
- Retains factory features in select GM Class II Data Bus vehicles while functioning with an
aftermarket radio.
- Supports Bose, Monsoon, Y-91 audio and non-amplified audio systems.
- Retains chime functions.
- Built-in chime volume adjustment.
- EIA color coded wiring for easy installation.
1. The Front and Rear fading are not retained on Y-91 Bose System.
2. Chime includes: seat belt, check engine, key in ignition, low fuel, low oil and lights on.
SOCGM-17C Harness (GM-C2)

If the vehicle is equipped with an amplified audio system, the SOCGM-17C has a built-in audio
level adaptor that outputs the proper audio level from the aftermarket radio to the factory
amplifier. To use this feature, plug in the male 8-pin connector on the GM-17C harness to the
GRAY female 8-pin connector on the GM-17C module. The module is also labeled “Bose” and
“Non Bose” to avoid confusion. (see picture below)
If the vehicle is NOT equipped with a factory amplified system, plug in the male 8-pin connector
to the BLACK female 8-pin on the GM-17C module.
The SOCGM-17C has a potentiometer to adjust the chime volume. It is set at half way by
default. To adjust the volume, simply use a suitable screw driver and turn the potentiometer
clockwise to increase the volume and counter-clockwise to decrease the volume.
BOSE
(Amplified)
Connection
Non-BOSE
(Non-Amplified)
Connection

NOTE:
There are instances on the Corvette when the chime will sound when either the “Traction Control”
or the “DIC” (Driver Information Center) buttons are pressed.
Traction Control Button Driver Information Center Buttons