Crown CEAS-1, CEAS-2 Owners manual

Optional Output Connectors for CE Series Amplifiers

Installation Guide (CEAS1/CEAS2)

page 1 of 2

OUTPUT CONNECTOR

CE Series Amplifier with Optional Output Connector Installed

TOOLS REQUIRED:

Torx #T-15 screwdriver

INCLUDES:

2 - #8 x 1¼ in. screws

• CE optional output connector

WARNING: CEAS1 AND CEAS2 OPTIONAL OUTPUT
CONNECTORS MUST BE INSTALLED BY A QUALIFIED
SERVICE CENTER.

Follow the installation instructions provided on the next
page to install your CE Optional Output Connector. Once
installed, your CE amplifier will offer barrier block or 5-way
binding post output connectors (depending on the kit
ordered).

Note that installing the optional output connectors does
NOT defeat the Neutrik® Speakon connectors on the back
panel of the amplifier. If, at any time, you prefer to use the
standard Neutrik® Speakon® output connectors, it is not

necessary to remove the optional output connector panel
from the amplifier. Instead, simply connect your speaker

wires to the Speakon® output connectors instead of the
optional output connectors.

PART # CEAS1

CE Series Amplifier Barrier Strip

Output Connectors

PART # CEAS2

CE Series Amplifier 5-Way Binding Post

Output Connectors

P.O. Box 1000 Elkhart, IN 46515 Phone: [phone] Fax: [phone]
Web Page: http://www.crownaudio.com

128271-1

10/99

Optional Output Connectors for CE Series Amplifiers

Installation Guide (CEAS1/CEAS2).

page 2 of 2

CE Series Optional Output Connector Wire Locations

INSTRUCTIONS:

1. Turn down level controls.

2. Turn off amp.

3. Unplug power cord.

4. Remove the four T-15 torx-head screws from the top cover, and retain screws.
Remove top cover.

5. Remove the two T-15 torx-head screws from the rectangular cover plate on the
back panel, and retain screws. Remove cover plate and discard.

6. Install CEAS1/CEAS2 in back panel opening and affix with cover-plate screws.

7. Attach wires to main PWA as follows (refer to the illustration above):

Red wire to relay K100 “ON” terminal (location A).
Orange wire to relay K200 “ON” terminal (location B).
Black wire to WP7 lug (location C).

8. Reinstall top cover.

9. Connect wires to new output panel.

10. Plug in power cord.

11. Turn on amp.

12. Turn up the level controls to desired volume.

P.O. Box 1000 Elkhart, IN 46515 Phone: [phone] Fax: [phone]
Web Page: http://www.crownaudio.com