Crestron ST-SPL User Manual

Infrared (IR) Splitter: ST-SPL

Description

Crestron’s ST-SPL is a splitter that distributes an IR signal so that more than one IR device can
be controlled from a single output port. As shown below, IR input to the unit is connected to the
port labeled IN via the supplied 6-foot cable with 3.5mm mini-phone plugs at each end. The
five ST-SPL output ports (labeled OUT) can be connected to any combination of five IR probes
(STIRP) and/or Master Blaster IR Sprayers (ST-MB/STI-MB).

ST-SPL Physical Views

3.25 in

(8.23 cm)

OUT OUT OUT

CONNECTORS LABELED

OUT

CONNECT TO ANY

COMBINATION OF STIRP,

ST-MB, OR STI-MB

CRESTRON

ST-SPL

IR SPLITTER

OUT OUT

IN

1.24 in

(3.14 cm)

1.97 in

(5.00 cm)

FROM IR EMITTER

DEVICE OUTPUT

The ST-SPL enclosure extends to form mounting flanges at the sides of the unit. There are
three holes per flange for installing screws (not supplied) to mount the unit.

NOTE: When incorporating the ST-SPL into a Cresnet system, care must be used when programming,
since all the devices controlled by a single ST-SPL share the same Serial Mouse Control Driver IR
port.

NOTE: Crestron devices utilizing this type of port connector include the following: CEN-TVAV, CN-TVAV,
CNX-DAPRC, CNX-RMC, CNX-RMCLV, and ST-CP. The ST-SPL may also be connected to the 2-pin
type IR port of any Crestron CNX Generation control system using an additional (Crestron part number
CNSP-112) cable. For cables for 2-Series control systems, contact Crestron customer service.

Further Inquiries

If after reviewing this sheet you cannot locate specific information or have questions, please
take advantage of Crestron's award winning customer service team by calling:

• In the US and Canada, call Crestron’s corporate headquarters at
1-888-CRESTRON [1-888-273-7876] or 1-201-767-3400.

• In Europe, call Crestron International at [phone].

• In Asia, call Crestron Asia at [phone].

• In Latin America, call Crestron Latin America at [phone].

• In Australia, call Crestron Pacific at [phone].

6-ft CABLE

(SUPPLIED)

For local support from exclusive Crestron factory-trained personnel in New Zealand, call Amber
Technologies at [phone].

Crestron Electronics, Inc. Operations Guide – DOC. 5685A

15 Volvo Drive Infrared (IR) Splitter: ST-SPL
Rockleigh, NJ 07647 01.02
Tel: 888.CRESTRON Specifications subject to change without notice.
Fax: [phone] www.crestron.com

Return and Warranty Policies

Merchandise Returns / Repair Service

1. No merchandise may be returned for credit, exchange, or service without prior
authorization from CRESTRON. To obtain warranty service for CRESTRON
products, contact the factory and request an RMA (Return Merchandise
Authorization) number. Enclose a note specifying the nature of the problem,
name and phone number of contact person, RMA number, and return address.

2. Products may be returned for credit, exchange, or service with a CRESTRON
Return Merchandise Authorization (RMA) number. Authorized returns must be
shipped freight prepaid to CRESTRON, Cresskill, N.J., or its authorized
subsidiaries, with RMA number clearly marked on the outside of all cartons.
Shipments arriving freight collect or without an RMA number shall be subject to
refusal. CRESTRON reserves the right in its sole and absolute discretion to
charge a 15% restocking fee, plus shipping costs, on any products returned with
an RMA.

3. Return freight charges following repair of items under warranty shall be paid by
CRESTRON, shipping by standard ground carrier. In the event repairs are found
to be non-warranty, return freight costs shall be paid by the purchaser.

CRESTRON Limited Warranty

CRESTRON ELECTRONICS, Inc. warrants its products to be free from
manufacturing defects in materials and workmanship under normal use for a period
of three (3) years from the date of purchase from CRESTRON, with the following
exceptions: disk drives and any other moving or rotating mechanical parts, pan/tilt
heads and power supplies are covered for a period of one (1) year; touchscreen
display and overlay components are covered for 90 days; batteries and incandescent
lamps are not covered.

This warranty extends to products purchased directly from CRESTRON or an
authorized CRESTRON dealer. Purchasers should inquire of the dealer regarding the
nature and extent of the dealer's warranty, if any.

CRESTRON shall not be liable to honor the terms of this warranty if the product has
been used in any application other than that for which it was intended, or if it has
been subjected to misuse, accidental damage, modification, or improper installation
procedures. Furthermore, this warranty does not cover any product that has had the
serial number altered, defaced, or removed.

This warranty shall be the sole and exclusive remedy to the original purchaser. In no
event shall CRESTRON be liable for incidental or consequential damages of any
kind (property or economic damages inclusive) arising from the sale or use of this
equipment. CRESTRON is not liable for any claim made by a third party or made by
the purchaser for a third party.

CRESTRON shall, at its option, repair or replace any product found defective,
without charge for parts or labor. Repaired or replaced equipment and parts supplied
under this warranty shall be covered only by the unexpired portion of the warranty.

Except as expressly set forth in this warranty, CRESTRON makes no other
warranties, expressed or implied, nor authorizes any other party to offer any other
party to offer any warranty, including any implied warranties of merchantability or
fitness for a particular purpose. Any implied warranties that may be imposed by law
are limited to the terms of this limited warranty. This warranty statement supercedes
all previous warranties.

Trademark Information

All brand names, product names, and trademarks are the sole property of their respective owners.
Windows is a registered trademark of Microsoft Corporation. Windows95/98/Me/XP and
WindowsNT/2000 are trademarks of Microsoft Corporation.