Crimestopper SV-5110 Installation Manual

INSTALLATION INSTRUCTION

SV-5110.II License bar color camera

SecurView series License plate bar waterproof back-up cameras are designed to
be installed on any vehicle using the existing license plate mounting holes. It is
easy to install with no drilling required, requiring minimal installation time.
This uniquely designed product can be of use for any passenger car, SUV and
Van, also can be of use for large trucks, school bus, bus or RV and boat as well.
Furthermore, it not only can be installed on the license plate, but also other
locations of the vehicle, such as on the sides of cargo trailers, above the hatch or
inside or outside motor home’s.

The SV-5110.II type is designed for any passenger car, SUV, Van, pickup truck
or trailer.

SPECIFICATION:

1/3” COLOR CMOS SENSOR SPECIFICATIONS
Image Device: OV7949
TV System: PAL / NTSC
Effective Pixel: 628 x 586 pixels / 510 x 496 pixels
Sensing Area: 5.961mm x 4.276mm
Scanning System: 2:1Interlance
Sync. System: Internal
Resolution: 420TV lines
Supper low Illumination: 0.1Lux
Video Output: 1.0vp-p, 75Ohm
Gamma Consumption: 0.45
ACC: Auto
S/N Ratio: Better than 48dB
White Balance: Auto
Electronic Shutter: 1/50Sec-12.5µSec (PAL) / 1/60Sec-12µSec (NTSC)
BLC: Auto
Current Consumption: Max. 60mA
Power Supply: DC12V
Operating Temperature: -20 oC~+70 oC, RG95%
Lens: 3.6 mm (P)/2.8 mm(N) F = 2.0

Lens Angle: 130o (P

TECHNICAL SUPPORT: [phone]
VER 05.17.07

INSTALLATION TIPS:

IMPORTANT!!
Read this instruction sheet completely and your monitors instructions
before beginning the installation.

Note: Most License plates do not require modification. However, please
look over camera mounting and placement options prior to making
modifications to vehicle.

Step 1. Remove license plate, if necessary cut or file a ¼ slot above the license

plate mounting holes as shown below.

Step 2. Install the License plate bar camera over the face on the top edge of the
license plate; make sure the screws are secure. DO NOT OVER TIGHTEN!!
Over tightening may damage the camera mounting hole locations.