DO GUIDE
From
For
From
HD-SCALER-HD-E/HD-SCALER-VGA-E
High-Denition Video Scalers
DO Check the Box
QTY PRODUCT PART NUM.
1 Power Pack, 5 Vdc 1.2 A, 100-240 Vac 2028121
Not Incl uded: Cab les, Mou nting Scr ews
DO Install the Device
®
The Crestron
or onto a rack rail.
Mounting onto a Flat Surface
Using four mounting screws (not included), mount the device onto a at surface. Mounting of the
HD-SCALER-HD-E onto a wall is shown in illustration .
Mounting onto a Flat Surface
Mounting onto a Rack Rail
The HD-SCALER-HD-E and HD-SCALER-VGA-E mount onto the front or rear rail of a rack.
Position either the left or right mounting ange of the device so that the holes align with the
holes in the rack. Then, secure the device to the rack using two rack mounting screws (not
included). Mounting of the HD-SCALER-HD-E onto a rack rail is shown in illustration .
Mounting onto a Rack Rail
HD-SCALER-HD-E and HD-SCALER-VGA-E can be mounted onto a at surface
DO Make Connections to the Rear Panel
Make connections to the front and rear panels of the device as appropriate for the installation.
Refer to illustrations through .
Connections to the Front Panel (HD-SCALER-HD-E and HD-SCALER-VGA-E)
®
To HDMI
Display or
Receiver
Connections to the Rear Panel (HD-SCALER-HD-E Only)
From HDMI
Audio/Video
Source
Connections to the Rear Panel (HD-SCALER-VGA-E Only)
Analog
Audio
Source
To Analog Audio
Output Device
Factory
Use
Only
Power
Pack
(Included)
From VGA
Video Source
From
Analog
Audio
Source
For
Factory
Use
Only
From
Power
Pack
(Included)
DO Use the On-Screen Display
By default, the HD-SCALER-HD-E and HD-SCALER-VGA-E automatically detect the display
settings of the connected display and output the preferred resolution of the display. If desired,
use the on-screen display (OSD) to change the output resolution or to adjust image quality.
To access the OSD and to select a menu item, press the MENU/ENTER button as required.
To navigate up or down in a menu or to adjust the value of a menu selection, press the UP or
DOWN button as required.
HD-SCALER-HD-E
As of the date of manufacture, the product has been tested and found to comply with specicatio ns for CE ma rking.
Federal Communications Commission (FCC) Compliance Statement
This device complies wi th part 15 of the FCC Rules. Operation i s subject to the following two conditions:
(1) This devic e may not cause har mful interference, a nd (2) this device must accept any interference received, including inter fere nce
that may cause undesired operation.
Caution: Chang es or modications not ex pressly appr oved by the manufac turer responsible for compliance could void th e user’s
author ity to op erate the equipment.
Note: This equipment ha s been te sted and found to comply with the limi ts for a Class B digi tal devi ce, pur suant to part 15 of the
FCC Rules. These limits are designed to provide reasonable prote ction against harmful inter ference in a residential installation.
This equipmen t gener ates, uses and can radia te radio frequency energy and, if not inst alled and used in accordance with the
instruction s, may cau se harm ful interference to radio comm unications. However, there is no guarantee that inter feren ce will no t
occur in a parti cular installation.
DO GUIDE
DO Learn More
HD-SCALER-VGA-E
Visit the website for additional information and the latest rmware updates.
Crestron Electronics
15 Volvo Drive, Rockleigh, NJ 07647
888.CRESTRON | www.crestron.com
If this equipment does cause har mful interference to r adio or television reception, wh ich can b e determined by tu rning th e
equipment off and on, the user is e ncouraged to tr y to correct the i nterferenc e by one or mo re of the following measures:
• Reorient or relocate the receiving antenna
• Increase the separation be tween t he equipment an d recei ver
• Connect the e quipment into an outlet on a circuit diffe rent from that to which the re ceiver is conne cted
• Consult the dealer or an exper ience d radio/TV technician for h elp
Industry Canada (IC) Compliance Statement
CAN ICES-3(B)/NMB-3(B)
The speci c patents that c over Crestron pro ducts are listed a t patents.crestron.com. The produ ct warranty ca n be found at www.crestron.com/warranty.
Crestr on and the Cre stron lo go are eithe r trademar ks or regist ered trade marks of Cr estron El ectronic s, Inc. in the U nited St ates and /or other cou ntries. H DMI and th e HDMI log o are either
trademar ks or regist ered trad emarks of HD MI Licen sing LLC in t he United S tates and /or other co untries . Other tra demarks, r egistere d trademar ks, and tra de names may be us ed in this
document t o refer to either t he entities claim ing the marks and na mes or their produ cts. Crestr on disclaims any pr oprietary i nterest in the ma rks and names of ot hers. Crest ron is not respon sible
for error s in typography o r photography.
This docum ent was written by t he Technical Publicat ions departmen t at Crestron.
©2015 Crestron Electronics, Inc.
DOC. 77 78A (2043 690 ) 03.15
Specic ations subject to c hange without not ice.
Loading...