Crystal Engineering M1 User Manual

m1

Aordably Accurate

Pressure Gauge

Solid, Dependable Performance

Bright, Backlit Display

Easy to read from a distance, in the dark,

Durable Construction

IP-65 Rated—Dust & splash proof; Shock resistant

circuitry; Hard Polyester/Polycarbonate blend

enclosure & rubber boot (Skydrol compatible)

or in bright sunlight

Long Battery Life

Ideal for hard to reach places—last up to three years, using the

programmable update rate.

CPF Sensor Assembly

316 stainless steel welded sensor—Shifts everyday wear

to a replaceable NPT, M20, or BSP adapter (included)



U.S. Patent No. 8,794,677

Saves MoneyM1

The M1 holds its accuracy for years at a time. Carry

the M1 and use it every day, for up to two years, between
calibrations. Even drops and overpressure won’t hurt it.

And, because the accuracy is high (0.2% of the displayed
pressure) across a very wide range, it’s easy to replace several
test gauges at a much lower cost.

Cost to use conventional gauges for 5 years

*

Cost to use an M1 for 5 years

$$$$

$$$

$$

$

YEAR 1 YEAR 2 YEAR 3

M1 Gauge Cost Conventional Gauge Cost Calibration Cost and Frequency

YEAR 4 YEAR 5

Cumulative Costs: Assumes four conventional gauges that last 5 years.

*

0

4624.D

Crystal Engineering Corporation

708 Fiero Lane, Suite 9, San Luis Obispo, CA 93401, USA

Telephone: [phone] | Fax: [phone]

Dear Test Gauge User,

Tired of carrying a suitcase full of test gauges, just so that you have the right range? Or a gauge that even
works?

Try an M1. One M1 might be able to replace all of your gauges. Because the accuracy of an M1 is 0.2% of the
pressure being indicated, not just of the full scale, one M1 can replace a lot of test gauges.

M1s come calibrated, with traceable certifi cates from an ISO17025 accredited cal lab (ours). It only needs to
be calibrated once every two years (although we don’t know of anyone that has had to adjust an M1— they
really hold their specifi cations).

Besides, it’s much more rugged—dropping it or over pressurizing won’t aff ect the accuracy.

Do your back a favor. Switch to an M1. Leave the suitcase at home…

Sincerely,

 e Crystal Team

Money Saving Tip

Install the M1 as a process gauge anywhere

mechanical gauges don’t do the job.

M1 is ideal for:

Hard to reach locations



lasts 2 years between calibrations

Water hammer



protected from overpressure

Vibration & pulsation



durable, silicon sensor does not wear out

Crystal products include a factory calibration report

that proves it meets its specications over the operating

temperature range. The products described herein, are

calibrated in Crystal’s accredited Calibration Lab (A2LA,

Certicate #2601.01 ISO/IEC 17025) in an environmental

chamber using fully automated equipment. Inclusion of

the ILAC-MRA symbol does not imply certication or ap-

proval of the product itself, but rather refers to Crystal’s

accreditation as a calibration facility.

For detailed specications
go to the Data Sheet at crystalengineering.net/m1

No part of this document may be reproduced or

modied in any form or by any means, electronic

or mechanical, without express written permission

from Crystal Engineering Corporation.

©2014 Crystal Engineering Corporation