m1
Power On
Zero
Quick Reference
2
sec
Backlight
Power O
sec
sec
1
1
setup
setup
20 PSI, 1.4bar,
>
140 kPa, 1.4kg/cm
2
m1Quick Reference
Note: Pressing the enter button always returns the gauge to operating mode. If you want to set multiple Display Functions,
press the setup button to navigate from one Display Function to the next, then press the enter button when you are done.
Gauge Setup Basics
1 Access Setup
Gauge Setup Map
Maximum, Minimum, or Averaging
1
x
(ashing HI, LO, and AVG icons)
Hi On ( )
Lo On ( )
A On ( )
next
( )
2 View Setup options 3 Select an option
Pressure Units
PSI
mmHg
"Hg
next
( )
mmH2O
"H2O
*
kg/cm
mbar
bar
MPa
kPa
*
2
2
x
( )
( )
enter
next
(Averaging window: 2 to 20 samples)
next
( )
+
1
=
=
t: 68F
t: 60F
All units are not available with every pressure range.
H20 icons and temperature settings will only display on H20 enabled units.
*
next
( )
+
1
=
=
Gauge Setup Map continued
rd 4.0. . . . . . . (1/ 15 seconds . . . 3,000 hours)
rd 2.0. . . . . . . (1/ 30 seconds. . . 6,000 hours)
rd 1.0. . . . . . . (1/ 1 minute . . . . . 10,000 hours)
rd 0.2. . . . . . . (1/ 5 minutes . . . . 25,000 hours)
rd 0.1. . . . . . . (1/ 10 minutes . . . 30,000 hours)
m1Quick Reference
Backlight Timer
next
( )
3
x
Lt: 15 (light stays on for 15 seconds)
Lt: 60 (light stays on for 60 seconds)
Lt: On (light does not turn o automatically)
To Clear Peaks or Line Pressure
1
sec
setup
Troubleshooting
Err 1 displayed:
The M1 checks the internal calibration every time it’s turned on.
Contact factory for further instructions.
Err 2 displayed:
The M1 has tried to display a number too large
for the display due to electrical malfunction or numerical error.
Contact factory for further instructions.
Err 5 or Err 6 displayed:
The M1 pressure sensor is exhibiting behavior out of normal
operating condition. Contact factory for sensor replacement.
Power Management
*
+
This menu can be accessed only when the gauge is o.
*
Ultra Low Power Mode
O - -*. . . . . (4/ 1 second . . . . . 600 hours)
O 1H
At “Power On,” this setting is displayed as No Auto o
*
At “Power On,” this setting is displayed as Auto o 1H
*
*
. . . (4/ 1 second . . . . . 600 hours)
**
Note: Whenever one of the rd settings is selected,
the battery icon will change from to
indicating that the M1 is in Ultra Low Power Mode.
next
( )
+
1
=
=
Note: If there is no gauge activity for 10 seconds, the gauge
will return to operating mode. Any Setup options that you have
selected will be enabled.
crystalengineering.net
4695.F
© 2013 Crystal Engineering Corporation
708 Fiero Lane, Suite 9, San Luis Obispo, California 93401-8701
Loading...