Crystal Audiovideo System User Manual
System Series
Operating Instructions
© 2000 Crystal Audio
Table of contents
Information about this manual…………………………………… 2
Connecting the speakers……..…………………………………. 3
Positioning the speakers…………………………………………. 4
Adjusting your amplifier for the System Series Speakers…….. 5
Precautions………………………………………………………… 5
Specifications……………………………………………………… 6
Information about this manual
This instruction manual is referred to the following speaker models:
System 2
System 4
System Dipole 4
System Center 4
System 5
System 6
System Center 6
SystemBass twin 7
System 8
SystemBass 10
SystemBass 12R
Please read this instruction manual before using the System Series Speakers.
2
Connecting the speakers
This section explains how to conect your speakers to your amplifier.
• Before connecting the speakers make sure that your amplifier is turned off.
• Turn off the subwoofer before connecting the input signal cable on its internal
amplifier.
• Connect the plus (+) and minus (-) terminals of each speaker to the corresponding
plus (+) and minus (-) terminals on the amplifier.
• If a biwire type of connection is used (except System 2, System 5 and System
Dipole 4 that have single wire binding posts), the gold plated bridges must be taken
off. Unscrew the binding post’s screws and pull off the two bridges. Tighten the
screws.
• If you use bare speaker wire at the speaker terminals, remove the binding post’s
screw and place the bare wire into the side opening of the terminal. Then tighten the
screw.
• If a banana plug type is used, just push the plug into the binding post’s top hole.
Figure 1 shows a typical system connection of two front speakers, two rear speakers,
one center speaker and one subwoofer on a AV amplifier for 5.1 channel reproduction.
Front Right
AV Amplifier
Subwoofer
LINE IN
Center
Center
Front
Rear
Front Left
R
R
L
L
Rear Right
Subwoofer
Rear Left
Figure 1. Typical connection of 5.1 channel configuration.
3
Loading...