ENGINE PRECAUTIONS
WARNING!!! Read engine owners/operators manual before using or attempting to service
this machine. A fire or explosion can occur resulting in personal injury if the following
instructions are not followed:
• DO NOT fill fuel tank while engine is running. Allow engine to cool before refuelling.
• DO NOT operate the engine when an odour of fuel is present, or other explosive
conditions exist.
• IF FUEL IS SPILT, move the machine away from the area of the spill and avoid creating
any source of ignition until the fuel has been removed.
• DO NOT store, spill, or use fuel near an open flame or devices such as a stove, furnace,
water heater which utilize a pilot light, or devices which can create a spark.
• RE-FUEL OUTDOORS or in well ventilated area.
• DO NOT operate engine if the air cleaner or cover directly over the carburettor air
intake is removed.
• DO NOT choke the carburettor to stop the engine.
• DO NOT tamper with the governor springs, governor links or other parts which may
increase the governed engine speed.
• DO NOT tamper with the engine speed selected by the original equipment
manufacturer.
• CAUTION!!! DO NOT run at excessive speeds. Operating the engine at excessive
speeds increases the danger of personal injury.
• DO NOT touch hot mufflers, cylinders or fins, as contact may cause burns.
PRESSURE PUMP PRECAUTIONS
• NEVER allow the pump to run for more than a 3 minute period without opening the
gun. (This will cause pump damage due to excessive water temperature and void the
warranty)
• NEVER let the pump run when the machine is not connected to the water supply.
• NEVER run acid or hard caustics through the pump.
• Never use chemicals or agents which are not compatible with the Buna-N and PVC
(polyvinyl) or neoprene covering of the hose. (Always use citrus based detergents.)
• Never use hot water through the pump.
• Check for leaks, tighten connections if necessary. Machine must be turned off and
pressure released from pump and gun.