CrimeStopper SV-5200.IR, SV-5200.IR.C, SV-5420.IR, SV-5420.IR.C, SV-5420.IR.BC Installation Instructions Manual

SV-5200.IR

with Night

License Plate Bar-Type

SV-5200.IR.C

Camera

INSTALLATION INSTRUCT IONS:

The SV-5200.IR and SV-5200.IR.C are bar-type license plate cameras with a super wide 180°
viewing angle and IR night vision. They are easy to install with no drilling required, requiring
minimal installation time. This uniquely designed product can be used for any passenger car,
SUV and Van. It can also be used on many large Semi Trucks, School Buses, and Transit
Buses

FEATURES:

• Revolutionary design integrates a Color rear vision camera with your rear license plate

• Enhance the look of your Car, SUV, Truck or Van.

• The 180° ultra wide-angle CMOS color camera provides rear images in real time and

eliminates the dangerous “blind-spot” directly behind your vehicle when backing.

• Works well in day or night, on most vehi c les .

• Normal or Reverse Image (Selectable)

• The plate cam easily connects with other SecurView monitor or aftermarket monitor that

uses an RCA input

• Available in black and chrome color

• The PlateCam™ is designed for vehicles in which the license plate location is centered

and above the level of the rear bumper. The PlateCam™ may not perform well on
vehicles with low or offset license plate positions.

SIDE

VIEW

License Plate

Camera Lens

Mounting

Surface

Cable

Factory License

Plate Bolt

NOTE

License Plate Should Not

Be Cut Or Trimmed

MOUNTING:

1. The SV-5200.IR and SV-5200.IR.C Rear Vision Systems use a super wide-angle lens for best
all around performance. The Camera will display the full width of most parking spaces up to 8
feet or even wider.

2. These cameras are designed to work best on vehicles that have a licens e plate locat ed at the
center and above the rear bumper. If your vehicle has a plate location that is offset to the left
side, right side, or your plate is located under the bumper then the PlateCam™ may not
provide optimum performance.

3. The SV-5200.IR and SV-5200.IR.C are designed to use the existing License Plate mounting
equipment

INSTALLATION

CAMERA:

1. The Camera has built-in circuitry to reverse the image so objects on the right of vehicle
appear on the right and objects on the left appear on the left when looking at a standard
monitor. (See Reverse Imaging next section for more information.)

2. The color CMOS camera is maintenance-free, waterproof (IP-68) and vibration resistant.

3. This camera has built-i n Infra-Red LEDs for night vision. This will provide the driver with the
absolute best illumination when backing up the vehicle at night time.

4. The camera is completely electronic. There are NO manual adjustments for focus, etc.