Crimestopper TN-4005, TN-4008 Installation Manual

TN-4005 / TN-4008 Install Guide

3 Wire minimum connections

Black Wire – Chassis Ground

Red Wire - +12v Constant Input. Connect to constant +12v power source

White Wire - + Ignition source.

Optional Connections

Green Wire – 1 amp negative output for starter disable

Yellow Wire – Test wire for starter disable (optional) Ground this wire momentarily
(one second) after installation. This will test Starter Disable output. The relay will
close and open the starter circuit for 30 seconds. If properly installed, the vehicle
should not turn over / start during this time. The test will send a message to the
device “History” that reads “Installation Test Sequence” on the website.

Blue Wire – (-) Alarm Input Trigger. After 27 seconds of a constant negative input
from your vehicle alarm, this will send a message to the device.

Violet Wire – (-) Door Unlock Wire

Label side of module must be facing up.

Make sure vehicle is parked outside, in clear view of the horizon for GPS to “lock
in”.

Orange and Yellow L.E.D.’s will stay on solid once unit has GPS lock and Cell lock.

Fax EQUIPMENT & SERVICE AGREEMENT to 805.581.9500

Crimestopper Security Products, Inc.
1770 S. Tapo Street
Simi Valley, CA 93063
Tel: [phone] Fax: [phone] Toll Free: 800.998.6880
Email: [e-mail]