Crosley CG206B, CG205W, CG1100PRWK, CG1100PRW, CG1100PRAK Owner's Manual

Gas Range Featuring

• Sealed surface burners

• Clock and timer, if equipped

• Pilotless ignition

8113P043-60

(1/93)

FORFUTUREREFERENCE

Forfuturereferencewe suggest you re-
tain this manual after recording the WARNING: If the informa-

model numberandserialnumber ofthis tion in this manual is not
gas appliance in the spaces provided.

Thisinformationcanbefoundontherat-followed exactly, a fire or

ing platelocatedonthesidesofthelow- explosion may result caus-
er range front frame. Pull out lower ing property damage, per-

drawerto see ratingplate, sonal injury or death.

- Donot store oruse gaso- _z_._
line or other flammable

MODELNUMBER vapors and liquids in the

vicinity ofthis or any Oth-

SERIAL NUMBER er appliance.

-WHAT TO DO IF YOU

DATEOF PURCHASE

These numbers identify your range.

Pleaseusethem in anycorrespon- • Do not touch any elec- • INJURY TO PERSONS

dence or servicecallsconcerningyour trical switch; do not COULD RESULT
appliance, use any phone in your

Pleaseretaintheproofofpurchasedoc- building. • INSTALLANTI-TIP
umentsforwarrantyservice. DEVICES PACKED

SMELL GAS: ,_ WARNING

• Do not try to light any • ALL RANGES

appliance, CAN TIP

• Immediately call your WITH RANGE

gas supplier from a

neighbor's phone. • SEE INSTALLATION
Follow the gas suppli- INSTRUCTIONS

er's instructions.

To reduce the risk of tipping of the

• If you cannot reach appliance from unusual usage or by

your gas supplier, call excessive loading of the oven door,

the fire department, the appliance must be secured by a

- Installation and service check ifdeviceisinstalledproperly:Use

must be performed by a a flashlight andlookunderneathrange

qualified installer, ser- to see that one of the rear leveling legs

vice agency or the gas
supplier.

properly installed anti-tip device, To

isengagedinthebracketslot.

L%J

Time-Of-DayClock

Ifyour rangefeaturesa time-of-day clockand minutetimer

follow the instructions for the illustration that matches the

clock on your range.

ANALOG CLOCK AND TIMER DIGITALAND CLOCK TIMER

12

11._\OFF/z1

1 ___- CLOCKSET MINUTET/MEFt

"'/llllJl_ TM 88:88 will flash in the display when the

7' 6 5 range is first connected to power or if

power is interrupted.

TOSETCLOCK: Push in and turn Min- TO SET CLOCK: Press and hold
uteTimerknobtothecorrecttimeofday. CLOCK SET button while turning MIN-

BesureMinuteTimer handisonOFFaf- UTE TIMER knob to the correct time of
tersetting clock, day. MINUTE TIMER knob can be

TO SET MINUTE TIMER: Turn knob in
either direction to the desired time. TO SET MINUTE TIMER: Turn MIN-

Whenthebuzzersounds,manuallyturn UTE TIMER knobtotheright,tothede-
theTimer to OFF, sired time, up to 60:00 (t hour). Timer

turned in either direction.

willbegincountingdownafterafew sec-
onds delay.When time has lapsed, a
continualbeepwillsoundforupto2min-

utes.

4

(continued on next page)

Time-Of-Day Clock (continued)

ELECTRONIC

CLOCK AND TIMER TO SET MINUTE TIMER: Slide switch TO CANCEL MINUTE TIMER OP-

downtoTIMERposition.0:59willbedis- ERATION OR STOP "END-OF-

HOUR CLOO( playedassoonas theswitchismovedto TIME" BEEPS: Slideswitchuptothe

maticallybegincounting down from one pear inthe display.

8 1 2 : _------_ _ + the TIMER positi°n' The timer will aut°-clock position.Timeof day willreap-

MZN TZVER sound.Slide switchto the CLOCK posi-

When rangeisfirstconnectedto power reappearinthe display.
or ifpowerisinterrupted,12:00willflash

inthedisplay.

CLOCK position. =e
Press and hold HOUR button until cor-

+° +'+°°+t+u°'°O[ 05

rect hour appears inthe display, mZN
PressandholdMIN buttonuntilthe cor-

rectminutesappearinthedisplay.

hourin increments ofone minute. When

time has lapsed, a continual beep will
tionto stop beeps.The time of day will

+

TO SET A TIMING OPERATION

FOR LESS THAN ONE HOUR:
Pressand hold MIN buttonuntilde-

siredtimeappearsinthedisplay.Tim-
er will immediately begin counting

downassoonasthe MINbuttonisre-

leased.

TO SET A TIMING OPERATION

FOR GREATERTHAN ONE HOUR:
Pressthe HOUR button,1:59 willap-

pear in the display.Select desired
minutesbypressingandholdingMIN

button,Timingwillbeginwhen button
is released.

Two hours isthe maximum timing
that can be set.

5

SurfaceCooking

IGNITION SYSTEM TO LIGHT SEALED BURNER ADDITIONAL INFORMATION
Your range will feature pilotless igni- 1. Place utensilon burnergrate. * When therange isfirstinstalled,the

tion;a sparkfromthe ignitorlightsthe pilotsmaybedifficulttolightduetoair
burner.Theignitorislocatedattheback 2. Push in and turn knob to the LITE inthegasline.Tobleedoffairfromthe

side of each surface burner, position. After the burner lights, turn line, hold a lighted match nextto the

Ignitor gasto the appliance.

REARVIEWOFSEALEDBURNER

the knob to the desired flame size. burner and turn knob on. When the

proceedas directed.

• Be sure all surface controls are set
in the OFF position prior to supplying

_ burner lights, turn the knob off and

NOTE: The knob on your appliance burneroff.If gas has accumulated
may not look likethe knob in this il- and a strong gas odor is detected,

lustration,but it will operate as de- wait 5 minutesfor the gas to dissi-

scribedinthis booklet, pate before relighting burner.

• CAUTION: If flame should go out
duringa cookingoperation,turnthe