Crimestopper Security Products RS1905FM, RS-1804FM, RS-1604TW1, RS-1704TW2 User Manual
RS-1604TW1/RS-1704TW2/RS-1804FM
This device complies with FCC Rules part 15. Operation is
subject to the following two conditions: 1) This device may not
cause interference, and (2) this device must accept any
be received, including interference that
may cause undesired operation. The manufacturer is not
responsible for any radio or TV interference caused by
unauthorized modification to this equipment. Such modification
RS1905FM
2-Way Paging Remote Engine Starting & Keyless
Entry System with 1-Way Sidekick Remote Control
OPERATING INSTRUCTIONS
-PRIMARY: These are features that must be connected in order for the system to operate properly i.e. Remote
Start connections, Flashing lights, Brake Reset. For programming, the hood pin and program button are required.
-OPTIONAL: These are features are to be connected only if desired or agreed upon by the customer and the
installing dealer i.e. Door Locks, Trunk Pop, Dome Light Illumination, Horn-Honk, Anti-Grind, etc. These features
may also require additional parts and/or labor fees. Consult with your installer beforehand to be sure of what is
going to be installed with your particular system.
TECHNICAL SUPPORT: (800) 998-6880
Monday - Friday 8:00am - 4:30pm Pacific Std. Time
Web Site: www.crimestopper.com
E-mail: email@crimestopper.com
CRIMESTOPPER SECURITY PRODUCTS, INC.
1770 S. TAPO STREET, SIMI VALLEY, CA. 93063
interference that may
could void the user's authority to operate the equipment.
REV C – 09.30.2005
2
TABLE OF CONTENTS
Operation Cautions & Warnings…. ………………..….…………………………………….…………………...………2
2-Way Paging LED Remote TW1.........…………………………………………………………….…………..……….3
2-Way Paging LCD Remote TW2..……………………………………………………………………………...……….4
2-Way Paging LCD Remote FM…..…….. ……………………………………………………………………...…...…..5
Using the Remote 1-Way Remote………………………………………………………………………………….….6-7
Remote Engine Starting…………………………………………………………………………………………...….. 8-11
Turbo Timer Mode……………………………….……………………………………...………………………….….…12
Convenience and Safety Features…….……………………….………………..…………………… …..….....….13-14
Transmitter Programming….…………….………………………………………….……………….…..…….…......…15
2 Vehicle Operation.………………………………….………………...……………………..………...……..…...……16
Troubleshooting “Before You Call”………….…………..………………………………………….………… .…...17-18
Low Battery Warning and replacing the AAA battery on LCD Remote…………………………………………….19
Setting the Clock…………………………………………………………………………………...………...…Back Page
OPERATION CAUTIONS & WARNINGS
CRIMESTOPPER SECURITY PRODUCTS, INC. and its VENDORS shall not be liable for any accident resulting
from the use of this equipment. This system is designed to be professionally installed into a car or vehicle in which
all items, such as parking brake and all associated components, door switches, transmission shift l inkage, throttle
linkage, and all engine safety features, are in perfect working condition.
DO NOT install the Remote Engine Starting System on MANUAL TRANSMISSION vehicles. If accidentally left
in gear the vehicle could become a self-propelled threat to life and property.
IT IS ABSOLUTELY THE OWNER’S SOLE RESPONSIBILITY TO: A) Understand the operation of this system
and its safety features. B) Check for proper operation of the system prior to accepting delivery of the vehicle from
the installation facility. C) Check and maintain the condition of the vehicle and all items relative to the proper
operation of this system and its safety features. D) Always leave the doors and windows closed and locked to
protect against accident and theft.
DO NOT remote start the vehicle in a closed garage. Make sure that the garage door is open or there is
adequate ventilation. Failure to observe this rule could result in injury or death from poisonous Carbon Monoxide
fumes.
3
2-WAY PAGING LED REMOTE RS-1604TW1
OPERATION:
BUTTON 1 (Lock Symbol):
• Press and release to Lock doors.
• Press and Hold for more than 3 seconds to activate
“Panic” feature.
BUTTON 2 (Unlock Symbol):
• Press and release to Unlock doors.
BUTTON 3 (Trunk Symbol):
• Press and Hold for two seconds to activate trunk pop
(Optional Feature) .
BUTTON 4 (Start):
• Press and Hold for two seconds to Start/Stop Engine
BUTTON 5 (Side button)
§ Press and Release to show the previous status.
§ Press and Hold for 5 second to switch to vehicle #2.
