Crystal CRYSTALLITE 15, CRYSTALLITE 20, CRYSTALLITE 25 User Manual [ru]

INSTRUCTIONS OF INSTALLATION, OPERATION

& MAINTENANCE

MODEL

CRYSTALLITE 15, 20 ,25

Freezers & Coolers Industry S.A.

1. INTRODUCTION

Proper installation and maintenance are essential for maximum satisfaction from your appliance. It is therefore

necessary to carefully read and observe the indications of these instructions for use.

2. TRANSPORT (Figure 1)

Always transport the appliance in horizontal position, do not

overturn it and do not load it on leaning position.

UNPACKAGING OF THE APPLIANCE

3.

• Open up the carton and remove the wooden frame from

Photo 3

the upper side of the freezer (Photos 1 & 1A).

• Take off the carton and remove the wooden holds from

the corners.

• Remove the palette by unscrewing the two supporting

screws at the base of the palette (Photo 2).

• Option: In a separate bag inside the cabinet you will

find 4 plastic corners for the plastic bumper, 8 screws
that support these corners and 8 caps that cover the

screws respectively.
You must screw the corners, by using a screwdriver,
inside the existing holes on the metal surface and then
you have to place the plastic caps (Photo 3).

Photo 2

Figure 1

Photo 1

Photo 1A

4. INSTALLATION OF THE APPLIANCE

— Make sure the appliance is stable and in horizontal position.

─ — The freezers are available either with revolving wheels or with supporting legs that enable to adjust the height.

Make sure that the floor surface is not inclined and that it facilitates the appliance’s transport and installation.

─ — Never install the freezer against direct sun light nor in the vicinity of a heat source such as a cooker, a stove,

a heater, a fireplace, etc.

— Avoid installing the appliance in confined rooms, damp, and without airing or in wall recesses.

─ — Make sure that the distance between the wall or other large objects and the back and left side of the appliance is at

least 10 cm. This distance is the minimum required to ensure normal ventilation of the refrigeration mechanism.

5. ELECTRICAL CONNECTION

Make sure that the feed cable and the socket are appropriate for the appliance power. In case of doubt, contact a
qualified technician.
Before inserting the plug in the mains outlet, make sure the voltage mentioned on the nameplate on the back side
of the appliance, complies with the one of your network. A discrepancy of +/- 10% is acceptable.
Too high or too low voltage network may seriously damage the compressor. Such damages are not covered by the
guarantee. The appliance must be earthed as prescribed by the relevant legislation whereas it is indispensable for your
personal safety. The manufacturer has provided for earthing in the electrical installation and external surface of the
appliance.

NOTE: Upon start up, running may be noisy. Noise will only last for the engine “running in” time and will
dim progressively.

2