CTS MCT-RACK-12-MGM User Manual
MCT-RACK-12-MGM
12 SLOTS COMPACT MEDIA
CONVERTER CENTER
User’s Guide
Version 0.90
2
Trademarks
CTS is a registered trademark of Connection Technology Systems Inc..
Contents are subject to revise without prior notice.
All other trademarks remain the property of their respective owners.
Copyright Statement
Copyright Connection Technology Systems Inc..
This publication may not be reproduced as a whole or in part, in any way whatsoever
unless prior consent has been obtained from Connection Technology Systems Inc..
FCC Warning
This equipment has been tested and found to comply with the limits for a Class-A
digital device, pursuant to Part 15 of the FCC Rules. These limitations are designed
to provide reasonable protection against harmful interference in a residential
installation. This equipment generates uses and can radiate radio frequency energy.
If this equipment is not installed properly and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into a different outlet from that the receiver is connected.
Consult your local distributors or an experienced radio/TV technician for help.
Shielded interface cables must be used in order to comply with emission limits.
Changes or modifications to the equipment, which are not approved by the party
responsible for compliance, could affect the user’s authority to operate the equipment.
Copyright © 2016 CONNECTION TECHNOLOGY SYSTEMS INC.,
All Rights Reserved.
Company has an on-going policy of upgrading its products and it may be possible
that information in this document is not up-to-date. Please check with your local
distributors for the latest information. No part of this document can be copied or
reproduced in any form without written consent from the company.
3
Revision History
Version
Release Date
Description
0.90
20160314
First release
4
Table of Contents
1. INTRODUCTION ......................................................................................... 5
1.1 The MCT-RACK-12-MGM ................................................................... 5
1.2 Connectors, Indicators, and Switches ................................................. 6
2. INSTALLATION ........................................................................................... 7
2.1 Requirement ....................................................................................... 7
2.2 Unpack MCT-RACK-12-MGM ............................................................. 7
2.3 Install MCT Series Media Converters ................................................. 8
2.4 Install MCT-RACK-12-MGM ................................................................ 9
2.4.1 Standard 19-Inch Rack Installation ........................................... 9
2.4.2 Desk Top Installation ............................................................... 10
2.5 Connect MCT Series Media Converters to network .......................... 10
2.6 Connect Power Supply ..................................................................... 10
2.7 Power On the MCT-RACK-12-MGM ................................................. 11
2.8 DI/DO Configuration ......................................................................... 12
3. OPERATION .............................................................................................. 13
3.1 LED Status ........................................................................................ 13
4. MAINTENANCE ........................................................................................ 15
4.1 Fault Identification ............................................................................. 15
4.2 Hardware Replacement Procedures ................................................. 16
4.3 Firmware and Configuration Upgrade ............................................... 16
5
1. INTRODUCTION
Thank you for choosing MCT-RACK-12-MGM. This CHASSIS is specifically
designed to the managed media converter which required monitoring point-topoint connection for the deployment of FTTX applications. By selecting and
installing from among of various MCT series media converters, MCT-RACK12-MGM allows users to upgrade and integrate their existing network.
1.1 The MCT-RACK-12-MGM
Connection Technology Systems (CTS) MCT-RACK-12-MGM, the universal
media converter chassis, provides 12 slots for mixed installation of MCT
series media converters. Up to 12 media converters can be powered by the
MCT-RACK-12-MGM without the external power supply required. The MCTRACK-12-MGM features a redundant power supply system to ensure reliably
system operation even in case of one of power supply module failed.
Moreover, its miniature size allows MCT-RACK-12-MGM to be installed in a
narrow space. All above user friendly designs make MCT-RACK-12-MGM be
in a shape of high performance and reliability.
MCT-RACK-12-MGM can be used as a table top unit or mounted on a 19
inches standard rack by using 19 inches bracket accessories shipped
together with the unit.
6
Hardware Features
Hot-Swappable Converter Modules
Hot-Swappable Power Modules
Power Redundancy
Commercial Operation Temperature 0°C~50°C
Plug & Play Design
Redundant Power Supply
Redundant power supply is provided for non-stop running.
1.2 Connectors, Indicators, and Switches
Front Panel
10/100Mbps RJ-45 LAN port
USB host
Console RS232 port (RJ-45)
LED Indicators
Reset Button
Rear Panel
DC Power Connector
AC Power Connector
➑
Loading...