C-scope NEWFORCE R1 BROCHURE
051015 20
DISPLAY
GROUND
FREQUENCY
BATTERY
BACK
DISCRIM
SENSITIVITY
AUDIO
PROGRAMS
SET-UP
051015 20
STORE
RECALL
BACK
DISCRIM
SENSITIVITY
AUDIO
PROGRAMS
SET-UP
051015 20
DISCRIM
SIL-SEARCH
MODE
GROUND
BACK
DISCRIM
SENSITIVITY
AUDIO
PROGRAMS
SET-UP
051015 20
TUNE
DC GAIN
AC GAIN
BACK
DISCRIM
SENSITIVITY
AUDIO
PROGRAMS
SET-UP
051015 20
SET
EDIT
LEARN ACC
LEARN REJ
BACK
DISCRIM
SENSITIVITY
AUDIO
PROGRAMS
SET-UP
051015 20
051015 20
051015 20
PIN-PT OFF
PIN-PT ON
MOTION OFF
MOTION ON
BACK
DISCRIM
SENSITIVITY
AUDIO
PROGRAMS
SET-UP
051015 20
51
DISCRIM
SENSITIVITY
AUDIO
PROGRAMS
SET-UP
051015 20
DISCRIM
SENSITIVITY
AUDIO
PROGRAMS
SET-UP
SET
EDIT
LEARN ACC
LEARN REJ
BACK
BACK
TUNE
DC GAIN
AC GAIN
BACK
DISCRIM
SIL-SEARCH
MODE
GROUND
BACK
STORE
RECALL
BACK
DISCRIM
SENSITIVITY
AUDIO
PROGRAMS
SET-UP
DISCRIM
SENSITIVITY
AUDIO
PROGRAMS
SET-UP
DISPLAY
GROUND
FREQUENCY
BATTERY
BACK
CONTRAST
BRIGHTNESS
BACK
computer aided search system
• Twin Microprocessor control system
• Large Backlit Liquid Crystal Display
• CASSY Computer Aided Search System
• RADAR - Real Time Ground Radar Display
• High speed target analyser (ID)
• Target Pin Point
• Audio Discrimination
• Program Storage Facility
• Full range discrimination
• 15cm or 25cm diam lightweight
search heads
• Continuous Battery Monitor
• Recharge Socket
• Headphone Socket
• Independent volume Control
specification
Battery Type: 8 x AA, MN1500 or equivalent, Alkaline
cells recommended.
Supply Voltage: 12v DC (nominal), 13.8v DC (max)
Supply Current: 55mA (no backlight)
100mA (backlight full on)
Switch on the R1 and the opening screen tells you that
it is all ready to go, select program mode and there’s
nothing to adjust except the volume. The R1 is optimised and automatic. There are two powerful
computers, each carrying out one million operations
every second. The first carries out all of the signal and
target analysis. The second controls the user interface.
This takes the data produced by the first processor and
presents it to the user on the display. The twin processor
’’
design enables the R1 to carry on detecting whilst the
user changes settings.
It is unusual these days to find any
particular product made for our hobby
that totally evades criticism. I am
pleased to announce in our opinion
the Newforce R1 is such a product
INDEPENDENT FIELD TESTER
processed by the detector. Any adjustments are made using the simple to operate
’’
This makes it particularly
easy to set the correct discrimination levels and see
the effect of different
modes. The R1 features a
unique Ground Radar display allowing the user to
see the signal being
MENU driven interface. A single button press gives access to the MENU. A straightforward rotary control is used to select the item you wish to change a press of a
button alters the setting.
The R1 is the easiest way
to successful treasure hunting.
Battery Life: 40 Hours normal detecting using Alkaline
batteries and no backlight
Battery Indicator: Alkaline:Full 13.2V Empty 8.5V
Rechargeable: Full 10.8V Empty 8.5V
Audio Frequency: 100Hz to 5.5kHz, 714Hz (nominal)
Transmit frequency: 6.097kHz, 6.250kHz, 6.410kHz
Search Coils: 25cm concentric and 15cm ‘2D’
Detection (Typical in air performance, Motion mode)
Range Guide:
Hammered 6d 20cm
£1 coin 30cm
‘old’ 10p 32cm
Cartwheel 1d 33cm
Large object 125 cms (maximum)
features
Twin Microprocessor control system
•
Large Backlit Liquid Crystal Display
•
CASSY Computer Aided Search System
•
RADAR - Real Time Ground Radar Display
•
High speed target analyser (ID)
•
Target Pin Point
•
Audio Discrimination
•
Program Storage Facility
•
Full range discrimination
•
15cm or 25cm diam lightweight search heads
•
Continuous Battery Monitor
•
Recharge Socket
•
Headphone Socket
•
Independent volume Control
•
ISO 9001 Quality. CE.
