Page 1
HD-DA4-4KZ-E
1:4 HDMI® Distribution Amplifier w/4K60 4:4:4 & HDR Support
> Splits one HDMI® source to four outputs
> Handles 4K60 4:4:4 and HDR video signals
> Fully compatible with HD 1080p, UHD 4K, and DCI 4K sources
and displays
> Handles 3D video and Deep Color
> Handles Dolby® TrueHD, Dolby Atmos®, DTS HD®, DTS:X®, and
uncompressed 7.1 linear PCM audio
> Selectable handling of HDCP 2.2 or HDCP 1.4
> EDID management options
> Input and output video presence indication
> No programming or control system required
> Thin profile – less than one inch deep
> Surface, shelf, or single rack rail mountable
> External 100-240V universal power pack included
The Crestron® HD-DA4-4KZ-E is a simple to use, high-performance 4K
AV distribution amplifier designed to split a single HDMI® signal to feed
up to four separate displays, switchers, and/or other devices. It provides
full support for UHD and DCI 4K60 4:4:4 and HDR video, HDCP 1.4 or 2.2
copy protection, and high-bitrate 7.1 audio, to ensure optimal performance
and compatibility for any HD or 4K video application. No programming or
control system is required for operation.
[1]
For smaller or larger applications, refer to models HD-DA2-4KZ-E
and HD-DA8-4KZ-E.
SPECIFICATIONS
Video
Input Signal Type: HDMI w/HDR10, Deep Color, 3D, & 4K60 4:4:4 support
(DVI & Dual-Mode DisplayPort compatible
Output Signal Type: HDMI w/HDR10, Deep Color, 3D, & 4K60 4:4:4
support
[1]
(DVI compatible
[2]
)
Copy Protection: Selectable for HDCP 2.2, HDCP 1.4, or HDCP disabled
Maximum Resolutions:
Scan
Type
Resolution
4096x2160 DCI 4K
&
Progressive
3840x2160 4K UHD
2560x1600 WQXGA 60 Hz 4:4:4 36 bit
1920x1080 HD1080p 60 Hz 4:4:4 36 bit
Interlaced 1920x1080 HD1080i 30 Hz 4:4:4 36 bit
NOTE: Common resolutions are shown; other resolutions are supported at
pixel clock rates up to 600 MHz
[2]
Frame
Rate
24 Hz 4:4:4 36 bit
30 Hz 4:4:4 36 bit
60 Hz 4:2:2 36 bit
60 Hz 4:4:4 24 bit
[1]
Audio
Input Signal Type: HDMI (Dual-Mode DisplayPort compatible
[2]
)
Output Signal Type: HDMI
Formats: Dolby Digital®, Dolby Digital EX, Dolby Digital Plus, Dolby TrueHD,
Dolby Atmos, DTS®, DTS-ES, DTS 96/24, DTS HD High Res, DTS HD Master
Audio, DTS:X, LPCM up to 8 channels
Communications
USB: USB 2.0 host; supports firmware update and custom EDID upload
via a USB flash drive
HDMI: HDCP & EDID (does not pass CEC)
HDCP Version: Selectable for HDCP 2.2, 1.4, or OFF;
HDCP encrypted content is blanked in OFF mode
EDID Mode: Selectable for DEFAULT or COPY 1ST;
• The factory default EDID is 4K60 4:4:4 non-HDR video with
2-channel LPCM audio;
• The factory default EDID can be replaced with a custom EDID
[1]
)
via USB;
• Sliding the switch from DEFAULT to COPY 1ST copies and stores
the EDID from the device at OUTPUT 1 and passes it to the INPUT
source device;
• Sliding the switch from COPY 1ST to DEFAULT erases the stored
EDID and uses the factory default or custom EDID;
Note: Changing the device at OUTPUT 1 will not update the stored
Color
Sampling
Color
Depth
EDID until the switch is moved to DEFAULT and back to COPY 1ST
Connectors
INPUT: (1) HDMI Type A connector, female;
HDMI digital video/audio input
(DVI & Dual-Mode DisplayPort compatible
[1]
;
[2]
)
OUTPUT 1 – 4: (4) HDMI Type A connectors, female;
HDMI digital video/audio outputs
(DVI compatible
[2]
)
[1]
;
SERVICE: (1) USB Type A connector, female;
USB 2.0 host port;
For firmware update and custom EDID upload via a USB flash drive
crestron.com | 800.237.2041
Page 2
HD-DA4-4KZ-E 1:4 HDMI
®
Distribution Amplifier w/4K60 4:4:4 & HDR Support
HD-DA4-4KZ-E – Front View
HD-DA4-4KZ-E – Rear View
24VDC 0.75A: (1) 2.1 x 5.5 mm DC power connector;
24 Volt DC power input;
PW-2407WU power pack included
Controls & Indicators
PWR: (1) Bi-color LED, indicates operating power is supplied via the
power pack; illuminates amber while booting, green when operating