TWO-WAY PAGER OPERATION & PAGE TONES:
FEATURE
BUTTON ACTION BEEPS LED/FLASH
PAGING
LED's
#1
#5
nd
CAR2
#3
TRUNK
POP
FIXED
ANTENNA
#2
UNLOCKLOCK
#4
REMOTE
START
LOCK #1 (Lock) Press & Release 1X then 1X again Orange / 1X
UNLOCK #2 (Unlock) Press & Release 1X then 2X again Green / 2X
AUX #1 #3 (Trunk) Press & Hold 2 Sec. 1X then 3X again Yellow / 1X
REMOTE START #4 (Start) Press & Hold 2 Sec. 1X then 3X again Blue /3X
ENGINE RUNNING 6X Blue / 6X
TURN OFF ENGINE #4 (Start) Press & Hold 2 Sec. 1X No Page back
PANIC #1 (Lock) Press & Hold 3 Sec. 1X then 2X / 12X Orange 12X / Green 1X
4
tional
Press and release twice to recall the last message from the
d two seconds to change from Car 1 to Car 2
enable/disable beep
2-WAY PAGING LCD REMOTE RS-1704TW2
OPERATION:
BUTTON 1 (LOCK Symbol):
• Press and release to Lock doors.
• Press and Hold for more than 3 seconds to activate “Panic”
feature.
#1 LOCK
BUTTON 2 (Unlock Symbol):
• Press and release to Unlock doors.
BUTTON 3 (Trunk Symbol):
• Press and Hold two seconds to activate trunk pop (Op
Feature).
#5 RECALL
CAR I or II
BUTTON 4 (Start Key Symbol):
• Press and Hold two seconds to Start/Stop engine.
BUTTON 5 (On side of remote):
• Press and release to light up the LCD screen.
#3 TRUNK
•
LCD screen.
• Press and Hol
• Press 5 times to change the time and
tones from the remote.
FIXED
ANTENNA
#2 UNLOCK
AM
LCD
SCREEN
#4 ENGINE
START/STOP
LOCK
UNLOCK
TRUNK POP
REMOTE
LOW BATTERY
PANIC
START
5
2-WAY PAGING LCD REMOTE RS-1804FM/1905FM
message from the
OPERATION:
BUTTON 1 (Lock Symbol):
• Press and release to Lock system.
Press and Hold for more than 3 seconds to activate
“Panic” feature.
BUTTON 2 (Unlock Symbol):
• Press and release to Unlock system.
BUTTON 3 (Trunk Symbol):
• Press and Release to activate trunk pop (Optional
Feature).
BUTTON 4 (Start Symbol):
• Press and release to Start/Stop Engine.
BUTTON 5 (On Side of Remote)
• Press and release to recall the last
LCD screen.
• Press and Hold 5 seconds to change from Car 1 to Car 2.
• Press 5 times to enable/disable beep tones from the
remote.
#5
RECALL /
CAR I OR II
#1 ARM/
LOCK
#3 TRUNK
POP
FIXED
ANTENNA
LCD
PM
START
SCREEN
#2 DISARM/
UNLOCK
#4 ENGINE
START/STOP
PM
LOCK UnLock Trunk Pop Confirm Remote Successful Start
Start Request
IGN
PM
PM
PM
PM
IGN
(<<<< MOVING <<<<<)
6
USING THE 1-WAY REMOTE
OPERATION:
BUTTON 1 (Lock Symbol):
• Press and release to Lock doors.
• Press and Hold for more than 3 seconds to
activate “Panic” feature.
BUTTON 2 (Unlock Symbol):
• Press and release to Unlock doors.
BUTTON 3 (Trunk Symbol):
• Press and Hold for two seconds to activate
trunk pop (Optional Feature).
BUTTON 4 (Start):
• Press and Hold for two seconds to Start/Stop
Engine
BUTTON 5 (Side button)
§ Press and Release to show the previous
status.
§ Press and Hold for 5 second to switch to
vehicle #2.
#1
LOCK
#3
TRUNK
Replacement Battery
FLASHLIGHT
COOLSTART
The transmitter supplied with the CoolStart system contains four buttons, flashlight, and vehicle 2 switch. The
button configuration of the CoolStart system is Factory-set and unchangeable. See Page 16 for additional
information on how to use your remote to operate a second vehicle equipped with a CoolStart system.
NOTE: BUTTON #4 and #3 Remote Start/Trunk
There is a deliberate delay or 2 presses (Optional) built into the system on button #4 and #3 to help prevent
accidental remote starting from the remote being in your pocket or pu rse. During normal use, if you press button
#4 or #3 too quickly, the system may not start the engine or open trunk.
#2
UNLOCK
#5
VEHICLE 2
#4
REMOTE
START
Loading...