Crimestopper SV-6300.OEM.IR Installation Manual

SV-6300 OEM

SV-6300 OEM-IR

INSTALLATION INSTRUCTION

The SV-6300 universal mount waterproof back-up cameras are designed to be
installed on any vehicle. Most installations are easy to install with no drilling
required, requiring minimal installation time.
This uniquely designed product can be of use for any passenger car, SUV and
Van, also can be of use for large truck, school bus, bus and boat as well.
Furthermore, it can not only be installed on the license plate, but anywhere on
the vehicle, such as under the bumper, on the sides of cargo trailers or above the
hatch.

SPECIFICATION:

Image Device: OmniVision CameraChipTM
TV System: NTSC full color
Operating Voltage: 12 V DC
Image: Mirror image or non mirror image (optional)
Video Output: 1.0Vp-p, 750Ohm
Resolution: 380 TV Lines
Illumination: 2Lux/F1.2, 0Lux with Night-vision (SV-6300 OEM-IR)
Current Consumption: Max. 60mA/ 200mA for Night-vision
Lens: f=2.8mm/f=2.0
View Angle: 115 degrees
Water Resistance: IP68

INSTALLATION TIPS:
Step 1. Find a flat place to the left or right of license plate or mounting surface.
Step 2. Mount the SV-6300 camera using screws provided to secure the camera

base to your chosen mounting location (Do not over tighten screws).

TECHNICAL SUPPORT: [phone]

VER 2.22.07

Step 3. Wire connections:
Connect the Camera’s (Yellow) connector to video input on monitor unit; Black

connector is for the power connected to DC 12V.

A. Connect the yellow (RCA) connector to video monitor input connection,

and the black connector to the video monitor power output connector, if
the Rear view monitor unit has auto reverse camera power on feature. (See

Wiring Diagram1.)

B. Connect the yellow (RCA) connector to video monitor input connection

and the black connector to reverse light power wire by using the power
wire, if the Rear view monitor does not have auto reverse camera power
on feature. When the vehicle is placed in reverse position, the camera is
powered on. (See Wiring Diagram 2.)