•
C.Scope International Ltd
Kingsnorth Technology Park
Wotton Road Ashford Kent TN23 6LN
tel: 01233 629181 fax: 01233 645897
email: info@cscope.co.uk
SINGLE, HIGHLY TUNED
LOW FREQUENCY BETTER
THAN MULTI-FREQUENCY
Exhaustive tests by independent researchers have shown that low frequencies penetrate the ground deeper. Single dedicated frequency means easy
operation and clear, easy to interpret signals. The R1 uses a single, highly
focussed 7kH3signal, ideally suited to EUROPEAN ground conditions
Single,highly
focussed frequency
probes deep.Easy to
use,clear information
from underground.
www .cscope.co.uk
Multiple frequency.
No deeper but mass
of unnecesary signals
makes detector difficult
and complicated to use.
computer aided search system computer aided search system
The NEWFORCE R1 harnesses the power
of the micro-computer to check ground
conditions,optimise depth and provide
target identification data all in a user-friendly
lightweight and highly robust package.
The computer pre-sets everything for the
novice or the professional can manually
change the operating parameters
and tweak performance exactly
to personal preference .
the controls and what they do
ON/OFF VOLUME
This rotary control turns the unit on and simply
adjusts the volume to a comfortable level. No need to
enter the menu system just to change the volume as
with some computerised detectors!
MENU/SCROLL
This easily understood rotary control is used in
conjunction with the ENTER button to access the
menu system and adjust any aspect of R1 operation.
It has two functions. The first is to highlight the
desired menu option. The second is to adjust the value
of a setting up or down.
ENTER
The ENTER push button is used to confirm highlighted
menu selections. Once a menu option has been highlighted then pressing the ENTER button will select
that option. If a value is being set then pushing
the ENTER button will store that value. When no
menus are displayed pushing the ENTER
key will display the menus.
PIN-POINT
Pin-Point and Volume are 'hot' controls. This means
that they are always available for use during the
search. Pin-Point is used to reset the 'Radar' display
and to help the precise positioning of a signal.
Faster find retrieval with the intelligent R1!
menu system
discrimination
This range of functions allows you to reject or ignore unwanted signals
generated by items such as pull tabs. It can also act as a Notch Accept
or a Notch Reject. There are four options to set the discrimination level
to give maximum flexibility and ease of setting. A black block under the
line of ID numbers indicates that a signal with that number will give no
audio sound, the ID display will still show the signal.
sensitivity
These functions allows setting the sensiivity of the R1.
audio
This range of functions control how the audio information about buried
targets is presented.
programs
These functions allow the operator to store and recall the set up of the
R1. Up to two programs can be stored. A program will store all of the
current settings including Discrimination, Sensitivity, Frequencies etc.
It will not store the Display Contrast and Brightness settings. These are
stored separately and retrieved automatically at turn on. The R1 comes
with the first three programs preset to commonly used settings.
The COIN INLAND Program is set for high sensitivity to precious metals,
the ALL METAL Program for deep seeking of all metals and COIN
BEACH Program for Beach use.
set-up
These options allow the display settings to be adjusted. These settings
are stored when the R1 is switched off and will be restored when it is
turned back on.
short while ago I was
pleased to be asked to
A
model from C.Scope, this being
the Newforce R1.
instructions in the manual and
used the detector over a number
of buried targets of known
identity buried in my lawn.
expected. Even a Roman AE4 at
a depth of 5ins, with a rather
sneaky iron nail lying within an
inch of it, was clearly picked out.
Radar graph over each target.
