Crestron TPMC-4XG-BTP Operations & Installation Manual

Crestron TPMC-4XG-BTP
Internal Battery Pack for TPMC-4XG
Operations & Installation Guide

This document was prepared and written by the Technical Documentation department at:

Crestron Electronics, Inc.

15 Volvo Drive

Rockleigh, NJ 07647

1-888-CRESTRON

All brand names, product names and trademarks are the property of their respective owners.

©2008 Crestron Electronics, Inc.

Crestron TPMC-4XG-BTP Internal Battery Pack for TPMC-4XG

Contents

Internal Battery Pack for TPMC-4XG: TPMC-4XG-BTP 1

Introduction ...............................................................................................................................1

Features and Functions................................................................................................ 1

Specifications ..............................................................................................................2

Physical Description.................................................................................................... 2

Industry Compliance ...................................................................................................3

Handling ...................................................................................................................... 3

Storage.........................................................................................................................3

Setup .......................................................................................................................................... 4

Charging ...................................................................................................................... 4

Installation................................................................................................................... 4

Removal ......................................................................................................................5

More Information.......................................................................................................................6

Reference Documents..................................................................................................6

Further Inquiries..........................................................................................................6

Future Updates ............................................................................................................6

Return and Warranty Policies....................................................................................................7

Merchandise Returns / Repair Service ........................................................................7

CRESTRON Limited Warranty...................................................................................7

Operations & Installation Guide – DOC. 6657A Contents • i

Crestron TPMC-4XG-BTP Internal Battery Pack for TPMC-4XG

Internal Battery Pack for
TPMC-4XG: TPMC-4XG-BTP

Introduction

Features and Functions

• Lithium Ion rechargeable battery pack for the TPMC-4XG

NOTE: For more information on the TPMC-4XG touchpanel, refer to
the latest version of the TPMC-4XG Isys i/O™ Handheld WiFi
Touchpanel Operations Guide (Doc. 6655), which is available from the
Crestron website (http://www.crestron.com/manuals

NOTE: For more information on the TPMC-4XG-DS, refer to the latest
version of the TPMC-4XG-DS Desktop Docking Station/Charger guide
(Doc. 6656).

WiFi Touchpanel

• Can be charged when TPMC-4XG is mounted in the
TPMC-4XG-DS Docking Station/Charger (sold separately)

).

Operations & Installation Guide – DOC. 6657A Internal Battery Pack: TPMC-4XG-BTP • 1

Internal Battery Pack for TPMC-4XG Crestron TPMC-4XG-BTP

Specifications

Specifications for the TPMC-4XG-BTP are listed in the following table.

TPMC-8X-BTP Specifications

SPECIFICATION DETAILS

Battery
Output Voltage 3.7 Volts DC
Capacity 1800 mAh
Composition Lithium Ion (Li-Ion)
Charging time 2 hours 50 minutes
Weight 1.4 oz (40 g)

Physical Description

The TPMC-4XG-BTP has a multi-pin connector for attachment inside
the battery compartment of the TPMC-4XG.

TPMC-4XG-BTP Physical View

2 • Internal Battery Pack: TPMC-4XG-BTP Operations & Installation Guide – DOC. 6657A

Crestron TPMC-4XG-BTP Internal Battery Pack for TPMC-4XG

Industry Compliance

As of the date of manufacture the TPMC-4XG-BTP has been tested and
found to comply with specifications for CE marking and standards per
EMC and Radiocommunications Compliance Labelling.

Handling

NOTE: The TPMC-4XG-BTP contains a Lithium Ion (Li-Ion) battery.
When the unit can no longer retain a charge, it must be recycled or
disposed of properly. Follow local ordinances and/or regulations for
disposal.

To prevent damage to multi-pin connector and wiring, use care when
handling the TPMC-4XG-BTP.