SETUP: (1) Pushbutton and (1) red LED, restores factory settings
RESET: (1) Recessed pushbutton for hardware reset
INPUT: (1) Green LED, indicates video signal presence at the HDMI input
OUTPUT 1 – 4: (4) Green LEDs, each indicates video signal transmission
at the corresponding HDMI output
HDCP: (1) 3-position slide switch, selects the HDCP version (OFF, 1.4,
or 2.2)
EDID: (1) 2-position slide switch, selects the EDID mode (DEFAULT or COPY
1ST)
Power
Power Pack (included): Input: 100-240 Volts AC, 50/60 Hz;
Output: 0.75 Amps @ 24 Volts DC;
Model: PW-2407WU
Environmental
MODELS & ACCESSORIES
Available Models
HD-DA4-4KZ-E: 1:4 HDMI® Distribution Amplifier w/4K60 4:4:4 &
HDR Support
Included Accessories
PW-2407WU: Wall Mount Power Pack, 24VDC, 0.75A, 2.1mm, Universal
(Qty. 1 included)
Available Accessories
CBL-HD Series: High-Speed HDMI® Cables
Notes:
1. 4K60 4:4:4 and HDR support requires the use of HDMI cables and couplers with a minimum
TMDS bandwidth of 18 Gbps. If 4K60 4:2:0 or 4K30 4:4:4 performance is acceptable, cables
and couplers with a minimum bandwidth of 10.2 Gbps may be used. Please be aware that
bandwidth loss is cumulative, so performance may be reduced when inserting multiple cables
and couplers inline.
2. HDMI requires an appropriate adapter or interface cable to accommodate a DVI or Dual-Mode
DisplayPort signal. CBL-HD-DVI interface cables are available separately.
This product may be purchased from an authorized Crestron dealer. To find a dealer, please contact
the Crestron sales representative for your area. A list of sales representatives is available online at
https://www.crestron.com/How-To-Buy/Find-a-Representative or by calling 855-263-8754.
Temperature: 32° to 104° F (0° to 40° C)
Humidity: 10% to 90% RH (non-condensing)
Enclosure
Chassis: Metal, black finish, with (2) integral mounting flanges
Mounting: Freestanding, surface mount, or attach to a single rack rail
Dimensions
Height: 0.87 in (22 mm)
Width: 8.09 in (206 mm)
Depth: 4.67 in (119 mm)
Compliance
CE, IC, FCC part 15 Class B digital device
crestron.com | 800.237.2041
The specific patents that cover this and other Crestron products are listed online at
https://www.crestron.com/legal/patents.
Certain Crestron products contain open source software. For specific information, visit
https://www.crestron.com/opensource.
Crestron and the Crestron logo are either trademarks or registered trademarks of Crestron
Electronics, Inc. in the United States and/or other countries. Dolby, Dolby Atmos, and Dolby Digital
are either trademarks or registered trademarks of Dolby Laboratories in the United States and/or
other countries. DTS, DTS HD, and DTS:X are either trademarks or registered trademarks of DTS,
Inc. in the United States and/or other countries. HDMI and the HDMI Logo are either trademarks
or registered trademarks of HDMI Licensing LLC in the United States and/or other countries.
Other trademarks, registered trademarks, and trade names may be used in this document to refer
to either the entities claiming the marks and names or their products. Crestron disclaims any
proprietary interest in the marks and names of others. Crestron is not responsible for errors in
typography or photography. Specifications are subject to change without notice.
©2018 Crestron Electronics, Inc.
Page 3
HD-DA4-4KZ-E 1:4 HDMI
®
Distribution Amplifier w/4K60 4:4:4 & HDR Support
8.09 in
206 mm
7.49 in
191 mm
4.67 in
119 mm
0.87 in
22 mm
4.07 in
103 mm
4.57 in
116 mm
6.89 in
175 mm
Crestron Electronics, Inc. 15 Volvo Drive | Rockleigh, NJ 07647
Tel: 800.237.2041 / 201.767.3400 | Fax: 201.767.1903
www.crestron.com
All brand names, product names and trademarks are the property of their respective owners.
Specifications subject to change without notice. Revised 09/26/18
©2018 Crestron Electronics, Inc.
Loading...