CryptOn CCP700-B-EN560, CCP700-C-EN560 User Manual

Installing HP Windows 10 PC

CCP700-B-EN560 & CCP700-C-EN560

I323845

– PC Configuration Instructions

Please take a few moments to read these instructions.

The process of installing the PC is split into stages. Dependant on if you have Bluetooth (Wireless) or
a cabled unit, the process is different, so please select the correct guidance section.

If your brake tester is connected to your CCP700, ensure
you have the installation discs or a copy of the transfer
process and a USB/serial adaptor before proceeding.

There are 5 stages to the swap over process:

1. Pre install checks

2. Remove existing PC

3. Install new pc and connect

4. Configure Gas Analyser, Smoke Meter,

Temperature Probe and Tachometer

5. Input Garage Details

Pre install Check

On the current system, are the Smokemeter, Gas analyser, Temperature probe and Tacho operating
correctly? If not contact, your service agent before proceeding with the PC change over.
Record Braketester Version (if fitted)

Remove Existing PC

 Close down all applications and power off
 Remove the rear Panel of the Trolley
 Remove all plugs and lift the PC out through access below keyboard

(The PC is held in place with Velcro)

 Remove the keyboard and mouse

Install New PC and Connect

Windows 10 requires a connection to the internet to activate the operating system and download
drivers for your printer. This is achieved by connecting the PC to your network via a cabled or a
wireless dongle connection.

Important Note for Brake Tester
Installations

From the front screen of your
current Brake test program, make a
note of the version number of the
Brake tester program. This may be
needed later during the install
process of your new PC.

Once activated, your PC does not need to remain connected to the internet. However, internet
connection is recommended for support.

 Make sure the PC is turned off
 Install the new PC into the cabinet and carefully reconnect the cables for monitor, keyboard and

mouse

 Plug the Bluetooth dongle into one of the USB ports on the front of the PC.

The dongle must stay in the first USB port it is plugged in to.

(Note, some models of the Laird dongle and certain Belkin devices are not compatible with Win 10)
These will require to be replaced.

 Plug in the power cable
 Turn on your new PC
 Turn on the Gas analyser and Smokemeter

1 = Keyboard
2 = Mouse
3 = Printer
4 = Gas Analyser
5 = Tach
6 = Temp

1 2 3

4

5

6

680 Gas Analyser Configuration

1) Open “Control Panel”

2) Open “Hardware and Sound” and then “Device Manager”