Crimestopper RS800 User Manual

RS800 Series III

Remote Engine Starting System

OPERATING INSTRUCTIONS

OPERATION CAUTIONS & WARNINGS

CRIMESTOPPER SECURITY PRODUCTS, INC. and its VENDORS shall not be liable for any accident resulting from
the use of this equipment. This system is designed to be professionally installed onto a vehicle in which all items, such
as parking brake and all associated components, door switches, transmission shift linkage, throttle linkage, and all
engine safety features, are in perfect working condition.

DO NOT install this Remote Engine Starting System on MANUAL TRANSMISSION vehicles. If accidentally left in
gear the vehicle could become a self-propelled threat to life and property.

IT IS ABSOLUTELY THE OWNER’S SOLE RESPONSIBILITY TO: A) Understand the operation of this system and its
safety features. B) Check for proper operation of these safety features prior to accepting delivery of the vehicle from the
installation facility. C) Check and maintain the condition of the vehicle and all items relative to the proper operation of
this system and its safety features. D) Always leave the doors and windows closed and locked to protect against
accident and theft.

DO NOT remote start the vehicle in a closed garage. Make sure that the garage door is open or there is adequate
ventilation. Failure to observe this rule could result in injury or death from poisonous Carbon Monoxide fumes.

REV. A 09/2002

This device complies with FCC Rules part 15. Operation is subject to the following two conditions: 1)
This device may not cause interference, and (2) this device must accept any interference that may be
received, including interference that may cause undesired operation. The manufacturer is not
responsible for any radio or TV interference caused by unauthorized modification to this equipment.
Such modification could void the user's authority to operate the equipment.

OPERATION

REMOTE ENGINE STARTING - SUCCESSFUL START:

1. Press and release the remote start button.

2. Parking lights flash once, then turn ON along with the IGN/ACC
circuits

3. After a few seconds the Starter Motor engages. (Parking lights
and Acc circuits turn off while cranking.)

#1

LOCK/

UNLOCK

START

4. Engine Starts and Runs. Parking Lights and Acc turn back on,
Doors Lock.

5. Engine will remain running for programmed run time or until reset
with Brake pedal.

REMOTE ENGINE STARTING - UNSUCCESSFUL START

In the event that the engine does not start on the first attempt, the

TRANSMITTER BUTTONS

system shuts down for a few seconds, then attempts to restart the
engine a 2

nd

and 3rd time. For hard starting engines, the unit will
allow a starter crank time of up to a maximum of10 seconds. This should provide ample cranking time for difficult starts,
but is limited to help prevent damage to the starter from over cranking in the case of a malfunctioning unit.

1. If engine starts on 2

nd

or 3rd attempt, see steps 4 & 5 above of "Successful Start".

2. If Third attempt fails to start engine, the system will turn off and doors will remain locked. NO FURTHER ATTEMPTS

WILL BE MADE AUTOMATICALLY

TURNING OFF A REMOTE STARTED ENGINE:

1. Engine is running in Remote Start (Parking lights are ON).

2. Press and release the Remote Start button again.

3. Engine turns & parking lights OFF, Doors remain locked or will re-lock/re-arm if applicable.

KEYLESS ENTRY (POWER DOOR LOCK CONTROL) (OPTIONAL)

This system enables you to remotely lock and unlock the vehicle’s doors (if equipped with power locks) through the
transmitter for safety and convenience. This feature may require extra labor and/or parts to install. Press the
Lock/Unlock button on the transmitter as you leave or come near the vehicle. Parking lights will flash 1X for lock and
2X’s for unlock.

NOTES: Doors lock automatically when vehicle is Remote Started. Starter Disable/Anti-grind is also enabled/disabled
with the lock/unlock button. If an anti-grind/starter kill relay is installed on a vehicle without power door locks, the
lock/unlock button of the remote control must still be used to operate the Starter disable. We recommend installing the
LED also when installing the Optional Starter Disable, as this will be your only indicator that it is active.

#2

REMOTE

START

CAR 1-2