Page 1
- Retains factory features in select Toyota vehicles while functioning with an aftermarket
radio.
- Pre-programmed to retain factory Steering Wheel Controls.
- iPhone Voice Recognition (VR) feature from SWC on select radios.
- Supports BT-HF/A2DP/AVRCP profile on select aftermarket radio models.
- Supports Pick Up/End Call, Pick up and Toggle between 1st and 2
nd
incoming call, AVRCP
Track, Seek.
- Retains factory AUX Input.
- EIA color coded wiring for easy installation.
TY-61S Interface Module
TY-61S T-Harness
3.5MM to 4-pin SWC Cables
PRECAUTIONS:
1. Remove the negative battery terminal to avoid any short circuits during installation.
2. Do not install the interface near any major components or near the HVAC system. This may cause
damage or overheating to the vehicle.
Rev.022817
1/4
TOYOTA
2003 - 2013 4Runner
2005 - 2011 Avalon
2007 - 2011 Camry
2004 - 2008 Camry Solara
2007 - 2011 FJ Cruiser
2008 - 2012 Highlander
2006 - 2011 RAV4
2003 - 2011 Sequoia
2004 - 2011 Sienna
2005 - 2012 Tacoma
2003 - 2013 Tundra
2009 - 2011 Venza
Page 2
SETTING THE AFTERMARKET RADIO BRAND
This step is done on the TY-61S SWC Module. With the key in the off position, set the DIP switches to the
corresponding radio listed below.
4-PIN SWC CABLE
The TY-61S SWC Module allows for both types of connections:
OPTION A is used for ALPINE, CLARION, JVC, and KENWOOD units (Blue/Yellow wire is attached)
OPTION B is used for BOSS, DUAL, FAHRENHEIT, JENSEN, POWER ACOUSTIK, PIONEER, SONY and
SOUND STREAM units.
NOTE: Cap or insulate the 3.5mm plug or Blue/Yellow wire if not being used.
SETTING THE TOYOTA SWC
Rev.022817
2 / 4
Page 3
STEERING WHEEL CONTROL BUTTON FUNCTIONS
SWC Button
SHORT PRESS
LONG PRESS
PIONEER
VOL +
VOL Seek Up
Seek Down
Mode
OFF Hook
ON Hook
Voice
*NOTE:
Step Increment
Step Decrement
Preset Up
Preset Down
Source
Pick Up Call*
End Call / Ignore Call
Activate VR/Deactivate VR
BT Mode Active:
OFF Hook = Toggle between
1st and 2nd Call
Continuous VOL +
Continuous VOL -
Seek Up
Seek Down
Power On/Off
None
None
None
SWC Button
SHORT PRESS
LONG PRESS
ALPINE
VOL +
VOL Seek Up
Seek Down
Mode
OFF Hook
ON Hook
Voice
*NOTE:
Step Increment
Step Decrement
Seek Up
Seek Down
Source
Pick Up Call
End Call
Activate VR*/Deactivate VR*
BT Mode Active:
OFF Hook = Toggle between
1st and 2nd Call
Continuous VOL +
Continuous VOL –
None
None
None
None
None
N/A
SWC Button
SHORT PRESS
LONG PRESS
CLARION
VOL +
VOL Seek Up
Seek Down
Mode
OFF Hook
ON Hook
Voice
*NOTE:
Step Increment
Step Decrement
Preset Up
Preset Down
Source
Pick Up Call*
End Call
Mute
BT Mode Active:
OFF Hook = Toggle between
1st and 2nd Call
Continuous VOL +
Continuous VOL –
Seek Up
Seek Down
Power On/Off
None
None
None
Rev.022817
3 / 4
Page 4
SWC Button
SHORT PRESS
LONG PRESS
JVC
VOL +
VOL Seek Up
Seek Down
Mode
OFF Hook
ON Hook
Voice
*NOTE:
Step Increment
Step Decrement
Seek Up
Seek Down
Source
Pick Up Call*
End Call
Activate VR
BT Mode Active:
User must End 1st call in
order to pick up 2nd
incoming call.
Continuous VOL +
Continuous VOL –
M-Seek Up
M-Seek Down
None
None
None
None
Deactivate VR:
Say “Cancel“ or remain silent
until it times out Auto
switch back to previous Source.
SWC Button
SHORT PRESS
LONG PRESS
KENWOOD
VOL +
VOL Seek Up
Seek Down
Mode
OFF Hook
ON Hook
Voice
Step Increment
Step Decrement
Seek Up
Seek Down
Source
Pick Up Call/
Call History On/Off
End Call / Deactivate VR
Activate VR
Continuous VOL +
Continuous VOL -
None
None
None
None
None
None
None
Rev.022817
4 / 4
Loading...