Storage

The TPMC-4XG-BTP can be stored in a temperate, dry place (removed
from the touchpanel and docking station) indefinitely without significant
irreversible degradation of its performance. The self-discharge rate is a
function of temperature and internal resistance. High temperature storage
reduces charge retention. Best results occur if the TPMC-4XG-BTP is
stored at an optimal temperature of 32° to 104°F (0° to 40°C). After an
extended period of storage, initiate a few charge/discharge cycles to
restore full capacity.

Operations & Installation Guide – DOC. 6657A Internal Battery Pack: TPMC-4XG-BTP • 3

Internal Battery Pack for TPMC-4XG Crestron TPMC-4XG-BTP

Setup

Charging

NOTE: A Lithium Ion (Li-Ion) battery typically provides 300-500
charge/discharge cycles.

To charge the TPMC-4XG-BTP, install the TPMC-4XG-BTP in a
TPMC-4XG touchpanel and mount the touchpanel on an AC powered
TPMC-4XG-DS Docking Station/Charger (sold separately).

NOTE: The battery pack may take up to three hours to charge in a
powered touchpanel if the panel is in use during charging.

Installation

Use the following procedure to install the TPMC-4XG-BTP in a
TPMC-4XG touchpanel:

1. Place the touchpanel screen side down on a clean, soft surface.

2. Remove the battery compartment cover on the rear of the
touchpanel.

3. Place the TPMC-4XG-BTP in the battery compartment oriented so
the multi-pin connector is on the top.

4. Carefully connect the multi-pin connector of the TPMC-4XG-BTP
with the corresponding connector inside the battery compartment.
The pin side of the connector should be facing downward (toward
the front of the TPMC-4XG).

NOTE: When installing the battery in the TPMC-4XG, ensure the
connecting wires are not under the battery. Refer to the photo on the
following page for proper wire routing.

5. Re-attach the battery compartment cover.

NOTE: To prevent battery drain during shipment or for long-term

storage, the TPMC-4XG has a battery switch inside the battery
compartment. To use the internal battery, move the switch to the left (on)

4 • Internal Battery Pack: TPMC-4XG-BTP Operations & Installation Guide – DOC. 6657A

Crestron TPMC-4XG-BTP Internal Battery Pack for TPMC-4XG

position. To conserve battery power when the unit will not be used for
extended periods, move the switch to the right (off) position.

TPMC-4XG-BTP in Battery Compartment of TPMC-4XG

Removal

Use the following procedure to remove the TPMC-4XG-BTP from a
TPMC-4XG touchpanel:

1. Place the touchpanel screen side down on a clean, soft surface.

2. Remove the battery compartment cover on the rear of the
touchpanel.

3. Using the flat end of a small slot head screwdriver, gently pry the
multi-pin connector off the corresponding connector in the battery
compartment of the TPMC-4XG.

4. With the multi-pin connector detached from the TPMC-4XG, lift
the TPMC-4XG-BTP out of the battery compartment.

Operations & Installation Guide – DOC. 6657A Internal Battery Pack: TPMC-4XG-BTP • 5

Internal Battery Pack for TPMC-4XG Crestron TPMC-4XG-BTP

More Information

Reference Documents

The latest version of all documents mentioned within the guide can be
obtained from the Crestron website (http://www.crestron.com/manuals
This link will provide a list of product manuals arranged in alphabetical
order by model number.

List of Related Reference Documents

DOCUMENT TITLE

TPMC-4XG Isys i/O™ Handheld WiFi Touchpanel
TPMC-4XG-DS Desktop Docking Station/Charger

).

Further Inquiries

If you cannot locate specific information or have questions after
reviewing this guide, please take advantage of Crestron's award winning
customer service team by calling Crestron at 1-888-CRESTRON
[1-888-273-7876].

You can also log onto the online help section of the Crestron website
(www.crestron.com/onlinehelp
First-time users will need to establish a user account to fully benefit from
all available features.

) to ask questions about Crestron products.

Future Updates

As Crestron improves functions, adds new features and extends the
capabilities of the TPMC-4XG-BTP, additional information may be
made available as manual updates. These updates are solely electronic
and serve as intermediary supplements prior to the release of a complete
technical documentation revision.

