Crosslee PLC TUMBLE DRYER, CL.001S Instructions For Use Manual

INSTRUCTIONS FOR USE

TUMBLE DRYER

IMPORTANT

PLEASE READ THESE INSTRUCTIONS THOROUGHLY BEFORE USING THIS APPLIANCE.
KEEP THEM IN A SAFE PLACE FOR FUTURE REFERENCE.

INSTALLATION

Position the tumble dryer so that the plug remains accessible after installation. Do not block the vent at
the side or base of the dryer, as this will impair the working of the machine. This appliance must not be
installed behind a lockable door, a sliding door or a door with hinges on the opposite side to that of the
tumble dryer.

TUMBLE DRYER VENTING

When using a vent hose, remember the following points:
The vent hose must be at least 10cm (4 ins) in diameter.
No more than three right-angled bends should be allowed when positioning the vent hose.
Do not distort or constrict the vent hose as this will reduce the airflow.
When drying, the vent hose must always be extended to an open door or window.
The vent hose must not be shared with other appliances, for example, a cooker hood outlet.
Note: Do not obstruct or add a mesh to the vent hose outlet during use and ensure that it cannot be
blocked or bent sharply which may obstruct the airflow.
It is recommended that the interior of the hose be periodically inspected and cleaned if necessary.

Your tumble dryer may be supplied with a vent hose (If not, one is
available as an accessory).
A vent hose allows you to direct the warm, damp air expelled from the rear
of the dryer to an open door or window.
One end of the vent hose is fitted with an adaptor which can be pushed into
the exhaust outlet at the bottom left hand corner at the rear of the tumble
dryer (see fig.)The free end should be led to a suitable outlet. It may be
simply hung through an open window or a more permanent connection
made using the four holes in the adaptor flanges.
The best solution is to make a permanent connection through either a wall
or a window. This is particularly recommended for small, cool rooms and a
kit for this purpose is available as an accessory.

FINAL INSTALLATION

Push the filter into its operating position as shown in
the diagram. Remove any dust by wiping the drum
and door with a damp cloth. Any initial smell of
burning will be caused by dust on the heater and will
quickly disappear.

THE CONTROLS

A. THE TIMER

Select the required drying time based on the recommendations on the control panel.

B. HEAT SWITCH Select the required heat setting based on the recommendations on the control

panel.

PREPARATION

Check care labels inside the garments.

CARE LABELS YOU MAY FIND ON YOUR FABRICS

Do not tumble dry woollen or wool mixture articles unless the article is labelled as being suitable .This
should avoid shrinkage.
Place delicate articles, e.g.tights, scarves, inside a pillowcase.
To avoid the need to iron easycare polyester/cotton items it is better to only dry small loads (i.e. half fill
drum) It is better to dry small and large articles together.