Crosley Radio CR32 User Manual

WARNING:

TO PREVENT FIRE OR SHOCK HAZARD, DO NOT EXPOSE THIS APPLIANCE TO RAIN
OR MOISTURE. DO NOT REMOVE COVER. PILOT LAMPS SOLDERED IN PLACE. NO
USER SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE
PERSONNEL.

CAUTION

RISK OF ELECTRIC SHOCK

DO NOT OPEN

CAUTION:

TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE
COVER (OR BACK). NO USER - SERVICEABLE PARTS INSIDE. REFER
SERVICING TO QUALIFIED SERVICE PERSONNEL.

The lighting flash with arrowhead symbol, within an equilateral
triangle, is intended to alert user to the presence of uninsulated
"dangerous voltage" within the product's enclosure that may be
of sufficient magnitude to constitute risk of electric shock to
persons.

The exclamation point within an equilateral triangle is intended
to alert user to the presence of important operating and
maintenance (servicing) instruction in the literature accompanying
the appliance.

SPECIFICATION

FREQUENCY RANGE : FM 87.5 - 108.5 MHz
POWER CONSUMPTION : 10W

POWER SOURCE : AC 120V ~ 60Hz
ANTENNAS : External antenna for FM

SPEAKER : 4”DYNAMIC TYPE

• DESIGN AND SPECIFICATION SUBJECT TO
CHANGE WITHOUT NOTICE.

: AM 525 - 1710 KHz

: Built-in ferrite bar for AM

CR32

Cathedral Radio

Instruction Manual

910-031800-029

IMPORTANT SAFETY

INSTRUCTION

PLEASE READ CAREFULLY ALL THE FOLLOWING IMPORTANT

1. Read Instructions - All the safety and operating instructions should be read

2. Retain instructions - The safety and operating instructions should be retained

3. Heed Warnings - All warnings on the product and in the operating Instructions

4. Follow Instructions - All operating and use instructions should be followed.

5. Cleaning - Unplug this product from the wall outlet before cleaning. Do not use

6. Attachments - Do not use attachments not recommended by the product

7. Water and Moisture - Do not use this product near water - for example, near a

8. A product and cart combination should be moved with care. Quick stops, excessive

9. Ventilation - Slots and openings in the cabinet are

10. Power Sources - This product should be operated only from the type of power

11. Grounding or Polarization - This product may be equipped with a polarized

12. Power - Cord Protection - Power - supply cords

13. Lightning - For added protection for this product during a lightning storm, or

THAT ARE APPLICABLE TO YOUR EQUIPMENT

before the product is operated.
for future reference.
should be adhered to.

liquid cleaners or aerosol cleaners. Use a damp cloth for cleaning.
manufacturer as they may cause hazards.
bath tub, wash bowl, kitchen sink, or laundry tub; in a wet basement; or near

a swimming pool; and the like.
force, and uneven surfaces may cause the product and cart

combination to overturn.
provided for ventilation and to ensure reliable operation

of the product and to protect it from overheating, and
these openings must not be blocked or covered, The
openings should never be blocked by placing the product
on a bed, sofa, rug, or other similar surface. This product
should not be placed in a built - in installation such as a
bookcase or rack unless proper ventilation is provided or
the manufacturer's instructions have been adhered to.

source indicated on the marking label, if you are not sure of the type of power
supply to your home. Consult your product dealer or local power company. For
products intended to operate from battery power, or other sources, refer to the
operating instructions.

alternating-current line plug (a plug having one blade wider than the other). This
plug will fit into the power outlet only one way. This is a safety feature. If you are
unable to insert the plug fully into the outlet try reversing the
plug, If the plug should still fail to fit, contact your
electrician to replace your obsolete outlet. Do
not defeat the safety purpose of the polarized plug.

should be routed so that they are not likely to be
walked on or pinched by items placed upon or against them, paying particular
attention to cords at plugs, convenience receptacles, and the point where they
exit from the product.

when it is left unattended and unused for long periods of time, unplug it from
the wall outlet and disconnect the antenna or cable system. This will prevent
damage to the product due to lightning and power - line surges.