Check the Crestron website periodically for manual update availability
and its relevance. Updates are identified as an “Addendum” in the
Download column.

6 • Internal Battery Pack: TPMC-4XG-BTP Operations & Installation Guide – DOC. 6657A

Crestron TPMC-4XG-BTP Internal Battery Pack for TPMC-4XG

Return and Warranty Policies

Merchandise Returns / Repair Service

1. No merchandise may be returned for credit, exchange or service without prior authorization
from CRESTRON. To obtain warranty service for CRESTRON products, contact an
authorized CRESTRON dealer. Only authorized CRESTRON dealers may contact the factory
and request an RMA (Return Merchandise Authorization) number. Enclose a note specifying
the nature of the problem, name and phone number of contact person, RMA number and
return address.

2. Products may be returned for credit, exchange or service with a CRESTRON Return
Merchandise Authorization (RMA) number. Authorized returns must be shipped freight
prepaid to CRESTRON, 6 Volvo Drive, Rockleigh, N.J. or its authorized subsidiaries, with
RMA number clearly marked on the outside of all cartons. Shipments arriving freight collect
or without an RMA number shall be subject to refusal. CRESTRON reserves the right in its
sole and absolute discretion to charge a 15% restocking fee plus shipping costs on any
products returned with an RMA.

3. Return freight charges following repair of items under warranty shall be paid by CRESTRON,
shipping by standard ground carrier. In the event repairs are found to be non-warranty, return
freight costs shall be paid by the purchaser.

CRESTRON Limited Warranty

CRESTRON ELECTRONICS, Inc. warrants its products to be free from manufacturing defects in materials
and workmanship under normal use for a period of three (3) years from the date of purchase from
CRESTRON, with the following exceptions: disk drives and any other moving or rotating mechanical
parts, pan/tilt heads and power supplies are covered for a period of one (1) year; touchscreen display and
overlay components are covered for 90 days; batteries and incandescent lamps are not covered.

This warranty extends to products purchased directly from CRESTRON or an authorized CRESTRON
dealer. Purchasers should inquire of the dealer regarding the nature and extent of the dealer's warranty, if
any.

CRESTRON shall not be liable to honor the terms of this warranty if the product has been used in any
application other than that for which it was intended or if it has been subjected to misuse, accidental
damage, modification or improper installation procedures. Furthermore, this warranty does not cover any
product that has had the serial number altered, defaced or removed.

This warranty shall be the sole and exclusive remedy to the original purchaser. In no event shall
CRESTRON be liable for incidental or consequential damages of any kind (property or economic damages
inclusive) arising from the sale or use of this equipment. CRESTRON is not liable for any claim made by a
third party or made by the purchaser for a third party.

CRESTRON shall, at its option, repair or replace any product found defective, without charge for parts or
labor. Repaired or replaced equipment and parts supplied under this warranty shall be covered only by the
unexpired portion of the warranty.

Except as expressly set forth in this warranty, CRESTRON makes no other warranties, expressed or
implied, nor authorizes any other party to offer any warranty, including any implied warranties of
merchantability or fitness for a particular purpose. Any implied warranties that may be imposed by law are
limited to the terms of this limited warranty. This warranty statement supersedes all previous warranties.

Trademark Information

All brand names, product names and trademarks are the sole property of their respective owners. Windows is a registered trademark
of Microsoft Corporation. Windows95/98/Me/XP/Vista and WindowsNT/2000 are trademarks of Microsoft Corporation.

Operations & Installation Guide – DOC. 6657A Internal Battery Pack: TPMC-4XG-BTP • 7

Crestron Electronics, Inc. Operations & Installation Guide – DOC. 6657A

15 Volvo Drive Rockleigh, NJ 07647 (2021834)
Tel: 888.CRESTRON 07.08
Fax: [phone] Specifications subject to
www.crestron.com change without notice.