Crux SWRTY-61N User Manual
Crux Interfacing Solutions • 6860 Canby Ave., Suite 104, Reseda, CA 91335
phone: (818) 609-9299 • fax: (818) 996-8188 • www.cruxinterfacing.com
SWRTY-61N
RADIO REPLACEMENT
SWC RETENTION
+
R
INTERFACING SOLUTIONS
PRODUCT FEATURES:
PARTS INCLUDED:
INSTALLATION DIAGRAM:
Radio Replacement with Steering Wheel Retention and
Rear-View Camera Retention for TOYOTA Vehicles
- Retains factory features in select Toyota vehicles while functioning with an aftermarket radio.
- Pre-programmed to retain factory Steering Wheel Controls.
- iPhone Voice Recognition (VR) feature from SWC on select radios.
- Retains OE Rear View Camera.
- Supports BT-HF/A2DP/AVRCP prole on select aftermarket radio models.
- Supports Pick Up/End Call, Pick up and Toggle between 1st and 2nd incoming call, AVRCP Track, Seek.
- EIA color coded wiring for easy installation.
SWRTY-61N MODULE SWRTY-61N HARNESS USB Retenon Cable SWC CABLES
+12V Constant Yellow
+12V ACC Red
Ground Black
Illumination Orange
SWC for Kenwood/JVC Blue/Yellow
Vehicle Speed Sense (VSS) Red/Black
Parking Brake
TO FACTORY
HARNESS
Not Used
Right Front (+) Gray
Right Front (-) Gray/Black
Left Front (+) White
Left Front (-) White/Black
Right Rear (+) Violet
Right Rear (-) Violet/Black
Left Rear (+) Green
Left Rear (-) Green/Black
Reverse Trigger Red/White
(see special note below) Yellow/Black
Power Antenna Blue
Audio Input
(Retains Factory AUX Input
in Select 2007-Up Vehicles)
24 PIN
28 PIN
10 PIN
6 PIN
Blue/ White
Red/White RCA
12-Pin Black
Connector
Blue / Antenna Turn On
AFTERMARKET
RADIO
Yellow RCA
(Retain OE Camera)
Rear View Camera Signal
SWRTY-61N
MODULE
1 2 3 4 5 6 7 8
AFTERMARKET
RADIO SELECTOR
(See Chart)
Plug in the 3.5MM SWC cable to the 4-pin port
on the module. See “DIP SWITCH SETTINGS” section.
Cap or insulate if
ON RADIO VEHICLE
not being used
Kenwood/JVC (BLUE / YELLOW)
SWC 3.5MM PLUG ADAPTER
USB-TY01
USB Retention Adaptor
(included in kit)
TOY OTA
SWC SETTING
(OFF ON OFF ON)
ON RADIO VEHICLE
1 2 3 4 5 6 7 8
3.5MM SWC CABLE
LIN BUS (Green)
Insulate with tape
if not being used
ANTENNA ADAPTOR
(Included in Kit)
Blue / Antenna Turn On
NOTE:
The BLUE Antenna Turn-On wire
should ONLY be connected to
one circuit of the aftermarket
radio. Choose the one which has
a wire populated on the factory
connector side.
1 of 3
rev.111318
Crux Interfacing Solutions • 6860 Canby Ave., Suite 104, Reseda, CA 91335
phone: (818) 609-9299 • fax: (818) 996-8188 • www.cruxinterfacing.com
RADIO REPLACEMENT
SWC RETENTION
+
R
INTERFACING SOLUTIONS
SWRTY-61N
DIP SWITCH SETTINGS:
SPECIAL NOTE:
Radio Replacement with Steering Wheel Retention and
Rear-View Camera Retention for TOYOTA Vehicles
On 2013 Toyota Sequoia and Tundra, the parking brake wire (RED wire) is in posion#1 on the OEM 28-pin connector. Please
insert the YELLOW/BLACK wire on the SWRTY-61N harness into posion#1. For all other models, please insert into posion# 15.
Please check that you are inserng the pin into the correct locaon as it is dicult to remove it again. The locking tab of the pin
should be facing UP when it is inserted into the connector.
For 2013 Sequoia & Tundra
Pin#1
Pin#15
For all other models
TOYOTA STEERING WHEEL CONTROL DIP SWITCH SETTING:
DIP: 5 6 7 8
Toyota
OFF ON OFF ON
AFTERMARKET RADIO DIP SWITCH SETTINGS:
RADIO BRAND: DIP: 1 2 3 4
Dual, Fahrenheit, Jensen, Pioneer
Power Acoustik, Soundstream
Alpine
Clarion
Kenwood
JVC
Boss, Old Sony
New Sony
OFF OFF ON ON
OFF OFF ON ON
OFF OFF OFF OFF
OFF ON ON OFF
OFF ON ON ON
OFF ON OFF ON
OFF ON OFF OFF
OFF OFF ON OFF
SWRTY-61N
28-Pin Connector
(wire view)
SWC MODULE
ON RADIO VEHICLE
1 2 3 4 5 6 7 8
SWC MODULE
ON RADIO VEHICLE
1 2 3 4 5 6 7 8
3.5MM SWC CABLE
Plug in the 3.5MM to 4-Pin SWC cable to the SWC module.
NOTE: Insulate the Blue/Yellow and Green wires if not being used.
SWC 3.5MM PLUG ADAPTER:
Use the supplied 3.5MM SWC Plug adapter for aermarket radios that do not have a 3.5mm SWC jack.
OPTION B
(included in kit)
2 of 3
RED to SWC Key 1
WHITE to SWC Key 2
SHIELD to SWC Ground
rev.111318
Loading...