Crimestopper CA-5012 Installation Manual

CA-5012 /Wireless /Top mount / under dash

mount Reverse Parking Sensor

Features:

• 2-Digit LED Numerical Distance Display (in
feet)

• Multi-Colored Bar Graph Display

• Audible Tones With Three Distinct Warnings

DISCLAIMER:
Under no circumstances shall the manufacturer or distributor of the Back

Stopper™ be held liable for consequential or incidental damages sustained
in connection with the use or installation of the Back Stopper™ Rear
Detection System. The Back Stopper™ is designed as a safety
enhancement device and is in no way intended as a replacement for rear­view mirrors, side-view mirrors or physically checking the surroundings
when backing a vehicle. Always check surroundings for safety when
backing!

TWO DISPLAY TYPES ARE AVAILABLE:

1. Top of dash mount

2. Under dash mount

LOCATING THE SENSORS:

SENSOR INSTALLATION:

1. Carefully measure and mark sensor locations. Measure,
double-check and check again. You are making permanent
modification to the vehicle , make sure spacing and angles
are correct!

2. Use the supplied 22M M hole sale drill to make sensor holes.

3. Route cable through hole.

4. Gently press in sensor. Hole clearance is critical, make sure
sensor fits snugly, but not over-tight. Crushed se nsors will
provide inaccurate readings and false alarms.

SENSOR ANG LE:

SIDE VIEW

Horizontal

NO!

Ground may interfere
with sensor.

0-10 degree upward

Optimum

performance

Downward

O.K.

(May n ot detect
small or low to
ground ob jects.)

WARNING! Before drilling the hole, make sure that the sensor will not be angling

towards the ground causing the sensor to continuously beep!