Crystal Quest Luxury Shower Power Installation And Operation Manual

Crystal Quest® Luxury Shower Power
INSTALLATION AND OPERATION GUIDE
ONLINE WARRANTY INFORMATION
CrystalQuest.com/warranty.html
Copyright 2018 Crystal Quest All rights reserved MADE IN THE USA
®
COMPONENTS
INSTALLATION INSTRUCTIONS
1. Remove existing shower head from shower arm (pipe) by unscrewing it counterclockwise (do not unscrew shower arm).
2. Install shower lter by turning clockwise onto the shower arm.*
3. Install shower head by turning clockwise onto other side of diverter
valve.*
4. If leaks appear, tighten or reinstall.
OPERATING SPECIFICATIONS:
Pressure Range: 30-60 psi (2.1-4.1 bar)
*DO NOT OVER TIGHTEN OR CROSS THREAD *Thread seal tape may be required.
Temperate Range: 40-110°F (4.4-43.3°C) Optimum Service Flow: 2-4 gpm
BEFORE ENTERING THE SHOWER
1. Activate lter by turning the shower water to “full-hot” for 3-5 minutes to ush media nes from shower lter. Loose media nes in a new cartridge are normal and will be ushed. This could require additional ushings.
2. Cool to the desired temperature before entering shower.
2
WHEN AND HOW TO CHANGE YOUR CARTRIDGE
CARTRIDGE REPLACEMENT
1. Unscrew the shower lter from the shower arm. It may not be necessary to unscrew the complete assembly from the shower arm (Fig 1).
2. Remove the old cartridge and replace with a new cartridge.
3. Make sure both O-rings are properly seated in the O-ring grooves. Apply a small amount of lubricant, such as any non-petroleum oil (do not use coconut oil), to each O-ring (Fig 2).
4. Screw the housing back together (Fig 3).
5. Run hot water for 2-3 minutes to ush media nes from shower lter. Loose media nes in a new cartridge are normal will be ushed out when in use.
MAINTENANCE / CAUTION
Caution: Protect disc from freezing temperatures. If freezing temperatures exist, drain unit
and set wet replacement disk aside to dry. Protect disk from direct sunlight. Not intended for outdoor use.
• Do not use non-Crystal Quest® replacement cartridges.
• Do not use non-Crystal Quest® parts or modify/tamper with unit. Note: O-rings may need to be cleaned and lubricated periodically with any non-petroleum
oil (do not use coconut oil).
PROBLEMS / SOLUTIONS
1. Leaking around threaded connections: Apply thread seal tape to threads
2. Leaking between two housing halves: Check that O-rings are properly seated in grooves and that housing halves are snuggly threaded together. Clean any media nes.
3. Poor water ow or chlorine odor returns: Replace lter cartridge
BACK FLUSHING
1. Unscrew the lter housing.
2. The cartridge can be used inversely. Simply remove the cartridge and reverse it by turning it around.
3. Reassemble the housing as per the instructions.
4. Use as normal.
WHEN TO CHANGE FILTER
Cartridge life (approximate) is 6-12 months.
Cartridge life is directly related to your water
conditions and volume of water ltered. Local water conditions may require more frequent
replacement.
3
ONE-YEAR LIMITED WARRANTY
CRYSTAL QUEST® warrants your CRYSTAL QUEST® Luxury Shower Power System for one year from the date
of purchase against all defects in materials and workmanship when used in compliance with the manual.
CRYSTAL QUEST® disclaims all implied warranties including, without limitation, warranties of merchantability
and tness for a particular purpose. If for any reason the product proves to be defective within one year
from the date of purchase, please call for assistance. This warranty gives you specic legal rights and you
may have other legal rights, which vary from state to state. CRYSTAL QUEST® assumes no responsibility
for incidental or consequential damages; for damages arising out of misuse of the product or the use of
any unauthorized attachment. Some states do not allow the exclusion or limitation of implied warranties or
incidental or consequential damages, so the above limitations or exclusions may not apply to you. Should
service be required during or after the warranty period or should you have any questions regarding how
to use your CRYSTAL QUEST® Luxury Shower Power System, contact our Technical Support department at
warranty@crystalquest.com, Monday through Friday, 9 AM to 5 PM Eastern Standard Time.
KEEP THIS MANUAL FOR FUTURE REFERENCE AND UNIT MAINTENANCE
http://crystalquest.com/warranty.htm
Product design is subject to change without notice.
For further assistance, contact your Crystal Quest dealer
To view the latest edition of the Luxury Power Shower Guide, visit CrystalQuest.com
Please note all drawings, pictures, colors and sizes are approximate for illustrative
purposes only and may not exactly resemble the end product.
Online warranty information
or visit us at www.crystalquest.com
CQE-SP-00800 CQE-SP-00802CQE-SP-00801
4
CQE-SP-00803
CQE-RC-04045
Loading...