CTS HES-3106 Series User Manual

HES-3106 SERIES

6 PORTS 10/100/1000BASE-T MANAGED ETHERNET SWITCH

5 PORTS 10/100/1000BASE-T AND 1 PORT 1000BASE-X OR

100/1000BASE-X UPLINK MANAGED ETHERNET SWITCH

5 PORTS 10/100/1000BASE-T AND 1 PORT 1000BASE-X OR

100/1000BASE-X UPLINK MANAGEMENT ETHERNET SWITCH

WITH CATV RF MODULE

User’s Guide

Version 1.0

2

Trademarks

CTS is a registered trademark of Connection Technology Systems Inc..
Contents subject to revision without prior notice.
All other trademarks remain the property of their respective owners.

Copyright Statement

Copyright  2012 Connection Technology Systems Inc..
This publication may not be reproduced as a whole or in part, in any way whatsoever
unless prior consent has been obtained from Connection Technology Systems Inc..

FCC Warning

This equipment has been tested and found to comply with the limits for a Class-A digital
device, pursuant to Part 15 of the FCC Rules. These limitations are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if the
equipment is not installed and used in accordance with the instructions, it may cause
harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:

 Reorient or relocate the receiving antenna.
 Increase the separation between the equipment and receiver.
 Connect the equipment into an outlet on a circuit different from that to which the

receiver is connected.

 Consult your local distributors or an experienced radio/TV technician for help.
 Shielded interface cables must be used in order to comply with emission limits.

Changes or modifications to the equipment, which are not approved by the party
responsible for compliance, could affect the user’s authority to operate the equipment.

Copyright © 2012 All Rights Reserved.
Company has an on-going policy of upgrading its products and it may be possible that

information in this document is not up-to-date. Please check with your local distributors
for the latest information. No part of this document can be copied or reproduced in any
form without written consent from the company.

Trademarks:
All trade names and trademarks are the properties of their respective companies.

3

Table of Contents

1. INTRODUCTION ........................................................................................... 4

1.1 The Managed Ethernet Switch ................................................................. 4

1.2 Appearance .............................................................................................. 5

2. INSTALLATION ............................................................................................. 8

2.1 Installation Requirements ......................................................................... 8

2.2 Checking the Package Contents .............................................................. 8

2.3 Installing the Managed Switch .................................................................. 9

2.4 Powering ON ............................................................................................ 9

2.5 Connecting the Switch to Network .......................................................... 10

3. OPERATION ................................ ................................................................ 11

3.1 LED Definitions ....................................................................................... 11

4. MAINTENANCE .......................................................................................... 12

4.1 Fault Identification .................................................................................. 12

4.2 Hardware Replacement Procedures ...................................................... 13

4.3 Firmware Upgrade .................................................................................. 13

4

1. INTRODUCTION

Thank you for choosing this Managed Ethernet Switch. The Managed Switch
can provide the best performance and price ratio when multiple copper ports
need to be deployed in networking environment.

1.1 The Managed Ethernet Switch

With 5 or 6 10/100/1000Mbps RJ-45 ports on the front panel, this compact
Managed Switch provides high performance store-and-forward switching
capability plus other advanced features such as QoS, VLAN, etc.. Clear,
at-a-glance per-port LED indicators make it easier for users to control and
manage network status. The built-in management module also allows users to
configure, control and monitor the system via SNMP based management
system.

Specification

Interface

 LAN Ports: 10/100/1000BASE-T x 5
 WAN Port: 1000 or 100/1000BASE-X x 1 or 10/100/1000BASE-T x 1

Standards

 Comply with IEEE 802.3, 802.3u, 802.3ab, 802.3z, 802.1q, 802.1p

standards

Features

 Switching:

 Support Auto-Negotiation in TP ports
 Support MDI/MDIX Auto-Crossover in TP ports
 Full/Half Duplex Mode Operation
 MAC Address Table: 2K
 Store-and-Forward Switching Mechanism
 VLANs: Support up to 128 VLAN Groups
 Support Tag VLAN
 Support Q-in-Q VLAN
 Support IGMP Snooping V1 and V2
 Bandwidth Control
 QoS support 802.1p and ToS Classification
 Priority Queues: 4 Queues