Crosley Radio CR02-001A User Manual

22-1-08
12
910-274200-0010-100
WARRANTY
Crosley Radio Products are warranted against defects in material and workmanship for a period of 90 days beginning from the date of sale to the original purchaser.
Upon receiving the RETURN AUTHORIZATION number from the Customer Service Department, properly pack your unit in its original packaging. Include any adapters, parts, & accessories which were originally provided with the product, along with a check or money order for $19.95 made out to Crosley Radio to cover the handling and return postage. Display the R.A. # on the outside of the carton and ship PREPAID via standard UPS or its equivalent.
ATTN: RETURNS DEP'T
2001 PRODUCTION DRIVE
BAY 2 & 3
LOUISVILLE, KY 40299
CROSLEY RADIO assumes no responsibility for units sent without prior Return Authorization.
The purchasers bill of sale is the only proof of warranty entitlement and must accompany the unit.
The warranty does not cover damage due to acts of nature, accident, misuse, abuse, negligence, commercial use or modification of, or to any part of the product. This warranty does not cover damage due to improper operation or maintenance, connection to improper voltage supply, or attempted repair by anyone other than a facility authorized by Crosley Radio to service the product. This warranty does not cover products sold AS IS or consumables (such as fuses or batteries). This warranty is valid only in the United States.
This warranty gives the purchaser specified legal rights in addition to any rights which may vary from state to state.
In accordance with the "Moss-Magnuson Warranty Act" of July 10, 1975, this is termed a "limited warranty" which in no way compromises Crosley Radio high standards of Quality and Workmanship.
25-2-08
Tempo Radio
CR02-001A
Instruction Manual
AM/FM
SNOOZE/DIMMER
W
AKE-
TO
ALM.SET
ALM.ON/OFF
CLOCK
ADJ.
SLEEP
+
VOLUME
-
iPOD/AUX
POWER
+
TUNE
-
10
The exclamation point within an equilateral triangle is intended to alert user to the presence of important operating and maintenance (servicing) instruction in the literature accompanying the appliance.
RISK OF ELECTRIC SHOCK
DO NOT OPEN
CAUTION
The lighting flash with arrowhead symbol, within an equilateral triangle, is intended to alert user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute risk of electric shock to persons.
CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). NO USER - SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.
Specification
Frequency Range : AM 530 - 1710 KHz
: FM 87.5 - 107.9 MHz Power Supply : AC Adaptor DC15V 1.3A Power Consumption : 23W Antennas
:
External
antenna Wire
for FM
:
External loop antenna
for AM
Speaker : 2 ¾ 8ohm 5W x 2
WARNING:
TO PREVENT FIRE OR SHOCK HAZARD, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE. DO NOT REMOVE COVER. PILOT LAMPS SOLDERED IN PLACE. NO USER SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.
* DESIGN AND SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE.
General
Troubleshooting :
Symptom Possible Problem Solution
Does not turn on AC adaptor isnt plugged into a
working wall socket or not plugged into the power supply jack on back of the unit
Plug the AC adaptor into a working wall socket and plug the connector into the supply jack on the unit
Doesnt respond Requires a reset If unit is plugged in and doesnt respond, try
resetting the unit by following these steps: a) remove iPod from dock b) unplug unit from power source c) remove back up batteries d) wait 1 hour, then resume use
iPod does not dock properly
Using no or wrong iPod insert Make sure the dock insert is the proper fit for your
iPod
iPod didnt install properly Remove your iPod from the dock and check for
obstruction on the connectors in the dock and on your iPod. Then reseat it in the dock.
Battery Low icon always flashing
Batteries are weak Replace with new batteries
Batteries were not installed properly Check to make sure polarity(+ and - ends)matches
the diagram in the battery compartment
iPod does not respond to the unit/iPod is playing but no sound comes out
iPod is not installed properly
Remove your iPod from the dock and check for obstruction on the connectors in the dock and on your iPod. Then reseat it in the dock.
Your iPod software is too old Upgrade on your iPod. For details visit
http://www.apple.com/ipod/download
iPod is locked up/plays but no sound comes out
Check the volume setting. Make sure your iPod is working properly before docking into the unit. Please refer to your iPod manual for details. See above for software upgrade information. you may need to reset your iPod. To do so: a) Toggle the Hold switch to hold position, then off. b) Press and hold the Menu and center Select
button at the same time until apple logo appears. You may need to repeat this step.
Using 1st or 2nd generation iPod, iPod Shuffle or other devices.
It cannot control those iPods or other devices.
Remote Control didnt work
Battery weak
Replace current battery with new battery
Remote Control is not pointed toward it remote sensor
Point the Remote Control towards the remote sensor (to the left of the display), move within 10 feet of the unit.
Radio/iPod performance is erratic
It is reaction to external interference
Move unit away from potential sources of external interference such as computers, modems, wireless devices(routers) or fluorescent light
No sound from unit Volume is set too low on unit
Make sure volume is turned up
iPod didnt charge up iPod is not installed properly
Remove your iPod from the dock and check for obstruction on the connectors in the dock and on your iPod. Then reseat it in the dock.
iPod is locked up/frozen
Please make sure your iPod is working properly before docking into the unit. Please refer to your iPod manual for details.
iPod battery has problem
Loading...
+ 4 hidden pages