Crimestopper RS-1405DP, RS-1505DP Operator's Manual

RS-1405DP/RS-1505DP

DP SERIES II (Data port)

1-Way Paging Remote Engine Starting & Keyless
Entry System with 5 Button Sidekick Remote Control

OPERATING INSTRUCTIONS

-PRIMARY: These are features that must be connected in order for the system to operate properly i.e.

Remote Start connections, Flashing lights, Brake Reset. For programming, the hood pin and program button
are required.

-OPTIONAL: These are features are to be connected only if desired or agreed upon by the customer and the
installing dealer i.e. Door Locks, Trunk Pop, Dome Light Illumination, Horn-Honk, Anti-Grind, etc. These
features may also require additional parts and/or labor fees. Consult with your installer beforehand to be sure
of what is going to be installed with your particular system.

TECHNICAL SUPPORT: [phone]

Monday - Friday 8:00am - 4:30pm Pacific Std. Time
Web Site: www.crimestopper.com
E-mail: [e-mail]

CRIMESTOPPER SECURITY PRODUCTS, INC.
1770 S. TAPO STREET, SIMI VALLEY, CA. 93063

This device complies with FCC Rules part 15. Operation is
subject to the following two conditions: 1) This device may not
cause interference, and (2) this device must accept any
interference that may be received, including interference that
may cause undesired operation. The manufacturer is not
responsible for any radio or TV interference caused by
unauthorized modification to this equipment. Such
modification could void the user's authority to operate the
equipment.

REV B – 8.2006

2

TABLE OF CONTENTS

Operation Cautions & Warnings….………………..….…………………………………….……………….….………2

Remote Operation………………………………………………………………………………………………..…....….3

Remote Engine Starting ,Idle Down Mode, Infinity Run Mode, ………………………………………….…....…..4-7

Turbo Timer Mode……………………………….……………………………………...…………………….…..….…..8
Convenience and Safety Features…………………………….………………..………………………..….…..….9-10

Transmitter Programming….…………….………………………………………….……………….…..…….….....…11

2 Vehicle Operation.………………………………….………………...……………………..………...………………12
Troubleshooting “Before You Call”………….…………..………………………………………….…………..….12-13

OPERATION CAUTIONS & WARNINGS

CRIMESTOPPER SECURITY PRODUCTS, INC. and its VENDORS shall not be liable for any accident
resulting from the use of this equipment. This system is designed to be professionally installed into a car or
vehicle in which all items, such as parking brake and all associated components, door switches, transmission
shift linkage, throttle linkage, and all engine safety features, are in perfect working condition.

DO NOT install the Remote Engine Starting System on MANUAL TRANSMISSION vehicles. If
accidentally left in gear the vehicle could become a self-propelled threat to life and property.

IT IS ABSOLUTELY THE OWNER’S SOLE RESPONSIBILITY TO: A) Understand the operation of this
system and its safety features. B) Check for proper operation of the system prior to accepting delivery of the
vehicle from the installation facility. C) Check and maintain the condition of the vehicle and all items relative to
the proper operation of this system and its safety features. D) Always leave the doors and windows closed
and locked to protect against accident and theft.

DO NOT remote start the vehicle in a closed garage. Make sure that the garage door is open or there is
adequate ventilation. Failure to observe this rule could result in injury or death from poisonous Carbon
Monoxide fumes.

3

REMOTE OPERATION

START

LOCK

UNLOCK

REMOTE

#4

#3

#2

#1

2ND VEHICLE

TRUNK

(AUX#3)

(AUX#2)

(AUX#4)

STARTER

#5

COOL START

(2ND FUNCTION)

The transmitter supplied with the RS-1405DP II/1505DP II system has five buttons. The button configuration
of the RS-1405DP II/1505DP II is Factory-set and unchangeable. See Page 12 for additional information on
how to use your remote to operate a second vehicle equipped with a CoolStart system.

NOTE: BUTTON #4 and #3 Remote Start/Trunk

There is a deliberate delay or 2 presses (Optional) built into the system on button #4 and #3 to help prevent
accidental remote starting from the remote being in your pocket or purse. During normal use, if you press
button #4 or #3 too quickly, the system may not start the engine or open trunk.

