Crestron STIRP User Manual

Installation Instructions

Infrared Emitter Crestron STIRP

CRESTRON STIRP

ATTACHING THE STIRP TO OTHER LOCATIONS

Rather than affixing the low output side of the STIRP shell directly over the IR sensor window, the shell can be positioned as much as three feet away on the axis of the IR sensor window. The high output side of the STIRP shell permits control at this greater distance. Placement of the STIRP on surfaces just above or below the IR sensor window, as shown below, may provide a more pleasing aesthetic appearance. However, be sure to position the STIRP shell so that the edge of the component does not block the IR signal. Also placing the STIRP shell on a cabinet door may result in interruption of the IR signal if the door is opened.

Shelves

Possible locations of STIRP shell attached to shelf directly below

CONNECTING THE STIRP

Insert the mono mini plug of the STIRP into one of the four IR OUT ports of the ST-CP, shown below. The STIRP can also connect to other Crestron devices such as the IR Splitter (ST-SPL) or SmartPresenter (SP-1).

or above IR sensor window

Infrared Emitter

Infrared Emitter Crestron STIRP

CRESTRON STIRP

ATTACHING THE STIRP TO OTHER LOCATIONS

Rather than affixing the low output side of the STIRP shell directly over the IR sensor window, the shell can be positioned as much as three feet away on the axis of the IR sensor window. The high output side of the STIRP shell permits control at this greater distance. Placement of the STIRP on surfaces just above or below the IR sensor window, as shown below, may provide a more pleasing aesthetic appearance. However, be sure to position the STIRP shell so that the edge of the component does not block the IR signal. Also placing the STIRP shell on a cabinet door may result in interruption of the IR signal if the door is opened.

Shelves

Possible locations of STIRP shell attached to shelf directly below

CONNECTING THE STIRP

Insert the mono mini plug of the STIRP into one of the four IR OUT ports of the ST-CP, shown below. The STIRP can also connect to other Crestron devices such as the IR Splitter (ST-SPL) or SmartPresenter (SP-1).

or above IR sensor window

Infrared Emitter

12 VDC

IR Sensor

Window

.5A

PCNET

COMA

COMB

IR OUT

ABCD

RF

12 VDC

.5A

VCR

IR Sensor

Window

Crestron Electronics, Inc.

15 Volvo Drive Rockleigh, NJ 07647 Tel: 888.CRESTRON / 201.767.3400 Fax: 201.767.7576 / BBS: 201.767.5506 www.crestron.com

Specifications subject to change without notice.

Doc. 5674A

06.99