Cryopak XTAGDISPLAY Users Manual

11,000 PARKWAY BLVD

ANJOU, QUEBEC

H1J 1R6

(T) 514.324.4720

888.423.7251

(F) 514.324.4720

CRYOPAK.COM

NEW JERSEY • MINNESOTA • CALIFORNIA • ARKANSAS • VANCOUVER • MONTREAL • FRANCE

User guide, configuration and usage:

1. Power up the xTagDisplay with a USB cable or external apdater(9-24VDC)

2. For wired sensors, as per the 1-wire communication protocol, attach the sensor via the RJ12 or 6 pins

connector and observe temperature readings on the xTagDisplay’s screen.

3. For RF sensors, xTag2, Press and hold the two buttons on the xTag2 until it switches on.

Once communication established, xTag2 will show data readings on xTagDisplay’s screen.

FCC

This equipment has been tested and found to comply with limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with instructions, may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

• Consult the dealer or an experienced radio/TV technician for help.

To assure continued compliance, any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to
operate this equipment.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
FCC Radiation Exposure Statement: This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled environment. This transmitter
must not be co-located or operating in conjunction with any other antenna or transmitter.

Canada:

This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and
(2) this device must accept any interference, including interference that may cause undesired operation of the device.