
®
                RF24
With 1.5” NPT Threaded Interface
www.crimsonav.com         support@crimsonav.com
Instruction Manual
Heavy Duty Parapet Mount
PACKAGE CONTENTS
WEIGHT CAPACITY
Maximum Weight Capacity
50lb / 23kg
!
CAUTION!
! !
WARNING! SEVERE PERSONAL INJURY AND PROPERTY DAMAGE CAN RESULT FROM 
IMPROPER INSTALLATION OR ASSEMBLY. READ THE FOLLOWING WARNINGS BEFORE 
WARNING!
BEGINNING.
B (1)
Aluminum 
Bracket
Base
M (1)
 Pipe Extension
K (2)
Wall Bracket
L (1)
 Pipe Insert
G (1)
 Base End Cap
A (1)
Aluminum 
Bracket
Arm
H (1)
Rubber Arm 
Plug
Do not use this product for any purpose not explicitly specied by Crimson AV. Improper installation may cause property damage or personal injury. If you do not understand these directions, or 
have doubts about the safety of the installation, contact Crimson AV Customer Service or call a 
qualied contractor. Crimson AV is not liable for damage or injury caused by incorrect mounting, 
assembly, or use.
DO NOT EXCEED THE MAXIMUM WEIGHT CAPACITY FOR THIS PRODUCT
C (6)
Stainless Steel
Bolts
Lock Washers
 E (6)D (6)
Stainless Steel
Washers
1
F (1)
Rubber Base 
Cap
RF24-0001

INSTALLATION INSTRUCTIONS
2
1
Pre-drill holes and securely install the RF24 base (B) on parapet.
Use of expansion bolts (not included) is recommended when 
installing into masonry surface.
3
Add pipe insert (L) into base, then secure in to position using 
the included stainless steel bolts and washers.
Insert pipe extension (M) over insert, then secure in to position 
using the included stainless steel bolts and washers.
2
RF24-0001

45
°
45
°
4
Insert bracket arm (A) into base, then secure in to desired 
position using the included stainless steel bolts and washers.
4A
(Option A): Pre-wire for the camera installation through the 
opening at the bottom of the RF24 base. Then install the camera according to the manufacturer’s directions.
Note:
3
Remove end cap and rubber plug to help guide wires.
RF24-0001

3/4” standard conduit connector
(not included)
4B
Note:
(Option B): Removing the rubber base cap will reveal a 3/4” 
threaded opening to receive a standard 3/4” conduit connector. This is handy for installations where the conduit is not 
run through the wall. Then install the camera according to the 
manufacturer’s directions.
RF24 comes with a standard 1.5” thread interface. For cameras that have a smaller or larger interface, an additional 
thread reducer would be required.
5
4
When installing base on a narrow parapet use wall brackets 
(K) for added security. (Hardware not included)
Use of expansion bolts (not included) is recommended when 
installing into masonry surface.
RF24-0001

360º
WARRANTY
Congratulations on the purchase of this Crimson product! The product you now have in your posses-
sion is made of durable materials and is based on a design, every detail of which has been meticu-
lously thought-out. That is why Crimson AV LLC products are covered by a 10-year warranty against 
defects in materials or manufacturing.
Crimson AV LLC disclaims any liability for modications, improper installations, or installations over 
the specied weight range. To the maximum extent permitted by law, Crimson AV LLC disclaims 
any other warranties, expressed or implied, including warranties of tness for a particular purpose 
and warranties of merchantability. Crimson AV LLC will not be liable for any damages arising out of 
the use of, or inability to use, Crimson AV LLC products. Crimson AV LLC bears no responsibility for 
incidental or consequential damages. This includes, but is not limited to, any labor charges for the 
repair of Crimson AV LLC products performed by anyone other than Crimson AV LLC.
Specications are subject to change without prior notice.
WARRANTY CONTINUED
NOTICE TO CUSTOMERS OUTSIDE THE UNITED STATES: CRIMSON PRODUCT WARRANTY APPLIES 
ONLY TO PRODUCTS PURCHASED IN THE UNITED STATES. FOR PURCHASES OUTSIDE OF THE 
UNITED STATES, PLEASE CONTACT YOUR COUNTRIES DISTRIBUTOR FOR COUNTRY SPECIFIC WARRANTY INFORMATION.
Note:
When the securing screws are removed, arm can be rotated 
360º for maintenance and camera installation.
© 2010 Crimson AV LLC. All rights reserved. 
Crimson is a Crimson AV LLC brand. Crimson 
and Crimson AV Mounting Solutions logos are 
trademarks of Crimson AV LLC.
5
TM
Crimson AV LLC
1854 Elmdale Ave
Glenview, IL 60026
RF24-0001