Crux SWRFD-60L User Manual

- Retains factory features in select FORD, LINCOLN, and MERCURY vehicles while

functioning with an aftermarket radio.

- Pre-programmed to retain factory Steering Wheel Controls.

- iPhone Voice Recognition (VR) feature from SWC on select Kenwood, Pioneer, Alpine

and JVC radios.

- Retains factory Aux-Input and Subwoofer (if equipped).

- EIA color coded wiring for easy installation.

FD-60L

Analog Module

Rev.092017

FD-60L

T-Harness

4-Pin SWC

Cables

Antenna Adaptor

1 / 4

1. Only supports analog Steering Wheel Control type.

2. Use part number SWRFD-60 for CAN Bus Steering Wheel Control.

3. Output signal stated above may not cover all Year/Model.

4. Does not retain SYNC.

5. Not compatible with factory-installed Sony systems and THX systems with amplifier.

HOW TO DETERMINE IF THE VEHICLE IS ANALOG

Analog Steering Wheel Control (SWC) signal, vehicles will have wires populated and line up to PINK and BLACK wire on the 24-Pin Crux connector.

SETTING THE AFTERMARKET RADIO BRAND

This step is done on the SWC Module. With the key in the off position, set the DIP switches to the corresponding radio listed below.

4-PIN SWC CABLE

Use the proper 3.5MM to 4-Pin SWC cable for the aftermarket radio you are using.

OPTION A is used for ALPINE, CLARION, (JVC and KENWOOD units will use the Blue/Yellow wire). OPTION B is used for BOSS, DUAL, FAHRENHEIT, JENSEN, POWER ACOUSTIK, PIONEER, SONY and

SOUNDSTREAM units.

NOTE: Cap or insulate the 3.5mm plug or Blue/Yellow wire if not being used.

Rev.092017

2 / 4

+ 2 hidden pages