Crown Verity CV-PHS Installation Manual

CV-PHS

PORTABLE HAND-WASH SINK

QUICK-START INSTRUCTI ONS

DO NOT CONNECT WATER HEATER TO ELECTRICITY UNLESS IT IS
FULL OF WATER!!!

START-UP:

Fill the fresh water tanks with cold, potable water and insert the siphon (intake)
hose from the pump into one of the fresh water tanks. Make sure the hose is all the way to
the bottom of the tank. Make sure the drain hose(s) are inserted into the waste water tank.

Plug the long power cord into a dedicated electrical outlet. Connect the water pump
cord to the electrical outlet inside the cart ; the pu mp will run. Open the cold water fauce t
until water flows free with
empty).

OPERATION:

When the faucets are turned off the pump will automatically shut off and turn back
on when the faucet(s) are opened,
this, simply run more water until the air bubbles are out. NOTE: when the fresh water
tank is empty, the pump will drain air bubbles into the system, and the fresh water tank
must be exchanged or refilled. Disconnect the pump from the electrical outlet until the
fresh water tank can be exchanged or refilled.

• Do not let the pump run dry for more than 2 minutes; damage to the pump my

result.

• Do not let the waste water tank overflow. Dispose of waste water in a sanitary drain

only.

• Drain hoses must be inserted into the waste water tanks at all times (unless

connected to a sanitary drain).

• You can connect the sink cart to direct city water supply via the garden hose

coupling located immediately downstream of the pump outlet.

• The sink drain(s) may be connected to a sanitary drain via the garden hose fittings

located directly below each sink bowl.

• NO POWER?? Check the reset button on the GFCI electrical outlet located in the

cart.

no air bubbles

unless there are air bubbles

(this may take a minute if the heater is

in the water lines. To correct