6 X 10 PUSH BUTTON CENTER LOCK
www.crlaurence.com
Fax Orders (800) 262-3299
Phone Orders (800) 421-6144
C.R. Laurence Architectural Products
CENTER LOCK SYSTEM
2
INSTALLATION INSTRUCTIONS
SHEET 1 OF 2
OF SPANNER INTO POKEHOLE IN COLLAR OF DRIVE
REMOVE INSIDE LEVER BY INSERTING POINT
1
SLEEVE AND DEPRESSING RETAINING CLIP.
3
4
6
5
REFERS TO L1000 INSTALLATION INSTRUCTION
*
HANDBOOK FROM ILCO UNICAN
SEE STEP 10. INSTALLING INSIDE LEVER
*
CYLINDER ANTI-CLOCKWISE UNTIL IT IS FREE.
SEE STEP 11. INSTALLING COMBINATION CHANGE PLUG ASSEMBLY
REMOVE CYLINDER BY INSERTING KEY AND ROTATING
*
REMOVE INSIDE TRIM PLATE BY UNSCREWING THREAD RING
FROM DRIVE UNIT.
SEE STEP 9. INSTALLING INSIDE TRIM PLATE.
*
INSIDE LEVER
SPANNER
THREAD RING
KEY
CYLINDER
TRIM PLATE
THE TWO SECURING SCREWS
SEE STEP 7. INSTALLING REINFORCING PLATE.
REMOVE REINFORCING PLATE BY UNSCREWING
*
SEE STEP 5. INSTALLING LOCK.
REMOVE LOCK BY SLIDING IT FROM THE HOUSING.
*
SECURING SCREWS
REINFORCING PLATE
LOCK
HOUSING
REMOVE COVER PLATES
SEPARATE CLAMP PLATES BY REMOVING 4 CAP HEAD SCREWS
COVER PLATES
NUTS AND WASHERS.
SCREWS
WASHERS
WASHERS
NUTS
DOC # 1M003000
DL610LC, DL610RC, DL611LC, DL611RC
www.crlaurence.com
Fax Orders (800) 262-3299
Phone Orders (800) 421-6144
C.R. Laurence Architectural Products
CENTER LOCK SYSTEM
INSTALLATION INSTRUCTIONS
SHEET 2 OF 2
7
8
9
10
11
RH RHR LH LHR
BE SURE TO HAVE NUTS AND WASHERS ON THE OUTSIDE
ASSEMBLE CLAMP PLATES ONTO GLASS.
NOTE: BEFORE FINALLY TIGHTENING, TEST INSTALL THE
COVER PLATES TO ENSURE ALIGNMENT WITH GLASS.
6 X 10 PUSH BUTTON CENTER LOCK
RE-ASSEMBLE LOCK AND HARDWARE.
ENSURE LOCK HAS BEEN ASSEMBLED TO THE CORRECT HAND. FOLLOW DIRECTIONS
CAREFULLY APPLY COVER PLATES ENSURING HOLES
AND LOCK FACE PLATE LINE UP. PRESS ON FIRMLY.
REMOVE VHB TAPE COVER PAPER
*
IN THE ILCO UNICAN INSTALLATION BOOK. SET UP COMBINATION AND TEST LOCK
OPERATION AS DESCRIBED IN SECTION 13.
DL610LC, DL610RC, DL611LC, DL611RC
DL610RC DL611RC DL610LC DL611LC
DOC # 1M003000
Loading...