Replacement Battery

GP23A (12volt)

§

AUX

#

4: Pres

s button 5 then press button

4.

OPERATION:

BUTTON 1 (Lock Symbol):

• Press and release to Lock doors.

• Press and Hold for more than 3 seconds to activate

“Panic” feature.

BUTTON 2 (Unlock Symbol):

• Press and release to Unlock doors.

For RS-1505DP II only (Driver Door Priority Unlock)

• Press 2 times for Driver Door Priority Unlock.

BUTTON 3 (Trunk Symbol):

• Press and Hold for ½ second or press twice to

activate trunk pop.

BUTTON 4 (Start):

• Press and Hold for ½ second or press twice to

Start/Stop Engine.

BUTTON 5 (Vehicle #2/ 2nd Function)

§ AUX #2: Press button 5 then press button 1.

§ Press and Hold for 2 sec. for vehicle #2.

For RS-1505DP II only (AUX3/AUX4)

§ AUX #3: Press button 5 then press button 2.

4

REMOTE ENGINE STARTING

REMOTE ENGINE STARTING - SUCCESSFUL START:

1) Press the remote start button for at least 1/2 second (Default) or twice if set for double press.

2) Parking lights flash once; return solid, and the Ignition/Acc circuits turn on.

3) After a few seconds the Starter Motor engages, Parking lights and Acc circuits will turn off while cranking.

4) Engine Starts and Runs. Parking Lights and Acc turn back on, Doors Lock.

5) Engine will remain running for programmed run time until reset with Brake pedal. If needed, the engine can
be turned off with remote transmitter by pressing and releasing or double press the Start button.

AFTER

IGN

4

STARTER

THEN

FLASH 1X

SOLID

SOLID

SEC.

REMOTE ENGINE STARTING - UNSUCCESSFUL START

In the event that the engine does not start on the first attempt, the system shuts down for a few seconds, and
then attempts to restart the engine a 2nd and 3rd time. For hard starting engines, the unit will allow a starter
crank time of up to 10 seconds maximum. This should provide ample cranking time for difficult starts, but is
limited to 13 seconds to help prevent damage to the starter from over cranking.

1) If engine starts on 2nd or 3rd attempt, see steps 4 & 5 above of "Successful Start".

2) If Third attempt fails to start engine, the system will turn off and doors will remain locked.

NO FURTHER ATTEMPTS W ILL BE MADE AUTOMATICALLY

TURNING OFF A REMOTE STARTED ENGINE:

1) Engine is running in Remote Start (Parking lights ON).

2) Press and release the remote start button.

3) Engine & parking lights OFF, Doors re-lock/re-arm.

5

REMOTE ENGINE STARTING Cont.

ENTERING YOUR REMOTE STARTED VEHICLE:

1) With engine running, Remote Unlock system (If equipped) or open door with key.

2) Enter vehicle and be careful not to step on brake pedal! (Remote Start Reset).

3) Turn Ignition to ON/RUN position, then press brake pedal to reset the Remote Starter & Shift out of park.

4) Remote starter will reset instantly when the brake is pressed. Parking lights will turn off and the ignition key
is now controlling your vehicle.

REMOTE START RUN TIME RESET:

You can now reset the engine-run timer to allow for more running time after remote start has already occurred
using the remote control. After a successful remote start, press both the Lock & Unlock buttons together for at
least 2 seconds. The parking lights will flash 3 times and internal engine timer will reset back to zero minutes.

REMOTE ENGINE STARTING Cont. (IDLE DOWN MODE)

IDLE DOWN MODE:

This mode allows the unit to take over operation of the parked vehicle while the ignition key is removed and
you exit the vehicle. The vehicle is put into a remote running condition before you exit and it will remain
running for the programmed run time or until you come back.

Examples:

• You pull up to a convenience store for a quick stop, "Idle Down" mode keeps engine running when you exit the
vehicle, (with keys in hand) remote lock doors or arm alarm. When you return, unlock, turn ignition ON and drive
away.