SAFEGUARDS

AC

Polarized Plug

14. Power Lines - An outside antenna system should not be located in the vicinity
of overhead power lines or other electric light or power circuits, or where it can
fall into such power lines or circuits. When installing an outside antenna system,
extreme care should be taken to keep from touching such power lines or circuits
as contact with them might be fatal.

15. Overloading - Do not overload wall outlets, extension cords, or integral convenience
receptacles as this can result in a risk of fire or electric shock.

16. Object and Liquid Entry - Never push objects of any kind into this product through
openings as they may touch dangerous voltage points or short - out parts that
could result in a fire or electric shock. Never spill liquid of any kind on the product.

17. Servicing - Do not attempt to service this product yourself as opening or removing
covers may expose you to dangerous voltage or other hazards. Refer all servicing
to qualified service personnel.

18. Damage Requiring Service - Unplug this product from the wall outlet and refer
servicing to qualified service personnel under the following conditions;
a. When the power-supply cord or plug is damaged.
b. If liquid has been spilled, or objects have fallen into the product.
c. If the product has been exposed to rain or water.
d. If the product does not operate normally by following the operating instructions.

Adjust only those controls that are covered by the operating instructions as
an improper adjustment of other controls may result in damage and will often
require extensive work by a qualified technician to restore the product to its

normal operation.
e. If the product has been dropped or damaged in any way.
f. When the product exhibits a distinct change in performance - this indicates

a need for service.

19. Replacement Parts - When replacement parts are required, be sure the service
technician has used replacement parts specified by the manufacturer or have
the same characteristics as the original part. Unauthorized substitutions may
result in fire, electric shock, or other hazards.

20. Safety Check - Upon completion of any service or repairs to this product, ask
the service technician to perform safety checks to determine that the product
is in proper operating condition.

21. Wall or ceiling Mounting - The product should be mounted to a wall or ceiling
only as recommended by the manufacturer.

22. Heat - The product should be situated away from heat sources such as radiators.
Heat registers, stoves, or other products(including amplifiers) that produce heat.

WARNING: Changes or modifications to this unit not expressly approved by the party
responsible for compliance could void the user’s authority to operate the equipment.

NOTE: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not occur
in a particular installation. If this equipment does cause harmful intereference to radio
or television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following
measures:

- Reorient or relocate the receiving antenna.

- Increase the separation between the equipment and receiver.

- Connect the equipment into an circuit different from that to which the receiver
is connected.

- Consult the dealer or an experienced radio TV technician for help.

POWER SOURCE

Unwind the AC power cord at the back of the unit and connect it to a power
outlet.

RADIO OPERATION

1. Turn the unit ON by turning the ON-OFF SWITCH/VOLUME
CONTROL (4) clockwise to the ON position.

2. Select the desired waveband by turning the BAND selector (6) to
either the AM or FM position.

3. Turn the TUNING KNOB (3) to select the desired station on the Tuner
Dial (2).

4. Adjust the volume to the desired listening level by turning the ON-OFF
SWITCH/VOLUME CONTROL (4).

5. Turn the unit off by turning the ON-OFF SWITCH/VOLUME CONTROL
(4) counterclockwise to the off position.

EXTERNAL ANTENNA

The unit is provided with a wire antenna for FM reception. Move the wire until
the reception is clear . Do not connect the FM antenna to any external antenna.
Am reception would be improved by relocating the unit.

CASSETTE OPERATION

1. Turn the ON-OFF/VOLUME switch (4) to the ON position.

2. Insert a pre-recorded cassette tape into the tape slot with the exposed side
of the cassette facing towards the back of the radio. The cassette will slide
into the mechanism and will automatically begin to play.