Generally the smaller targets
at greater depth gave smaller
results on the display. The characteristic ’double bang’ of a
hammered lying slightly to one
side was represented by two
small peaks very close together
on the graph. I very quickly
picked up on the use of the
Ground Radar graphics as a
visual pin-point facility, acting
as confirmation to the existing
audio pinpoint facility.
were on perhaps the detectorists’ favourite terrain: the
rolled field. For this I chose
‘Factory setting B’ for all metal
target location. The two hours
we spent on this rolled field
produced a total of 128 targets,
but remember we were searching in all metal mode and
therefore digging up every
signal. Eight coins were found,
comprising seven George II
pennies and one really battered
Victorian halfpenny. The coins
were found at varying depths
from 1in to about 9ins.
measured hole we were still
getting respectable target
audio for a Georgian penny at
a depth of 9-10ins.
their confidence in the
Newforce R1’s ID performance
and the sharpness of the pin-
field-test the latest
I followed the quick set up
All were acknowledged as
I then studied the Ground
A short drive away and we
Putting a coin back into a
Our entire group spoke of
Field Test - Newforce R1
Extracted from Readers’ independent Field Test,
reproduced courtesy of Treasure Hunting magazine
point facility. The others had
also recognised the pinpoint
possibilities of the Ground
Radar simulation graph.
On a meadow site the first
target was a brass tack,
followed by a really corroded
AE3. Again we all took turns
using the detector, noting that
with several additional AE3s
located, the ID reading was
5-8. An anteminiarius of
Gallienus, found later, registered
9 on the ID.
We took out a total of 12
Roman coins from this site.
AE3s were located in soil at
measured depths of 2.5, 3.5
and 5.5 inches with clear sharp
target analysis. It could just be
pure luck but the week before,
five of us were on this same
site (anything Roman at this
time of year gets a visit from
us) and we pulled off a total
of only four AE3s and a cross
section of a brooch. Of course,
it is always a matter luck in
placing the search head directly
over the target, I can’t
deny that, but the Newforce
popped out coins on several
occasions very near to old
excavations and where foot
marks clearly showed the area
had been searched before.
It would appear that Lady
Luck and a good detector
constitute a good marriage.
Woodland was the next
type of land where I decided to
test the Newforce R1. This was
because conditions can be very
variable, and in our area
woods are normally absolutely
contaminated with shotgun
cartridge ends.
The patch of woodland chosen
was no different from this.
Although some reasonable
finds have been made here it
is very contaminated with the
leftovers of many a great
Edwardian - and later - shoot.
I decided this would be
good ground to test the
Learn Reject facility.
After a few minutes I had
found about three cartridge
ends, all from the same manufacturer. In fact, most of the
brass and copper cartridges
found here are of that make.
Sweeping them over the
search head I was delighted to
find that the culprits were now
not recognised by the audio,
although the ID graph still
informs you that a target of
sorts has been detected.
I searched along some paths
and around fallen tree roots
and all was clear. That was
until one of the tree root pans
gave off a clear sharp signal
registering on the ID display.
Digging down about 5ins into
the pan I locateda silver
coin. I dared to hope
that it would be a
hammered, but soon
confirmed that it
was not. It was
a reasonable
condition
25 centimes
coin of
Napoleon
III, dated
1872.
Strangely
enough,
this is
about the
fourth such
coin to be found in this area.
Perhaps the Newforce has
added more evidence to
support that the woodlands
may have played host to a
French guest invited to a shoot
held last century.
I can visualise him swinging
his gun round to claim a jinking
hen pheasant, causing a tightly
tailored pocket to split and
release some coins into the mud.
Hammered coins have been
recovered from this site,
approximately three so I have
been told, but the contamina-
tion is so bad that few
detectorists return after their
first visit.
We look upon this as a curse
to be broken by the R1.
Summary
The unanimous verdict of all
the Pastfinders is that the
results achieved and the clarity
of display information means
that the Newforce is in a
league all of its own. Try as we
might, we had a real problem
finding any fault with this
machine, in any area we tested
it on.
stand. It is also
packed with
handy hints, so that
even the new novice
owner has immediate
access to experienced tips.
The rapid ‘get you going’
instructions are also very useful.
It is unusual these days to find
any particular product made
for our hobby that totally
evades criticism. I am pleased
to announce in our opinion the
Newforce R1 is such a product.
All of the Pastfinders had
great pleasure in field testing
the Newforce R1 and take
further pleasure in producing
a positive report on a really
superb machine. It was a delight
to handle a detector produced
with an ear to detectorists’
comments and past criticism.
The
manual
is com-
prehensive,
and yet easy
to under-
Loading...