Crimestopper SV-6300.OEM Installation Manual

SV-6300

INSTALLATION INSTRUCTION

The SV-6300 universal mount waterproof back-up cameras are designed to be
installed on any vehicle. It is easy to install with no drilling required, requiring
minimal installation time.
This uniquely designed product can be of use for any passenger car, SUV and
Van, also can be of use for large truck, school bus, bus and boot as well.
Furthermore, it can not only be installed on the license plate, but anywhere on
the vehicle, such as under the bumper, on the sides of cargo trailers or above the
hatch.
The SV-6300 type is designed for any pickup truck and trailer or boot,

SPECIFICATION:

Image Device: OmniVision CameraChipTM
TV System: NTSC full color
Operating Voltage: 12 V DC
Image: Mirror image or non mirror image (optional)
Video Output: 1.0Vp-p, 750Ohm
Resolution: 380 TV Lines
Illumination: 2Lux/F1.2, 0Lux with Night-vision (optional)
Current Consumption: Max. 60mA/ 200mA for Night-vision
Lens: f=2.8mm/f=2.0
View Angle: 115 degrees
Water Resistance: IP68

NSTALLATION:
Step 1. Find place flat top lift or right on license plate.
Step 2. Install the SV-6300 camera top on the license plate. Using screws to hold

on the edge top of the license plate.

Step 3. Wires connection:
Camera’s Yellow socket is connected to video input on monitor unit; Black socket

is for the power connected to DC 12V.

A. Connect the yellow socket to monitor unit video input, and the black

socket to the monitor unit power output, if the Rear view monitor unit has
auto reverse camera power on feature. (See Wiring Diagram1.)

B. Connect the yellow socket to monitor unit video input and the black socket

to reverse light power wire by using the power wire, if the Rear view
monitor unit does not have auto reverse camera power on feature. When
the gear is in the reverse position, the camera is power on. (See Wiring
Diagram 2.)