CREVIS G Series, GN-9284 Quick Start Manual

Quick

Start Guide

G-Series Remote IO

1

2

3

Introduction

Example
System

Connections

4

Install CSP
Profile

5

PLC Ethernet
Setup

6

Network
Configuration

7

Download
Settings

8

Monitor
Data

GN-9284
CC-Link IE Field Basic

1 Introduction

Ethernet

Crevis Remote IO

FX5UC-32/DSS-TS

Figure 2.1: Sample System Layout

1.1 This guide contains brief configuration procedures for the GN-9284 CC-Link IE Field Basic Remote IO adaptor.
This adaptor functions as a slave on programmable logic controllers and other devices that function as a CC-Link IE Field
Basic master. For the purposes of this quick start guide, the focus will be on GX-Works3 compatible products like the iQ­F and iQ-R PLCs.

2 Example System Layout

2.1 This section is a system example that will be utilized for this guide. For simplicity, the system will be limited to a
master PLC and a single slave GN-9284 adaptor.

PLC: FX5UC-32MT/DSS-TS
Remote IO: GN-9284
Slice #1: GT-1238 8 pt, IN
Slice #2: GT-2328 8 pt, OUT
Slice #3: GT-3424 4 pt, Analog IN
Slice #4: GT-4424 4 pt, Analog OUT

Page 2

24 VDC

0 VDC

System Power

0 VDC

Field Power

24 VDC

GND

Figure 3.1: Adaptor Power Connections

Figure 4.1: Register Profile

3 Connections

3.1 Wire the system and field power as in Figure 3.1.

4 Register Profile

4.1 Download the GN-9284 CSPP profile and register in GX-Works3.

Tool  Profile Management  Register

Page 3