Crimestopper RS-800.IV Operator's Manual

RS800 Series IV Remote Engine Starting System

OPERATING INSTRUCTIONS

OPERATION CAUTIONS & WARNINGS
DO NOT install this Remote Engine Starting System on MANUAL TRANSMISSION vehicles. If accidentally left in gear the vehicle could become a self-propelled threat to life and property.
IT IS ABSOLUTELY THE OWNER’S SOLE RESPONSIBILITY TO: A) Understand the operation of this system and its safety features. B) Check for proper operation of these safety features prior to accepting delivery of the vehicle from the installation facility. C) Check and maintain the condition of the vehicle and all items relative to the proper operation of this system and its safety features. D) Always leave the doors and windows closed and locked to protect against accident and theft.
DO NOT remote start the vehicle in a closed garage. Make sure that the garage door is open or there is adequate ventilation. Failure to observe this rule could result in injury or death from poisonous Carbon Monoxide fumes.
REV. A 08/2003
This device complies with FCC Rules part 15. Operation is subject to the following two conditions: 1) This device may not cause interference, and (2) this device must accept any interference that may be received, including interference that may cause undesired operation. The manufacturer is not responsible for any radio or TV interference caused by unauthorized modification to this equipment. Such modification could void the user's authority to operate the equipment.

OPERATION OPERATION

REMOTE ENGINE STARTING - SUCCESSFUL START:
1. Press start button for at least one second, then release.
2. Parking lights flash once, then turn ON along with the IGN/ACC circuits
3. After a few seconds the Starter Motor engages. (Parking lights and Acc circuits turn off while cranking.)
4. Engine Starts and Runs. Parking Lights and Acc turn back on.
5. Engine will remain running for programmed run time or until reset with Brake pedal.
REMOTE ENGINE STARTING - UNSUCCESSFUL START
In the event that the engine does not start on the first attempt, the system shuts down for a few seconds, and then attempts to restart the engine a 2 and 3
rd
time. For hard starting engines, the unit will allow a starter crank time of up to a maximum of 13 seconds. This should provide ample cranking time for difficult starts, but is limited to help prevent damage to the starter from over cranking in the case of a problem with the system.
1. If engine starts on 2
nd
or 3rd attempt, see steps 4 & 5 above of "Successful Start".
2. If Third attempt fails to start engine the system will abort. NO FURTHER ATTEMPTS WILL BE MADE
AUTOMATICALLY
TURNING OFF A REMOTE STARTED ENGINE:
1. Engine is running in Remote Start (Parking lights are ON).
2. Press start button for at least one second and release.
3. Engine and parking lights turn off.
VALET MODE
Before servicing your vehicle or handing the keys over to a Valet we recommend putting the unit into valet mode. The remote start function WILL NOT operate when in Valet mode. To enter Valet mode, turn the key to the ON position, press and hold Program/Valet switch for 6 seconds. The LED will turn on solid and the system is now in valet. Perform this procedure again to exit of Valet mode.
HOOD OPEN SAFETY SWITCH (WITH INSTALLED HOOD PIN SWITCH)
A safety hood pin switch (when installed along with the remote start system) helps eliminate the risk of injury to someone working under the hood. If will prevents the engine from being remote started while the hood is open. It will also abort a remote started engine.
nd
Loading...
+ 2 hidden pages