3. Adjust the volume to the desired listening level by turning the ON-OFF
SWITCH/VOLUME CONTROL (4).

4. The cassette can be advanced in the fast forward mode, by depressing
the EJECT/F.F. button (9) half-way in. Pushing the EJECT/F.F. button (9)
again will stop the fast forward mode and return the tape mechanism to
the play mode. To eject the cassette, push the EJECT/F.F. BUTTON (9) all
the way in until the cassette ejects.

POLARIZED ELECTRICAL PLUG
INSTRUCTIONS

This product is equipped with a polarized alternating current line plug (a
plug having one blade wider than the other). This plug will fit into the
power outlet only one way. This is a safety feature, If you are unable to
insert the plug fully into the outlet, try reversing the plug. If the plug should
still fail to fit, contact an electrician to replace your obsolete outlet. Do not
defeat the purpose of the polarized plug.

TROUBLESHOOTING GUIDE

The unit is not functioning
* The AC power cord is not connected to a power outlet.
* The unit is not turned on : rotate the VOLUME knob from the OFF

position past the “click’’ to turn on the unit.
No radio
* Make sure the volume is turned up
* Rotate the tuning knob to find a station
* Make sure a cassette is not pushed in the cassette player. The radio will

not work if a cassette is fully inserted.
No cassette playback
* The cassette tape is not pushed all the way in. The cassette tape is

inserted in the wrong position
* Adjust the volume knob.
* The cassette has reached the end of the side being played. Press

EJECT/F.F button (9), remove cassette tape, flip the tape over and re-

insert.

NOTE: Remove the tape from the unit when is not in use or when listening

to the radio.

LOCATION OF PARTS

1. SPEAKER

2. TUNER DIAL

3. TUNING KNOB

4. ON - OFF SWITCH/VOLUME CONTROL

5. TONE CONTROL

6. AM/FM BAND SWITCH

7. POWER PLUG

8. CASSETTE DOOR

9. EJECT/F.F BUTTON

10. FM ANTENNA

WARRANTY

Crosley Radio Products are warranted against defects in material and
workmanship for a period of 90 days beginning from the date of sale to the
original purchaser.

Should the unit fail under normal usage during the 90 day warranty period, a
request for RETURN AUTHORIZATION (R.A.) must be made by the original
customer before returning the unit. Call Crosley Radio customer service for
Return Authorization at [phone] from 9 AM to 5 PM (EST) Monday to
Friday.

Upon receiving the RETURN AUTHORIZATION number from the Customer
Service Department, properly pack your unit in its original packaging. Include
any adapters, parts, & accessories which were originally provided with the
product, along with a check or money order for $19.95 made out to Crosley
Radio to cover the handling and return postage. Display the R.A. # on the
outside of the carton and ship PREPAID via standard UPS or its equivalent.

ATTN: RETURNS DEP'T

2001 PRODUCTION DRIVE

1

BAY 2 & 3

LOUISVILLE, KY 40299

10

2

3

9
8

CROSLEY RADIO assumes no responsibility for units sent without prior Return Authorization.

The purchaser’s bill of sale is the only proof of warranty entitlement and must accompany the unit.

The warranty does not cover damage due to acts of nature, accident, misuse, abuse, negligence, commercial
use or modification of, or to any part of the product. This warranty does not cover damage due to improper
operation or maintenance, connection to improper voltage supply, or attempted repair by anyone other than
a facility authorized by Crosley Radio to service the product. This warranty does not cover products sold
AS IS or consumables (such as fuses or batteries). This warranty is valid only in the United States.

This warranty gives the purchaser specified legal rights in addition to any rights which may vary from state
to state.

In accordance with the "Moss-Magnuson Warranty Act" of July 10, 1975, this is termed a "limited warranty"
which in no way compromises Crosley Radio‚ high standards of Quality and Workmanship.

4 5 6 7