Crux VIMLR-88 User Manual

INTERFACING SOLUTIONS

VIMLR-88

VERSION 1:

2005 - 2009 Land Rover Discovery (L319)
2005 - 2009 Range Rover Sport (L320)
2005 - 2009 Range Rover Vogue (L322)

VERSION 2:

2010 - 2011 Land Rover Discovery (L319)
2010 - 2011 Range Rover Sport (L320)
2010 - 2012 Range Rover Vogue L322)

Rev. 051413

VIDEO IN-MOTION ACTIVATION FOR LAND ROVER w/TOUCH-SCREEN NAV SYSTEMS V1 AND V2

We recommend reading this installation guide rst before starting any

work. Following these instructions from “Start” to” Finish” will ensure

a smooth and hassle free installation. We oer telephone support M-F
9:00 AM – 5:00PM PDT at 1 [phone]. We are here to help.

PARTS INCLUDED:

(1) LR-88 Interface
(1) LR-88 Harness
(1) Instruction

PRECAUTIONS:

- Remove the negative side of the battery to avoid any short circuits

durring the installation.

- Do not install the interface near any major components or near the

HVAC system. This may cause damage or overheating to the vehicle.

- Do not disconnect the airbag connection behind the radio panel.

PRELIMINARY:

Please read the entire mannual before installing this interface.

Vehicle must be equipped with factory DVD changer.

This interface does not activate DVD reader.

INSTALLATION OVERVIEW

20-PIN

(male plug)

GREEN/ VDO UNLOCK

WHITE/ 12V OUTPUT

Important Note:

This interface only supports the
following radio types:

-Touch-Screen navigation Version 1 &
Version 2.

THIS INTERFACE IS DESIGNED TO ACTIVATE

SAFETY WARNING:

VIDEO IN-MOTION TO ALLOW THE PASSENER
ACCESS TO THE ADDRESS INPUT WHILE THE

VEHICLE IS IN-MOTION. THIS INTERFACE MAY

CAUSE AN ERROR WHEN SERVICED AT THE
OEM DEALER. BE AWARE THAT MOST DEALERS
WILL ATTEMPT TO VOID THE MANUFACTURERS

WARANTY WHEN INSTALLING ANY AFTER-

MARKET EQUIPMENT. IMPROPER USE OF THIS

INTERFACE BY THE DRIVER MAY RESULT IN

CITATION. DRIVER MUST KEEP FULL ATTENTION

ON THE ROAD AND RESPOSIBILITY ON THE

SAFETY OF HIS PASSENGERS.

INSTALLING THE INTERFACE:

1. Remove the factory radio to gain access to the factory connectors.

2. Make the T-Harness connections behind the factory radio.

(if the connectors do not match please contact tech support)

3. Test and make sure the Reverse gear triggers the interface and
also test the video in-motion while the car is rolling.

(Navigation address input should be active while rolling)

4. Make all other connections before re-installing the factory

radio.

NON-PERMANENT VIDEO IN-MOTION:

If the customer wants the option to deactivate the video in-motion.

The installer can use the GREEN wire instead of the dip switch setting
to activate and deactivate the video in-motion.

This way the user can have access to the wire without having to get

behind the radio if eanting to deactivate.

TO ENABLE VIDEO

IN-MOTION

ON

1 2 3

4 5 6

1. On = Enable

2. Used

3. Not Used

4. Not Used

5. ON

6. ON

TO FACTORY
HARNESS

DIP SWITCH NUMBER 2 SETTING:

The interface works with vehicles with and without the factory rear-view

camera. Depending on the vehicle type you have, dip switch number 2
must be on “ON” or “OFF”

DIP SWICTHES:

FACTORY CAMERA

NO FACTORY CAMERA

2

ON
OFF

INTERFACE

20-PIN

(female plug)

TROUBLE SHOOTING

1. No video display while driving.

- Make sure the dip swithces are in the proper location.

8-PIN

(male plug)