Si TFT active matrix
16 million Colors.
Integral CCFT ,
Type to support field replacement.
Life time 30000 hours @ 25C, 50% of initial value.
Model
Project
Pin 9 DDC +5V
Pin 10 Ground
Pin 11 Ground
Pin 12 SDA
Pin 13 H. Sync &
Composite sync
Pin 14 V. Sync
Pin 15 SCL
S720
LIS17S24KA
Type1 Bright Pixels (Note 1)
Type2 Dark Pixels (Note 2)
Type3 Fault Pixels / Sub-Pixels(Note 3)
-5-
≦ 5
≦ 5
≦ 3
Service Manual
S720
C
T
X
Dec- 2002 - Version 0
C
C
T
T
X
X
Type4 Cluster of type1 or type 2 faults(Note 4)
Type5 Cluster of type3 faults (Note4)
Type6 Total Pixel Faults
Note 1 : Bright pixels in full black pattern.
Note 2 : Dark pixels in full white pattern
Note 3 : fault Pixel / Sub-Pixel : The pixel or sub-pixel is abnormal but not bright/dark pixel.
Note 4 : Fault Cluster : Two or more Pixels/Sub-pixels with faults within 5 * 5 block of pixels.
≦ 2
≦ 3
≦ 8
-6-
C
y
y
A
y
y
T
X
C
T
X
C
T
X
Dec- 2002 - Version 0
3.2 Modes and Timing Compability
The monitor shall support all the modes listed in Table 1.
Display Format IBM VGAVESAVESAVESA VESA VESA
Horizontal Dots 720640640640800 800 800
Vertical lines 400480480480600 600 600
Horizontal Frequency 31.46937.86137.537.879 48.07746.875
Vertical Frequency 7059.9472.8097560.317 72.18875.000
Pixel Rate ( MHz ) 28.32225.17531.531.5 40 50 49.5
H. Sync. Polarit
V. Sync. Polarit
O ms ( Period ) 16.68313.73513.33316.579 13.85313.333
P ms ( Pulse Width ) 0.0640.0790.0800.106 0.1250.064
Q ms ( Back Porch ) 1.0480.7390.4270.607 0.4780.448
R ms ( Active Area ) 12.71115.25312.67812.80015.840 12.48012.8
S ms ( Front Porch ) 0.3180.2370.0270.026 0.7700.021
Display Format VESAVESAVESAVES
Horizontal Dots 102410241024115212801280
Vertical lines 76876876886410241024
Horizontal Frequency 48.36356.746 60.02367.563.981 79.976
Vertical Frequency 60.00470.069 75.0297560.013 75.025
Pixel Rate ( MHz ) 65.07578.75108108135
H. Sync. Polarit
V. Sync. Polarit
O ms ( Period ) 16.66614.272 13.238 13.333 16.663 13.329
P ms ( Pulse Width ) 0.1240.1060.0500.0440.0470.038
Q ms ( Back Porch ) 0.6 0.5130.4660.4740.5940.475
R ms ( Active Area ) 15.8813.599 12.79512.816.006 12.804
S ms ( Front Porch ) 0.0620.0540.0170.0150.0160.012